Investigation of chlorinated phenols sorption mechanisms on different layers of the Danube alluvial sediment

2020 ◽  
Vol 98 ◽  
pp. 134-142
Author(s):  
Tamara Apostolović ◽  
Jelena Tričković ◽  
Marijana Kragulj Isakovski ◽  
Branislav Jović ◽  
Snežana Maletić ◽  
...  
2021 ◽  
Author(s):  
Tamara Apostolović ◽  
Jelena Tričković ◽  
Marijana Kragulj Isakovski ◽  
Snežana Maletić ◽  
Tijana Zeremski ◽  
...  

<p>Amendment of alluvial sediments with carbon rich materials such as biochars can be an effective method for controlling the penetration of hazardous substances from river water into drinking water sources during river bank filtration (RBF). In this work, the transport of chlorinated phenols (CPs) during simulated RBF through Danube alluvial sediment with and without biochar amendment was studied. In order to assess the effect of the biochar amendment on CPs retention in the alluvial sediment, column experiments were carried out, with the addition of biocide to exclude the influence of biodegradation. Four CPs that differ in polarity were used as sorbates: 4-chlorophenol (4-CP), 2,4-dichlorophenol (2,4-DCP), 2,4,6-trichlorophenol (2,4,6-TCP) and pentachlorophenol (PCP). For the column packing, Danube alluvial sediment was used, characterized as a mesoporous sandy material with low organic carbon content (1.57 %) and small specific surface area (1.65 m<sup>2</sup>/g). In contrast, the material used as the amendment in the column experiment is a biochar with high organic carbon content (89.8 %) and large specific surface area (341 m<sup>2</sup>/g). The breakthrough curves obtained for the alluvial sediment column without biochar amendment showed poor retention of all investigated CPs. Retardation factors (<em>R</em><sub>d</sub>) for 4-CP, 2,4-DCP and 2,4,6-TCP were 1.65, 1.98 and 1.48, respectively, whereas for PCP, <em>R</em><sub>d</sub> was somewhat higher (4.28) most likely due to the fact that it’s nonpolar nature greatly affects its distribution between the solid and aqueous phase. The addition of biochar into the alluvial sediment at a 0.5 % mass ratio significantly increased the retardation of all investigated CPs. The obtained <em>R</em><sub>d</sub> values for 4-CP, 2,4-DCP, 2,4,6-TCP and PCP were 102, 83, 78 and 92, respectively. The general increase in retardation of all investigated CPs can be explained by the increase of organic carbon content in the alluvial sediment by the addition of biochar, which is known to be the main fraction for organic components sorption in sediments and soils. In addition, the enhanced affinity of the alluvial sediment to retain the more polar CPs after biochar amendment indicates that sorption is carried out not only through nonpolar interactions, but also by electrostatic interactions between the CPs and functional groups on the surface of the biochar. The results show that biochar amendment of alluvial sediments could have a great potential for organic contaminants retention in the RBF zone, thus decreasing the risk of groundwater and drinking water sources contamination.</p><p><strong>Acknowledgement: </strong>The authors acknowledge financial support of the Ministry of Education, Science and Technological Development of the Republic of Serbia (Grant No. ‪451-03-68/‪2020-14/ 200125). The authors want to express their gratitude to Basna d.o.o. Čačak for providing the biochar.</p>


1991 ◽  
Vol 24 (3-4) ◽  
pp. 427-430 ◽  
Author(s):  
J. Nevalainen ◽  
P.-R. Rantala ◽  
J. Junna ◽  
R. Lammi

Conventional and oxygen bleaching effluents from hardwood kraft pulp mills were treated in laboratory-scale activated sludge processes. The main interest was the fate of organochlorine compounds in the activated sludge process. In the treatment of conventional bleaching wastewaters the BOD7-reduction was 80-91 % and in oxygen bleaching wastewaters 86-93 %. The respective CODCr removals were about 40 % and about 50 %. The AOX reductions were on average 22 % and 40 % in the treatment of conventional and oxygen bleaching effluents, respectively. The reductions of chlorinated phenols, guajacols and catecols were usually more than 50 % in both reactors. Very little accumulation of AOX into the sludge was observed. The stripping of AOX from aeration unit was insignificant.


1988 ◽  
Vol 20 (1) ◽  
pp. 65-72 ◽  
Author(s):  
Rurik Skogman ◽  
Reino Lammi

The requirements imposed on the Finnish forest products industry by the water authorities have focused on the reduction of BOD and suspended solids in the wastewaters. The industry has tried to comply with these requirements, first through internal measures such as process changes and closed systems. When these have not been sufficient, external treatment has been resorted to. The Wilh. Schauman Company in Jakobstad has chosen activated sludge with extended aeration from among the available methods for treating effluent. The plant has operated since the beginning of 1986 with extremely good results. In addition to the reduction of BOD and suspended solids, there has been a marked decrease of chlorinated phenols. Chlorinated substances with higher molecular weight are also removed during the process.


Geology ◽  
2000 ◽  
Vol 28 (9) ◽  
pp. 803-806 ◽  
Author(s):  
Clifford S. Riebe ◽  
James W. Kirchner ◽  
Darryl E. Granger ◽  
Robert C. Finkel

Organics ◽  
2021 ◽  
Vol 2 (3) ◽  
pp. 142-160
Author(s):  
Keith Smith ◽  
Gamal A. El-Hiti

para-Selective processes for the chlorination of phenols using sulphuryl chloride in the presence of various sulphur-containing catalysts have been successfully developed. Several chlorinated phenols, especially those derived by para-chlorination of phenol, ortho-cresol, meta-cresol, and meta-xylenol, are of significant commercial importance, but chlorination reactions of such phenols are not always as regioselective as would be desirable. We, therefore, undertook the challenge of developing suitable catalysts that might promote greater regioselectivity under conditions that might still be applicable for the commercial manufacture of products on a large scale. In this review, we chart our progress in this endeavour from early studies involving inorganic solids as potential catalysts, through the use of simple dialkyl sulphides, which were effective but unsuitable for commercial application, and through a variety of other types of sulphur compounds, to the eventual identification of particular poly(alkylene sulphide)s as very useful catalysts. When used in conjunction with a Lewis acid such as aluminium or ferric chloride as an activator, and with sulphuryl chloride as the reagent, quantitative yields of chlorophenols can be obtained with very high regioselectivity in the presence of tiny amounts of the polymeric sulphides, usually in solvent-free conditions (unless the phenol starting material is solid at temperatures even above about 50 °C). Notably, poly(alkylene sulphide)s containing longer spacer groups are particularly para-selective in the chlorination of m-cresol and m-xylenol, while, ones with shorter spacers are particularly para-selective in the chlorination of phenol, 2-chlorophenol, and o-cresol. Such chlorination processes result in some of the highest para/ortho ratios reported for the chlorination of phenols.


Sign in / Sign up

Export Citation Format

Share Document