A new model for predicting soil thermal conductivity from matric potential

2020 ◽  
Vol 589 ◽  
pp. 125167 ◽  
Author(s):  
Hailong He ◽  
Miles Dyck ◽  
Jialong Lv
2016 ◽  
Vol 17 (2) ◽  
pp. 601-613 ◽  
Author(s):  
Bing Tong ◽  
Zhiqiu Gao ◽  
Robert Horton ◽  
Yubin Li ◽  
Linlin Wang

Abstract Soil thermal conductivity λ is a vital parameter for soil temperature and soil heat flux forecasting in hydrological models. In this study, an empirical model is developed to relate λ only to soil volumetric water content θ and soil porosity θs. Measured λ values for eight soils are used to establish the empirical model, and data from four other soils are used to evaluate the model. The new model is also evaluated by its performance in the Simple Biosphere Model 2 (SiB2). Results show that the root-mean-square errors (RMSEs; ranging from 0.097 to 0.266 W m−1 K−1) of the new model estimates of λ are lower than those (ranging from 0.416 to 1.006 W m−1 K−1) for an empirical model of similar complexity reported in the literature earlier. Further, with simple inputs and equations, the new model almost has the accuracy of other more complex models (RMSE of λ ranging from 0.040 to 0.354 W m−1 K−1) that require additional detailed soil information. The new model can be readily incorporated in large-scale models because of its simplicity as compared to the more complex models. The new model is tested for its effectiveness by incorporating it into SiB2. Compared to the original SiB2 λ model, the new λ model provides better estimates of surface effective radiative temperature and soil wetness. Owing to the newly presented empirical model’s requirement for simple, available inputs and its accuracy, its usage is recommended within large-scale models for applications where detailed information about soil composition is lacking.


2021 ◽  
Author(s):  
Yili Lu ◽  
Tusheng Ren ◽  
Sen Lu ◽  
Robert Horton

<p>Soil thermal conductivity (λ) is affected by the energy status of water and is closely related to soil matric potential (h). In this study, a soil water retention curve and a soil thermal conductivity curve were linked via the critical point that separated the adsorption water and capillary water regimes. Based on existing water retention curve and a thermal conductivity curve models, we derived a new implicit mathematical formulation of the λ-h relationship. The λ-h relationship was valid for the entire water content range at room temperature. The new model parameter values for adsorption, capillarity and soil thermal conduction were optimized, and a linear relationship between critical water content and maximum adsorption capacity was established by fitting the SWRC and STCC models to measurements from eight soils. Laboratory evaluations using λ and h measurements on a loam soil and a clay loam soil showed that the new model well described observed values with coefficients of determination greater than 0.97. The implicit model can quantify λ-h behaviors for various soil textures over the entire water content range.</p>


2020 ◽  
Vol 2020 ◽  
pp. 1-12
Author(s):  
Fu-Qing Cui ◽  
Wei Zhang ◽  
Zhi-Yun Liu ◽  
Wei Wang ◽  
Jian-bing Chen ◽  
...  

The comprehensive understanding of the variation law of soil thermal conductivity is the prerequisite of design and construction of engineering applications in permafrost regions. Compared with the unfrozen soil, the specimen preparation and experimental procedures of frozen soil thermal conductivity testing are more complex and challengeable. In this work, considering for essentially multiphase and porous structural characteristic information reflection of unfrozen soil thermal conductivity, prediction models of frozen soil thermal conductivity using nonlinear regression and Support Vector Regression (SVR) methods have been developed. Thermal conductivity of multiple types of soil samples which are sampled from the Qinghai-Tibet Engineering Corridor (QTEC) are tested by the transient plane source (TPS) method. Correlations of thermal conductivity between unfrozen and frozen soil has been analyzed and recognized. Based on the measurement data of unfrozen soil thermal conductivity, the prediction models of frozen soil thermal conductivity for 7 typical soils in the QTEC are proposed. To further facilitate engineering applications, the prediction models of two soil categories (coarse and fine-grained soil) have also been proposed. The results demonstrate that, compared with nonideal prediction accuracy of using water content and dry density as the fitting parameter, the ternary fitting model has a higher thermal conductivity prediction accuracy for 7 types of frozen soils (more than 98% of the soil specimens’ relative error are within 20%). The SVR model can further improve the frozen soil thermal conductivity prediction accuracy and more than 98% of the soil specimens’ relative error are within 15%. For coarse and fine-grained soil categories, the above two models still have reliable prediction accuracy and determine coefficient (R2) ranges from 0.8 to 0.91, which validates the applicability for small sample soils. This study provides feasible prediction models for frozen soil thermal conductivity and guidelines of the thermal design and freeze-thaw damage prevention for engineering structures in cold regions.


Soil Science ◽  
1994 ◽  
Vol 158 (5) ◽  
pp. 307-313 ◽  
Author(s):  
G. S. CAMPBELL ◽  
J. D. JUNGBAUER ◽  
W. R. BIDLAKE ◽  
R. D. HUNGERFORD

Energy ◽  
2012 ◽  
Vol 44 (1) ◽  
pp. 197-210 ◽  
Author(s):  
Matjaz Perpar ◽  
Zlatko Rek ◽  
Suvad Bajric ◽  
Iztok Zun

2010 ◽  
Vol 14 (1) ◽  
pp. 91-98 ◽  
Author(s):  
D. Jougnot ◽  
A. Revil

Abstract. The parameters used to describe the electrical conductivity of a porous material can be used to describe also its thermal conductivity. A new relationship is developed to connect the thermal conductivity of an unsaturated porous material to the thermal conductivity of the different phases of the composite, and two electrical parameters called the first and second Archie's exponents. A good agreement is obtained between the new model and thermal conductivity measurements performed using packs of glass beads and core samples of the Callovo-Oxfordian clay-rocks at different saturations of the water phase. We showed that the three model parameters optimised to fit the new model against experimental data (namely the thermal conductivity of the solid phase and the two Archie's exponents) are consistent with independent estimates. We also observed that the anisotropy of the effective thermal conductivity of the Callovo-Oxfordian clay-rock was mainly due to the anisotropy of the thermal conductivity of the solid phase.


Sign in / Sign up

Export Citation Format

Share Document