Local Nusselt number enhancement during gas–liquid Taylor bubble flow in a square mini-channel: An experimental study

2013 ◽  
Vol 66 ◽  
pp. 8-18 ◽  
Author(s):  
Abhik Majumder ◽  
Balkrishna Mehta ◽  
Sameer Khandekar
Author(s):  
Ketan Atulkumar Ganatra ◽  
Dushyant Singh

Abstract The experimental study for air slot jet impingement cooling from the heated cylinder is carried out. The heated cylinder is placed on a flat plate. The flat plate has an effective dimension as plate length (P) from heat transfer point of view. The heating of the cylindrical surface is done by providing a constant heat flux. The various parameters which affect the heat transfer from the cylinder are ReD, h/S, S/D, and P/D. The range of the parameters considered are ReD = 10,000–25,000, h/S = 4–12, S/D = 0.072–0.108, and P/D = 0–2. The effect of various parameters on heat transfer distribution (stagnation and local Nusselt number) from the cylinder is investigated. The local Nusselt number has a maximum value at θ = 0 deg and then it decreases upto θ = 180 deg. This trend is observed for all the parametric variations. The stagnation Nusselt number (Nustag) and local Nusselt number increases with the change of parameters as increase in ReD and S/D and decrease in h/S. However, Nustag remains independent with the change in P/D. The correlation for stagnation and mean Nusselt number is developed using regression analysis as a function of ReD, h/S, S/D, and P/D. The maximum error associated with the correlated value of Nustag and Num as compared with the experimental data is observed as ±13% and ±25%.


2020 ◽  
Vol 45 (4) ◽  
pp. 373-383
Author(s):  
Nepal Chandra Roy ◽  
Sadia Siddiqa

AbstractA mathematical model for mixed convection flow of a nanofluid along a vertical wavy surface has been studied. Numerical results reveal the effects of the volume fraction of nanoparticles, the axial distribution, the Richardson number, and the amplitude/wavelength ratio on the heat transfer of Al2O3-water nanofluid. By increasing the volume fraction of nanoparticles, the local Nusselt number and the thermal boundary layer increases significantly. In case of \mathrm{Ri}=1.0, the inclusion of 2 % and 5 % nanoparticles in the pure fluid augments the local Nusselt number, measured at the axial position 6.0, by 6.6 % and 16.3 % for a flat plate and by 5.9 % and 14.5 %, and 5.4 % and 13.3 % for the wavy surfaces with an amplitude/wavelength ratio of 0.1 and 0.2, respectively. However, when the Richardson number is increased, the local Nusselt number is found to increase but the thermal boundary layer decreases. For small values of the amplitude/wavelength ratio, the two harmonics pattern of the energy field cannot be detected by the local Nusselt number curve, however the isotherms clearly demonstrate this characteristic. The pressure leads to the first harmonic, and the buoyancy, diffusion, and inertia forces produce the second harmonic.


2020 ◽  
Vol 105 (2) ◽  
pp. 471-495
Author(s):  
E. M. A. Frederix ◽  
E. M. J. Komen ◽  
I. Tiselj ◽  
B. Mikuž
Keyword(s):  

1983 ◽  
Vol 105 (3) ◽  
pp. 433-439 ◽  
Author(s):  
N. Seki ◽  
S. Fukusako ◽  
A. Yamaguchi

Experimental measurements are presented for free convective heat transfer across a parallelogrammic enclosure with the various tilt angles of parallel upper and lower walls insulated. The experiments covered a range of Rayleigh numbers between 3.4 × 104 and 8.6 × 107, and Prandtl numbers between 0.70 and 480. Those also covered the tilt angles of the parallel insulated walls with respect to the horizontal, φ, of 0, ±25, ±45, ±60, and ±70 deg under an aspect ratio of H/W = 1.44. The fluids used were air, transformer oil, and water. It was found that the heat transfer coefficients for φ = −70 deg were decreased to be about 1/18 times those for φ = 0 deg. Experimental results are given as plots of the Nusselt number versus the Rayleigh number. A correlation equation is given for the Nusselt number, Nu, as a function of φ, Pr, and Ra.


2021 ◽  
Vol 4 (8(112)) ◽  
pp. 16-22
Author(s):  
Mahmoud A. Mashkour

The heat convection phenomenon has been investigated numerically (mathematically) for a channel located horizontally and partially heated at a uniform heat flux with forced and free heat convection. The investigated horizontal channel with a fluid inlet and the enclosure was exposed to the heat source from the bottom while the channel upper side was kept with a constant temperature equal to fluid outlet temperature. Transient, laminar, incompressible and mixed convective flow is assumed within the channel. Therefore, the flow field is estimated using Navier Stokes equations, which involves the Boussinesq approximation. While the temperature field is calculated using the standard energy model, where, Re, Pr, Ri are Reynolds number, Prandtl number, and Richardson number, respectively. Reynolds number (Re) was changed during the test from 1 to 50 (1, 10, 25, and 50) for each case study, Richardson (Ri) number was changed during the test from 1 to 25 (1, 5, 10, 15, 20, and, 25). The average Nusselt number (Nuav) increases exponentially with the Reynold number for each Richardson number and the local Nusselt number (NuI) rises in the heating point. Then gradually stabilized until reaching the endpoint of the channel while the local Nusselt number increases with a decrease in the Reynolds number over there. In addition, the streamlines and isotherms patterns in case of the very low value of the Reynolds number indicate very low convective heat transfer with all values of Richardson number. Furthermore, near the heat source, the fluid flow rate rise increases the convection heat transfer that clarified the Nusselt number behavior with Reynolds number indicating that maximum Nu No. are 6, 12, 27 and 31 for Re No. 1, 10, 25 and 50, respectively


2014 ◽  
Vol 11 (1) ◽  
pp. 115-128 ◽  
Author(s):  
Sébastien Vintrou ◽  
Daniel Bougeard ◽  
Serge Russeil ◽  
Rabia Nacereddine

2021 ◽  
Vol 10 (2) ◽  
pp. 259-269
Author(s):  
M. Veera Krishna ◽  
N. Ameer Ahamad ◽  
Ali J. Chamkha

In the current investigative paper, the impact of Hall current on an unsteady magnetohydrodynamic liberated convection revolving flow of a nanofluid restricted with a uniform absorbent medium over an oscillatory moving vertical smooth plate with convective as well as diffusive frontier conditions has been reviewed. The non-dimensionalized governing differential equations by the appropriate frontier conditions are resolved by the perturbations technique. The impacts of the physical constants on the flow as well as the heat transfer features are displayed graphically and analyzed for Cu as well as Al2O3 nanoparticles. For the engineering industry, the skin friction coefficient, local Nusselt number, along with the Sherwood’s number are examined numerically in detail.


Sign in / Sign up

Export Citation Format

Share Document