How do tree stand parameters affect young Scots pine biomass? – Allometric equations and biomass conversion and expansion factors

2018 ◽  
Vol 409 ◽  
pp. 74-83 ◽  
Author(s):  
Andrzej M. Jagodziński ◽  
Marcin K. Dyderski ◽  
Kamil Gęsikiewicz ◽  
Paweł Horodecki ◽  
Agnieszka Cysewska ◽  
...  
Wood Research ◽  
2021 ◽  
Vol 66 (3) ◽  
pp. 449-462
Author(s):  
Tomasz Jelonek ◽  
Witold Pazdrowski ◽  
Joanna Kopaczyk ◽  
Magdalena Arasimowicz-Jelonek ◽  
Arkadiusz Tomczak

The research focused in determining the lignification indicator of fresh needled springs and the mass of fresh needles in reference to the lignin content in tracheid walls of peripheral area of the stem (MFT/LC and MFN/LC) of Scots pine differentiated as far as its biosocial position within the community expressed by Kraft’s classification. The material for the analysis came from mature pine stands growing on North European Plain, on the territory of Poland. Chemical and structural analyses of wood encompassed the area of mature sapwood, i.e. thickness of the last 10 annual rings located at 1.3 m (DBH). It seems that the noticed differences values of both indicators (MFT/LC and MFN/LC) in pines belonging to the first three Kraft’s biological classes are connected with physiological, physical and structural conditionings of water transport with minerals in xylem and are closely connected with competition for sunlight, water, nutrients and living space.


Forests ◽  
2021 ◽  
Vol 12 (7) ◽  
pp. 867
Author(s):  
Paulina Dukat ◽  
Klaudia Ziemblińska ◽  
Janusz Olejnik ◽  
Stanisław Małek ◽  
Timo Vesala ◽  
...  

The accurate estimation of an increase in forest stand biomass has remained a challenge. Traditionally, in situ measurements are done by inventorying a number of trees and their biometric parameters such as diameter at the breast height (DBH) and height; sometimes these are complemented by carbon (C) content studies. Here we present the estimation of net primary productivity (NPP) over a two years period (2019–2020) at a 25-year-old Scots pine stand. Research was based on allometric equations made by direct biomass analysis (tree extraction) and carbon content estimations in individual components of sampled trees, combined with a series of stem diameter increments recorded by a network of band dendrometers. Site-specific allometric equations were obtained using two different approaches: using the whole tree biomass vs DBH (M1), and total dry biomass-derived as a sum of the results from individual tree components’ biomass vs DBH (M2). Moreover, equations for similar forest stands from the literature were used for comparison. Gross primary productivity (GPP) estimated from the eddy-covariance measurements allowed the calculation of carbon use efficiency (CUE = NPP/GPP). The two investigated years differed in terms of the sum and patterns of precipitation distribution, with a moderately dry year of 2019 that followed the extremely dry 2018, and the relatively average year of 2020. As expected, a higher increase in biomass was recorded in 2020 compared to 2019, as determined by both allometric equations based on in situ and literature data. For the former approach, annual NPP estimates reached ca. 2.0–2.1 t C ha−1 in 2019 and 2.6–2.7 t C ha−1 in 2020 depending on the “in situ equations” (M1-M2) used, while literature-derived equations for the same site resulted in NPP values ca. 20–30% lower. CUE was higher in 2020, which resulted from a higher NPP total than in 2019, with lower summer and spring GPP in 2020. However, the CUE values were lower than those reported in the literature for comparable temperate forest stands. A thorough analysis of the low CUE value would require a full interpretation of interrelated physiological responses to extreme conditions.


2017 ◽  
Vol 25 ◽  
pp. 51 ◽  
Author(s):  
Miłosz Deptuła ◽  
Andrzej Nienartowicz ◽  
Marta Iwicka ◽  
Anna Filbrandt-Czaja

2008 ◽  
Vol 255 (7) ◽  
pp. 2678-2687 ◽  
Author(s):  
Mieczyslaw Turski ◽  
Cezary Beker ◽  
Katarzyna Kazmierczak ◽  
Tomasz Najgrakowski

2014 ◽  
Vol 75 (1) ◽  
pp. 77-87 ◽  
Author(s):  
Ewa Stefańska-Krzaczek ◽  
Paweł Pech

Abstract The utility of phytocenotic indices in the diagnosis and classification of forest sites might be limited because of vegetation degeneration in managed forests. However, even in secondary communities it may be possible to determine indicator species, although these may differ from typical and well known plant indicators. The aim of this work was to assess the vegetation diversity of Scots pine stands in representative forest site types along a moisture and fertility gradient. In total 120 sample plots from Turawa forests were included in the study. These plots represented young (21-40 years) and old (> 80 years) Scots-pine-dominated stands. The forest sites were categorised according to Polish site classification. Four site categories were studied: Bśw (very nutrient-poor and mesic sites), BMśw (nutrient-poor and mesic sites), BMw (nutrient-poor and moist sites), LMw (quite nutrient-rich and moist sites). The species composition of the forest patches studied hardly differed among forest site types. Almost all of the vegetation in site Bśw was different from both moist site types (BMw and LMw). Sites Bśw and LMw had the exclusive species determined as site indicators. Moreover, young stands had their own site type indicator species which differed from old stands. Numerical classification showed that only two plant communities were widespread: Leucobryo- Pinetum in Bśw and BMśw, and the community of Pinus sylvestris and Molinia caerulea in BMśw, BMw, LMw. In secondary communities typical indicator species may not be useful, but it is possible to determinate species that are locally unique to forest site type. Despite the convergence in the composition of the plant community resulting from tree stand unification, plant communities have the capacity for a more diverse composition. Tree stand conversion can increase phytocenotic diversity


Sign in / Sign up

Export Citation Format

Share Document