Combined heat and mass transfer in a uniformly heated vertical tube with water film cooling

1998 ◽  
Vol 19 (5) ◽  
pp. 401-417 ◽  
Author(s):  
S. He ◽  
P. An ◽  
J. Li ◽  
J.D. Jackson
1986 ◽  
Vol 108 (1) ◽  
pp. 70-75 ◽  
Author(s):  
R. L. Webb ◽  
H. Perez-Blanco

This paper studies enhancement of heat and mass transfer between a countercurrent, gravity-drained water film and air flowing in a vertical tube. The enhancement technique employed is spaced, transverse wires placed in the air boundary layer, near the air-water interface. Heat transfer correlations for turbulent, single-phase heat transfer in pipes having wall-attached spaced ribs are used to select the preferred wire diameter, and to predict the gas phase heat and mass transfer coefficients. Tests were run with two different radial placements of the rib roughness: (1) at the free surface of the liquid film, and (2) the base of the roughness displaced 0.51 mm into the air flow. The authors hypothesize that the best heat/mass transfer and friction performance will be obtained with the roughness at the surface of the water film. Experiments conducted with both roughness placements show that the authors’ hypothesis is correct. The measured heat/mass transfer enhancement agreed very closely with the predicted values. A unique feature of the enhancement concept is that it does not require surface wetting of the enhancement device to provide enhancement.


1974 ◽  
Vol 17 (109) ◽  
pp. 928-935 ◽  
Author(s):  
Heishichiro TAKAHAMA ◽  
Hideomi FUJITA ◽  
Tadahiko KODAMA ◽  
Masahiro KURIBAYASHI ◽  
Toshiharu AISO

2011 ◽  
Vol 19 (02) ◽  
pp. 121-129 ◽  
Author(s):  
PASUPATHY BALAMURUGAN ◽  
ANNAMALAI MANI

A model has been developed based on Colburn–Drew type formulation to analyze a vertical tube in tube stainless steel generator with forced convective boiling. Desorption of refrigerant vapor from refrigerant–absorbent solution takes place in the inner tube of the generator, when hot water through the annulus is used as heating medium. Simultaneous heat and mass transfer phenomena of desorption are described mathematically using the mass and energy balances, considering the heat and mass transfer resistances in liquid as well as vapor phases. Model equations are solved simultaneously by means of initial value problem solvers using explicit Runge–Kutta method with 4th order accuracy. A computer code has been developed in MATLAB to obtain the results. A parametric analysis has also been performed to study the effect of various parameters on the performance of the generator.


1986 ◽  
Vol 50 (5) ◽  
pp. 549-553
Author(s):  
A. P. Nesenchuk ◽  
A. M. Gabri�l' ◽  
E. N. Antonishina ◽  
V. A. Sednin ◽  
A. A. Sklyar ◽  
...  

Author(s):  
Jiqiang Su ◽  
Yuxiang Wu ◽  
Shuliang Huang ◽  
Huiqiang Xu ◽  
Yanmin Zhou

During the steam condensation, the presence of non-condensable gases is an important issue affecting the efficiency of the whole thermodynamic process. For this reason, many researchers investigated it by theoretical or experimental methods. A heat and mass transfer analogy model on steam condensation in presence of air over the vertical external surface based on the diffusion layer model is modified in the present paper. Based on previous authors’ experience, the suction effect at the gas-liquid interface and other analogy drawbacks are identified and overcome by supplementing it with more detailed analysis as well as targeted experiments. The experimental data obtained for condensation, outside vertical tube with an external diameter of 38 mm, of air/steam and helium/air/steam mixture, have been used to verify the present heat and mass transfer analogy formulation. By comparing against different available experimental data and previous formulations, the heat and mass transfer analogy formulation is demonstrated to be a accurate enough theoretical approximation. The deviation between predicted values of the new model and experiment results of this paper is less than 15% which has relative higher precision.


Sign in / Sign up

Export Citation Format

Share Document