scholarly journals Critical Current Test of Liquid Hydrogen Cooled HTC Superconductors under External Magnetic Field

2016 ◽  
Vol 81 ◽  
pp. 158-161 ◽  
Author(s):  
Yasuyuki Shirai ◽  
Masahiro Shiotsu ◽  
Hideki Tatsumoto ◽  
Hiroaki Kobayashi ◽  
Yoshihiro Naruo ◽  
...  
2001 ◽  
Vol 354 (1-4) ◽  
pp. 237-241 ◽  
Author(s):  
N. Shaked ◽  
A. Friedman ◽  
M. Sinvani ◽  
I.A. Al-Omari ◽  
Y. Wolfus ◽  
...  

2021 ◽  
Vol 63 (8) ◽  
pp. 1035
Author(s):  
П.И. Безотосный ◽  
К.А. Дмитриева

The results of calculating the temperature dependences of the critical current density and critical magnetic field of thin inhomogeneous superconducting films are presented. Comparison of the results obtained for inhomogeneous films with the results of calculations for homogeneous ones showed that in both cases, the decrease in the critical magnetic field occurs according to the root law, and the critical current density changes according to a power law with a degree of 3/2 when approaching the critical temperature. Quantitatively, the critical current density for inhomogeneous films in the absence of an external magnetic field is lower than for homogeneous ones. In turn, the critical magnetic field of inhomogeneous films is much larger than the critical field of homogeneous films.


2022 ◽  
Vol 92 (3) ◽  
pp. 414
Author(s):  
М.А. Зеликман

The analysis of possible current distributions when passing current through a periodically modulated long Josephson contact located in an external magnetic field is carried out. An approach based on the analysis of continuous configuration modification proceeding in the direction of Gibbs potential reduction is used for the calculation. The case when the pinning parameter is less than the critical value is considered. It is shown that at any value of the external magnetic field, there is a critical value of the transport current, when exceeded, the situation ceases to be stationary, as a result of which energy passes into radiation and heat, i.e. currents cease to be persistent. The value of the critical current is determined by the value of the magnetic field at which the vortices begin to fill the entire length of the contact. With an increase in the external magnetic field, the critical value of the current decreases.


1987 ◽  
Vol 99 ◽  
Author(s):  
S. Matsuda ◽  
M. Okada ◽  
T. Morimoto ◽  
T. Matsumoto ◽  
K. Ihara

ABSTRACTA tape-shaped wire with Y1 Ba2Cu3, O7-δ, core and Ag sheath was fabricated by a drawing-rolling method. The critical current density of the wire with 0.1 mm thickness and 6 mm width was in 2 the range of 2000 A/cm at 77 K in the absence of external magnetic field. Presence of 20 m Tesla magnetic field reduced the J value to 1/100.


2012 ◽  
Vol 512-515 ◽  
pp. 11-16
Author(s):  
Yuan Dong Peng ◽  
Qing Lin Xia ◽  
Qian Ming Huang ◽  
Li Ya Li ◽  
Hong Zhong Wang ◽  
...  

Superconductor samples Mg(B1-2x(SiC)x)2 (x=0, 5%, 10%) are synthesized from nano SiC, Mg and amorphous boron powders by microwave direct synthesis in a short time. Powder X-ray diffraction (XRD) analysis indicates that the phases of the synthesis sample are MgB2 (major phase) and a small amount of MgO and Mg2Si. The main peaks of MgB2, (100), (101), (002) and (110) are shift to the higher diffraction angle position and the width of half height of the diffraction plane is broaden for the SiC doping Mg(B1-2x(SiC)x)2, which show that the B positions of MgB2 are partly substituted and the grains of MgB2 are fine. Scanning electron microscope (SEM) observation shows that the MgB2 grain size is very small and the sample is tightness (compact). The onset superconducting transition temperature of the Mg(B1-2x(SiC)x)2 (x=0, 5%, 10%) samples measured by magnetization measurement are about 37.6 K, 37.0 K, 36.8 K respectively. The critical current density Jc are calculated according to the Bean model from the magnetization hysteresis loop of the slab Mg(B1-2x(SiC)x)2 (x=0, 5%, 10%) samples. The critical current density Jc of nano SiC doping Mg(B1-2x(SiC)x)2 samples are greatly enhanced. In higher external magnetic field, the Jc of 10% SiC doped sample is the highest; in lower external magnetic field, the Jc of 5% SiC doped sample is the highest; while in the whole external magnetic field, the Jc of undoped sample is the lowest.


2019 ◽  
Vol 61 (2) ◽  
pp. 234
Author(s):  
П.И. Безотосный ◽  
С.Ю. Гаврилкин ◽  
К.А. Дмитриева ◽  
А.Н. Лыков ◽  
А.Ю. Цветков

AbstractA method for calculating the critical current of an inhomogeneous superconducting film (plate) in different external magnetic fields has been proposed. The superconducting properties are changed by varying the coherence length and London penetration depth over the thickness. The coherence length is maximum at the center of the plate and decreases upon approaching its boundaries and the London depth, on the contrary, is minimum at the center of the plate and increases toward its boundaries. Using the proposed approach, the magnetic field dependences of the critical current on the external magnetic field for the cases of nonuniform and uniform distributions of the superconducting properties over the film thickness have been calculated and compared. It has been established that at the nonuniform distribution of the superconducting properties the critical current of the plate is higher than at the uniform distribution at the same external magnetic fields. This is due to the fact that the order parameter is redistributed over the inhomogeneous plate thickness in such a way that the superconducting state becomes more stable against the current and magnetic field. It has been shown that the vortex-free Meissner state in inhomogeneous films is maintained at higher fields than in homogeneous films. The greater the film nonuniformity, the higher the stability of the Meissner state against an external magnetic field.


Sign in / Sign up

Export Citation Format

Share Document