Bubble characteristics of air–water bubbly jets in crossflow

2013 ◽  
Vol 55 ◽  
pp. 156-171 ◽  
Author(s):  
Wenming Zhang ◽  
David Z. Zhu
Author(s):  
O. M. Katz

The swelling of irradiated UO2 has been attributed to the migration and agglomeration of fission gas bubbles in a thermal gradient. High temperatures and thermal gradients obtained by electron beam heating simulate reactor behavior and lead to the postulation of swelling mechanisms. Although electron microscopy studies have been reported on UO2, two experimental procedures have limited application of the results: irradiation was achieved either with a stream of inert gas ions without fission or at depletions less than 2 x 1020 fissions/cm3 (∼3/4 at % burnup). This study was not limited either of these conditions and reports on the bubble characteristics observed by transmission and fractographic electron microscopy in high density (96% theoretical) UO2 irradiated between 3.5 and 31.3 x 1020 fissions/cm3 at temperatures below l600°F. Preliminary results from replicas of the as-polished and etched surfaces of these samples were published.


Author(s):  
Ahmad Dousti ◽  
Hamed Gharedaghi ◽  
Pedram Hanafizadeh ◽  
Mehdi Ashjaee

1991 ◽  
Vol 31 (9) ◽  
pp. 952-959 ◽  
Author(s):  
Manabu Iguchi ◽  
Kentarou Nozawa ◽  
Zen-ichiro Morita

1985 ◽  
Vol 15 (4) ◽  
pp. 581-590 ◽  
Author(s):  
A. Papachristodoulou ◽  
F. R. Foulkes ◽  
J. W. Smith

Water ◽  
2018 ◽  
Vol 10 (9) ◽  
pp. 1129
Author(s):  
Ruidi Bai ◽  
Chang Liu ◽  
Bingyang Feng ◽  
Shanjun Liu ◽  
Faxing Zhang

Chute aerators introduce a large air discharge through air supply ducts to prevent cavitation erosion on spillways. There is not much information on the microcosmic air bubble characteristics near the chute bottom. This study was focused on examining the bottom air-water flow properties by performing a series of model tests that eliminated the upper aeration and illustrated the potential for bubble variation processes on the chute bottom. In comparison with the strong air detrainment in the impact zone, the bottom air bubble frequency decreased slightly. Observations showed that range of probability of the bubble chord length tended to decrease sharply in the impact zone and by a lesser extent in the equilibrium zone. A distinct mechanism to control the bubble size distribution, depending on bubble diameter, was proposed. For bubbles larger than about 1–2 mm, the bubble size distribution followed a—5/3 power-law scaling with diameter. Using the relationship between the local dissipation rate and bubble size, the bottom dissipation rate was found to increase along the chute bottom, and the corresponding Hinze scale showed a good agreement with the observations.


2016 ◽  
Vol 87 ◽  
pp. 156-166 ◽  
Author(s):  
Ruidi Bai ◽  
Faxing Zhang ◽  
Shanjun Liu ◽  
Wei Wang

2016 ◽  
Vol 155 ◽  
pp. 504-523 ◽  
Author(s):  
P. Maximiano Raimundo ◽  
A. Cartellier ◽  
D. Beneventi ◽  
A. Forret ◽  
F. Augier

1987 ◽  
Vol 114 ◽  
Author(s):  
Paul F. Gutmann

There are numerous chemical agents to achieve the specified air entrainment system. Generally, these are organic chemicals which are broadly classified as soaps and detergents. One of the best known chemical agents of this type is known in the art as Vinsol resin, manufactured by Hercules, Inc., which is a wood resin salt and is the standard against which other air-entraining agents are tested under ASTM C-233.


Sign in / Sign up

Export Citation Format

Share Document