Impact of porous complicated fin and sinusoidal-heated wall on thermogravitational convection of different nanofluids in a square domain

AbstractDirect numerical simulation (DNS) of an impinging jet flow with a nozzle-to-plate distance of two jet diameters and a Reynolds number of 10 000 is carried out at high spatial resolution using high-order numerical methods. The flow configuration is designed to enable the development of a fully turbulent regime with the appearance of a well-marked secondary maximum in the radial distribution of the mean heat transfer. The velocity and temperature statistics are validated with documented experiments. The DNS database is then analysed focusing on the role of unsteady processes to explain the spatial distribution of the heat transfer coefficient at the wall. A phenomenological scenario is proposed on the basis of instantaneous flow visualisations in order to explain the non-monotonic radial evolution of the Nusselt number in the stagnation region. This scenario is then assessed by analysing the wall temperature and the wall shear stress distributions and also through the use of conditional averaging of velocity and temperature fields. On one hand, the heat transfer is primarily driven by the large-scale toroidal primary and secondary vortices emitted periodically. On the other hand, these vortices are subjected to azimuthal distortions associated with the production of radially elongated structures at small scale. These distortions are responsible for the appearance of very high heat transfer zones organised as cold fluid spots on the heated wall. These cold spots are shaped by the radial structures through a filament propagation of the heat transfer. The analysis of probability density functions shows that these strong events are highly intermittent in time and space while contributing essentially to the secondary peak observed in the radial evolution of the Nusselt number.

Download Full-text

High-Resolution Measurements at Nucleate Boiling of Pure FC-84 and FC-3284 and Its Binary Mixtures

Journal of Heat Transfer ◽

10.1115/1.3220143 ◽

2009 ◽

Vol 131 (12) ◽

Cited By ~ 36

Author(s):

Enno Wagner ◽

Peter Stephan

Keyword(s):

Binary Mixtures ◽

High Speed ◽

Contact Region ◽

Infrared Camera ◽

Nucleate Boiling ◽

Heated Wall ◽

Rear Side ◽

Phase Contact ◽

Pure Fluids ◽

Three Phase

In a special boiling cell, vapor bubbles are generated at single nucleation sites on top of a 20μm thick stainless steel heating foil. An infrared camera captures the rear side of the heating foil for analyzing the temperature distribution. The bubble shape is recorded through side windows with a high-speed camera. Global measurements were conducted, with the pure fluids FC-84 and FC-3284 and with its binary mixtures of 0.25, 0.5, and 0.75mole fraction. The heat transfer coefficient (HTC) in a binary mixture is less than the HTC in either of the single component fluid alone. Applying the correlation of Schlünder showed good agreement with the measurements (1982, “Über den Wärmeübergang bei der Blasenverdampfung von Gemischen,” Verfahrenstechnik, 16(9), pp. 692–698). Furthermore, local measurements were arranged with high lateral and temporal resolution for single bubble events. The wall heat flux was computed and analyzed, especially at the three-phase-contact line between liquid, vapor, and heated wall. The bubble volume and the vapor production rate were also investigated. For pure fluids, up to 50–60% of the latent heat flows through the three-phase-contact region. For mixtures, this ratio is clearly reduced and is about 35%.

Download Full-text