Modeling flow pattern transitions in electrical submersible pump under gassy flow conditions

2019 ◽  
Vol 180 ◽  
pp. 471-484 ◽  
Author(s):  
Jianjun Zhu ◽  
Jiecheng Zhang ◽  
Guangqiang Cao ◽  
Qingqi Zhao ◽  
Jianlin Peng ◽  
...  
2014 ◽  
Vol 136 (4) ◽  
Author(s):  
Rinaldo Antonio de Melo Vieira ◽  
Mauricio Gargaglione Prado

The effect of free gas on electrical submersible pump (ESP) performance is well known. At a constant rotational speed and constant liquid flow rate, a small amount of gas causes a mild head reduction when compared to the single phase liquid head. However, at higher gas rates, a drastic reduction in the head is observed. This critical condition, known as the surging point, is a combination of liquid and gas flow rates that cause a maximum in the head performance curve. The first derivative of the head with respect to the liquid flow rate changes sign as the liquid flow rate crosses the surging point. In several works on ESP two-phase flow performance, production conditions to the left of the surging region are described or reported as unstable operational conditions. This paper reviews basic concepts on stability of dynamical systems and shows through simulation that ESP oscillatory behavior may result from two-phase flow conditions. A specific drift flux computation code was developed to simulate the dynamic behavior of ESP wells producing without packers.


Author(s):  
Jianjun Zhu ◽  
Ruben Cuamatzi-Melendez ◽  
Jose Alberto Martinez Farfan ◽  
Haiwen Zhu ◽  
Jiecheng Zhang ◽  
...  

This paper presents a numerical study of flow pattern recognition inside the rotating impeller of electrical submersible pump (ESP) using the transient multiphase CFD simulations. Based on the previous experimental facility for visualizing flow patterns in an ESP, the entire flow domain is constructed. The high-quality structured mesh comprising hexahedral grids is generated using multi-block technique in ANSYS ICEM. Mesh independence is confirmed by comparing numerical results with catalog curves. For transient two-phase simulation, the realized RNG k-ε turbulence model with volume of fluid (VOF) and Eulerian multiphase models is successfully implemented in ANSYS Fluent solver. The sliding mesh technique is applied to interfaces where rotating and stationary parts interact. By incorporating the same boundary conditions as experimental study, two different cases with fixed liquid flow rates and varying gas flow rates are selected to conduct CFD simulations. The comparison of numerical results against experimental visualizations shows that the two-fluid Eulerian model is superior to VOF model in simulating gas/liquid flow in a rotating ESP. The single-phase simulation results match catalog curves of ESP, which validates the numerical methodology. For gas-liquid simulations, the simulated flow patterns with Eulerian model agree well with visualization experiments. The distinct flow patterns prevailing inside the rotating ESP impeller are captured by CFD simulations, including dispersed bubble flow, bubbly flow, and intermittent flow.


2018 ◽  
Author(s):  
Jianjun Zhu ◽  
Zhihua Wang ◽  
Haiwen Zhu ◽  
Ruben Cuamatzi-Melendez ◽  
Jose Alberto Martinez-Farfan ◽  
...  

2019 ◽  
Vol 10 ◽  
pp. 82-86
Author(s):  
A.N. Ivanov ◽  
◽  
V.A. Bondarenko ◽  
M.M. Veliev ◽  
E.V. Kudin ◽  
...  

2021 ◽  
Vol 229 ◽  
pp. 108975
Author(s):  
R.H.R. Gutiérrez ◽  
U.A. Monteiro ◽  
C.O. Mendonça

2021 ◽  
Author(s):  
Mohd Hafizi Ariffin ◽  
Muhammad Idraki M Khalil ◽  
Abdullah M Razali ◽  
M Iman Mostaffa

Abstract Most of the oil fields in Sarawak has already producing more than 30 years. When the fields are this old, the team is most certainly facing a lot of problems with aging equipment and facilities. Furthermore, the initial stage of platform installation was not designed to accommodate a large space for an artificial lift system. Most of these fields were designed with gas lift compressors, but because of the space limitation, the platforms can only accommodate a limited gas lift compressor capacity due to space constraints. Furthermore, in recent years, some of the fields just started with their secondary recovery i.e. water, gas injection where the fluid gradient became heavier due to GOR drop or water cut increases. With these limitations and issues, the team needs to be creative in order to prolong the fields’ life with various artificial lift. In order to push the limits, the team begins to improve gas lift distribution among gas lifted wells in the field. This is the cheapest option. Network model recommends the best distribution for each gas lifted wells. Gas lifted wells performance highly dependent on fluid weight, compressor pressure, and reservoir pressure. The change of these parameters will impact the production of these wells. Rigorous and prudent data acquisitions are important to predict performance. Some fields are equipped with pressure downhole gauges, wellhead pressure transmitters, and compressor pressure transmitters. The data collected is continuous and good enough to be used for analysis. Instead of depending on compressor capacity, a high-pressure gas well is a good option for gas lift supply. The issues are to find gas well with enough pressure and sustainability. Usually, this was done by sacrificing several barrels of oil to extract the gas. Electrical Submersible Pump (ESP) is a more expensive option compared to a gas lift method. The reason is most of these fields are not designed to accommodate ESP electricity and space requirements. Some equipment needs to be improved before ESP installation. Because of this, the team were considering new technology such as Thru Tubing Electrical Submersible Pump (TTESP) for a cheaper option. With the study and implementation as per above, the fields able to prolong its production until the end of Production Sharing Contract (PSC). This proactive approach has maintained the fields’ production with The paper seeks to present on the challenges, root cause analysis and the lessons learned from the subsequent improvement activities. The lessons learned will be applicable to oil fields with similar situations to further improve the fields’ production.


Sign in / Sign up

Export Citation Format

Share Document