A novel approach for the simultaneous recycling of Ti-bearing blast furnace slag, diamond wire saw Si powder, and Al alloy scrap for preparing TiSi2 and Al-Si alloys

2021 ◽  
pp. 127905
Author(s):  
Yakun Zhang ◽  
Yun Lei ◽  
Wenhui Ma ◽  
Chaoran Zhai ◽  
Zhe Shi ◽  
...  
Materials ◽  
2021 ◽  
Vol 14 (18) ◽  
pp. 5198
Author(s):  
Khaled Ibrahim Azarroug Ehwailat ◽  
Mohd Ashraf Mohamad Ismail ◽  
Ali Muftah Abdussalam Ezreig

Gypseous soil is one type of expansive soil that contains a sufficient amount of sulphate. Cement and lime are the most common methods of stabilizing expansive soil, but the problem is that lime-treated gypseous soil normally fails in terms of durability due to the formation of ettringite, a highly deleterious compound. Moisture ingress causes a significant swelling of ettringite crystals, thereby causing considerable damage to structures and pavements. This study investigated the suitability of various materials (nano–Mg oxide (M), metakaolin (MK), and ground granulated blast-furnace slag (GGBS)) for the stabilization of gypseous soil. The results showed soil samples treated with 20% M-MK, M-GGBS, and M-GGBS-MK to exhibit lower swelling rates (<0.01% change in volume) compared to those treated with 10% and 20% of lime after 90 days of curing. However, soil samples stabilized with 10% and 20% binder of [(M-MK), (M-GGBS), and (M-GGBS-MK)] exhibited higher strengths after 90 days of soaking (ranging from 0.96–12.8 MPa) compared to those stabilized with 10% and 20% lime. From the morphology studies, the SEM and EDX analysis evidenced no formation of ettringite in the samples stabilized with M-MK-, M-GGBS-, and M-GGBS-MK. These results demonstrate the suitability of M-MK, M-GGBS, and M-GGBS-MK as effective agents for the stabilization of gypseous soil.


2019 ◽  
Vol 798 ◽  
pp. 333-341 ◽  
Author(s):  
Yun Lei ◽  
Chao Wang ◽  
Wenhui Ma ◽  
Jijun Wu ◽  
Kuixian Wei ◽  
...  

2009 ◽  
Vol 69-70 ◽  
pp. 328-332 ◽  
Author(s):  
C.Y. Yao ◽  
Wei Peng ◽  
Ming Huan Wang ◽  
F.Q. Liu

Diamond wire saw is the leading technology for use in cutting hard brittle material. Its smaller kerf and faster cutting time make it replacing the conventional slurry technology for those materials. Turned over the traditional router, this paper presents a novel approach that replaces the typical metallic core with a nonmetallic core, for manufacturing of ultraviolet curing resin fixed-abrasive diamond wire saw (DWS). The experiments show that the diamond wire saw made by this manufacturing method can obtain a good performance as well as taking many other advantages.


CONCREEP 10 ◽  
2015 ◽  
Author(s):  
Tomiyuki Kaneko ◽  
Keiichi Imamoto ◽  
Chizuru Kiyohara ◽  
Akio Tanaka ◽  
Ayuko Ishikawa

Sign in / Sign up

Export Citation Format

Share Document