Effects of surface treatments on high mobility ITiO coated glass substrates for dye sensitized solar cells and their tandem solar cell applications

2010 ◽  
Vol 94 (4) ◽  
pp. 691-696 ◽  
Author(s):  
J.W. Bowers ◽  
H.M. Upadhyaya ◽  
T. Nakada ◽  
A.N. Tiwari
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Dye Sensitized Solar Cells ◽  
High Mobility ◽  
Surface Treatments ◽  
Tandem Solar Cell ◽  
Coated Glass ◽  
Glass Substrates ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

scholarly journals Comparative Study of Characteristics of Dye Sensitized Solar Cells Fabricated Using Substrates Coated with Fluorine Doped Tin Oxide and Titanium

2020 ◽  
Vol 15 (3) ◽  
pp. 216-221
Author(s):  
Arbin Maharjan
Keyword(s):  
Solar Cells ◽  
Tin Oxide ◽  
Fill Factor ◽  
Short Circuit ◽  
Dye Sensitized Solar Cells ◽  
Coated Glass ◽  
Cell Efficiency ◽  
Glass Substrates ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

Dye-sensitized solar cells (DSSCs) have attracted many researchers because it has potential to supplement and compete with other solar cell technologies like Silicon (Si) and Cadmium Telluride (CdTe). The fabrication of DSSCs requires a photo electrode and a counter electrode of transparent and conducting nature. The commercial DSSCs uses electrodes of fluorine doped tin oxide (FTO) glass substrates. These electrodes are expensive and hence, possible alternative materials that are cheaper and that would provide better performance under similar environmental condition should be explored. In this paper, titanium (Ti)-coated glass substrates were prepared and then used to prepare electrodes for fabricating DSSCs. Similarly, DSSCs were fabricated using electrodes of conventional FTO-coated glass substrates. Performance characteristics like cell efficiency (η%), fill-factor (FF), short circuit current density (JSC) and open circuit voltage (VOC) of both fabricated DSSCs were obtained using their respective J-V characteristic curves under similar illumination of 100 mW/cm2 and with comparable transmittance under the visible transmission spectrum of 300-850 nm. The obtained results showed that DSSCs prepared using electrodes of FTO coated glass substrates have 1.557 times better cell efficiency and 2.172 times better fill factor than that of DSSCs fabricated using electrodes of Ti-coated glass substrates.

Donor-π-acceptor, triazine-linked porphyrin dyads as sensitizers for dye-sensitized solar cells

2015 ◽  
Vol 19 (01-03) ◽  
pp. 175-191 ◽  
Author(s):  
Ganesh D. Sharma ◽  
Galateia E. Zervaki ◽  
Kalliopi Ladomenou ◽  
Emmanuel N. Koukaras ◽  
Panagiotis P. Angaridis ◽  
...  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Carboxylic Acid ◽  
Power Conversion Efficiency ◽  
Conversion Efficiency ◽  
Power Conversion ◽  
Dye Sensitized Solar Cells ◽  
Orbital Energy ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

Two porphyrin dyads with the donor-π-acceptor molecular architecture, namely ( ZnP )-[triazine-gly]-( H 2 PCOOH ) and ( ZnP )-[triazine-Npip]-( H 2 PCOOH ), which consist of a zinc-metalated porphyrin unit and a free-base porphyrin unit covalently linked at their peripheries to a central triazine group, substituted either by a glycine in the former or a N-piperidine group in the latter, have been synthesized via consecutive amination substitution reactions of cyanuric chloride. The UV-vis absorption spectra and cyclic-voltammetry measurements of the two dyads, as well as theoretical calculations based on Density Functional Theory, suggest that they have suitable frontier orbital energy levels for use as sensitizers in dye-sensitized solar cells. Dye-sensitized solar cells based on ( ZnP )-[triazine-gly]-( H 2 PCOOH ) and ( ZnP )-[triazine-Npip]-( H 2 PCOOH ) have been fabricated, and they were found to exhibit power conversion efficiency values of 5.44 and 4.15%, respectively. Photovoltaic measurements (J–V curves) and incident photon to current conversion efficiency spectra of the two solar cells suggest that the higher power conversion efficiency value of the former solar cell is a result of its enhanced short circuit current, open circuit voltage, and fill factor values, as well as higher dye loading. This is ascribed to the existence of two carboxylic acid anchoring groups in ( ZnP )-[triazine-gly]-( H 2 PCOOH ), compared to one carboxylic acid group in ( ZnP )-[triazine-Npip]-( H 2 PCOOH ), which leads to a more effective binding onto the TiO 2 photoanode. Electrochemical impedance spectra show evidence that the ( ZnP )-[triazine-gly]-( H 2 PCOOH ) based solar cell exhibits a longer electron lifetime and more effective suppression of charge recombination reactions between the injected electrons and electrolyte.

Polyaniline/Graphene/Multi-Walled Carbon Nanotube Composites as Counter Electrode for Dye-Sensitized Solar Cells

2014 ◽  
Vol 1667 ◽  
Author(s):  
Yen-Chen Shih ◽  
Hsiao-Li Lin ◽  
King-Fu Lin
Keyword(s):  
Solar Cells ◽  
Composite Film ◽  
Counter Electrode ◽  
Dye Sensitized Solar Cells ◽  
Weight Ratio ◽  
Glass Substrates ◽  
Dye Sensitized ◽  
Multi Walled Carbon Nanotube ◽  
Electrochemical Deposition Method ◽  
Sensitized Solar Cells

ABSTRACTTo provide a counter electrode with lower-cost and simple production method for dye-sensitized solar cells (DSSCs), we developed polyaniline/graphene nanoplatelet/multi-walled carbon nanotube (PANi/GNP/MWCNT) composite films growing on glass substrates by using chemical/electrochemical deposition method and on fluorine-doped tin oxide (FTO)/glass substrates by using electrochemical deposition method respectively. A proper weight ratio of PANi/GNP/MWCNT (1/0.0030/0.0045) composite film depositing on FTO substrate as counter electrode with sheet resistance of 8.25±0.13 Ω/sq for DSSCs yielded power conversion efficiency (PCE) up to 7.45±0.08%, which has potential to replace the conventional Pt cell (7.62±0.07%). In addition, we also fabricated the DSSCs composed of a proper weight ratio of PANi/GNP/MWCNTs (1/0.0045/0.0060) composite film depositing on glass substrate as counter electrode. The sheet resistance of resulting composite film was 59.34±12.34 Ω/sq. These solar cells with FTO-free counter electrode exhibited a PCE of 2.90±0.09%.

Kinetics of dye regeneration in liquid electrolyte unveils efficiency of 10.5% in dye-sensitized solar cells

2018 ◽  
Vol 6 (42) ◽  
pp. 11444-11456 ◽  
Author(s):  
Jonnadula Venkata Suman Krishna ◽  
Narra Vamsi Krishna ◽  
Towhid H. Chowdhury ◽  
Suryaprakash Singh ◽  
Idriss Bedja ◽  
...  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Power Conversion ◽  
Dye Sensitized Solar Cells ◽  
Liquid Electrolyte ◽  
Dye Sensitized Solar Cell ◽  
Dye Sensitized ◽  
Dye Regeneration ◽  
Sensitized Solar Cells ◽  
Kinetics Of

We have designed and synthesised four novel porphyrin sensitizers for dye-sensitized solar cell applications and shown power conversion efficiency of 10.5%.

Correlating cobalt redox couples to photovoltage in the dye-sensitized solar cell

2018 ◽  
Vol 47 (34) ◽  
pp. 11942-11952 ◽  
Author(s):  
Kitty Y. Chen ◽  
Phil A. Schauer ◽  
Brian O. Patrick ◽  
Curtis P. Berlinguette
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Redox Potential ◽  
Linear Correlation ◽  
Dye Sensitized Solar Cells ◽  
Dye Sensitized Solar Cell ◽  
Redox Mediators ◽  
Dye Sensitized ◽  
Redox Couples ◽  
Sensitized Solar Cells

Two sets of structurally analogous Co(iii/ii)-based redox mediators were incorporated in the dye-sensitized solar cells and a linear correlation was demonstrated between redox potential and photovoltage.

scholarly journals Unsymmetrical Heptamethine Dyes for NIR Dye-Sensitized Solar Cells

2014 ◽  
Vol 2014 ◽  
pp. 1-10 ◽  
Author(s):  
Thomas Geiger ◽  
Iuliia Schoger ◽  
Daniel Rentsch ◽  
Anna Christina Véron ◽  
Frédéric Oswald ◽  
...  
Keyword(s):  
Molecular Structure ◽  
Solar Cells ◽  
Solar Cell ◽  
Near Infrared ◽  
Photophysical Properties ◽  
Dye Sensitized Solar Cells ◽  
Dye Sensitized ◽  
Sensitized Solar Cells ◽  
Nir Dye ◽  
Proof Of Principle

Seven unsymmetrical heptamethine dyes with carboxylic acid functionality were synthesized and characterized. These near-infrared dyes exhibit outstanding photophysical properties depending on their heterocyclic moieties and molecular structure. As proof of principle, the dyes were used as photosensitizers in dye-sensitized solar cells. Using the most promising dye, an overall conversion efficiency of 1.22% and an almost colorless solar cell were achieved.

A2 and A2B2 Benzoporphyrins as sensitizers for dye-sensitized solar cells

2019 ◽  
Vol 23 (04n05) ◽  
pp. 599-610 ◽  
Author(s):  
Siddhartha Kumar ◽  
Whitney Webre ◽  
Jacob Schaffner ◽  
Sheikh M. S. Islam ◽  
Francis D’Souza ◽  
...  
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Dye Sensitized Solar Cells ◽  
Acid Group ◽  
Dye Sensitized ◽  
Dye Loading ◽  
Two Factors ◽  
Homo And Lumo ◽  
Anchoring Group ◽  
Sensitized Solar Cells

The first example of A2B2 tetrabenzoporphyrin (KW-4) was synthesized, characterized and evaluated as a sensitizer for dye-sensitized solar cells. UV-vis and fluorescence spectroscopy revealed red-shifted and broadened absorption spectra of A2B2 tetrabenzoporphyrin as compared with its A2 dibenzo- and A2B2 dibenzoporphyrin analogues, which is a desired feature of dyes for dye-sensitized solar cells. DFT calculations also indicate favorable electron density distribution on the HOMO and LUMO of KW-4. However, the power conversion efficiency of the solar cell based on tetrabenzoporphyrin KW-4 displayed inferior performance than that of the solar cell based on A2 dibenzoporphyrin KW-2. The lower performance of the KW-4 cell was ascribed to two factors: the low lying LUMO energy level leading to less efficient electron injection and the “flat geometry” of the dye on TiO2surface facilitating charge recombination and decreasing dye loading. The investigation of anchoring group effect suggests that the acrylic acid group is a better anchoring group than pentadienyl carboxylic acid.

Dye-sensitized solar cells containing mesoporous TiO2spheres as photoanodes and methyl sulfate anion based biionic liquid electrolytes

2015 ◽  
Vol 3 (12) ◽  
pp. 6383-6391 ◽  
Author(s):  
Jia-De Peng ◽  
Chuan-Pei Lee ◽  
D. Velayutham ◽  
V. Suryanarayanan ◽  
Kuo-Chuan Ho
Keyword(s):  
Solar Cells ◽  
Solar Cell ◽  
Solid State ◽  
Dye Sensitized Solar Cells ◽  
Dye Sensitized Solar Cell ◽  
Methyl Sulfate ◽  
Sulfate Anion ◽  
Dye Sensitized ◽  
Liquid Electrolytes ◽  
Sensitized Solar Cells

A quasi-solid state dye-sensitized solar cell with the photoanode film of mesoporous TiO2spheres exhibited an efficiency of 6.18% and unfailing stability for 1200 h at 50 °C.

Sign in / Sign up

Export Citation Format

Share Document