Up-conversion luminescence of neodymium oxalate nanoparticles/TiO2/organically modified silane composite thin films derived at low temperature

2002 ◽  
Vol 19 (2) ◽  
pp. 307-312 ◽  
Author(s):  
Wenxiu Que ◽  
C.H Kam

1991 ◽  
Vol 196 (2) ◽  
pp. 201-213 ◽  
Author(s):  
P. Bruschi ◽  
A. Nannini ◽  
F. Massara


2011 ◽  
Vol 214 ◽  
pp. 444-449
Author(s):  
Natthapong Muangtrairat ◽  
Vishnu Rachpech ◽  
Lek Sikong

This paper describes the photoactive and antibacterial properties of TiO2, Fe3+/TiO2 and N/TiO2 thin films on 304 stainless steel substrate that prepared by a sol-gel and dip coating methods. Anatase phase crystalline together with an amorphous phase was formed after refluxed at 100W for 2h using a domestic microwave oven followed by oven heating in low temperature range 100-250°C for 1 h. The adhesion between thin film and stainless steel substrate is strong and films thickness observed by SEM were about 700~1000 nm. FT-IR spectra of as-prepared TiO2 powders reveal hydroxyl radical on TiO2 surfaces, leading to promotion of photocatalytic reaction of the films. Photocatalytic activity was determined by means of degradation of methylene blue solution under UV irradiation and antibacterial efficiency was evaluated by inactivation of E.coli. The photocatalytic reaction rate can be expressed as an exponential equation. TiO2 and TiO2 composite thin films exhibited high photoactive and antibacterial properties under UV irradiation comparing to control. E.coli was killed about 80% and 95% during treatment with UV for 1 and 3 h, respectively.



2016 ◽  
Vol 40 (6) ◽  
pp. 5177-5184 ◽  
Author(s):  
Muhammad Adil Mansoor ◽  
Muhammad Mazhar ◽  
Mehdi Ebadi ◽  
Huang Nay Ming ◽  
Mohd Asri Mat Teridi ◽  
...  

Low-temperature (475 °C) fabrication of CeO2–MnO composite thin films having a band gap of 2.5 eV by AACVD.



2001 ◽  
Vol 73 (2) ◽  
pp. 209-213 ◽  
Author(s):  
W. Que ◽  
Y. Zhou ◽  
Y.L. Lam ◽  
K. Pita ◽  
Y.C. Chan ◽  
...  


2000 ◽  
Vol 358 (1-2) ◽  
pp. 16-21 ◽  
Author(s):  
Wenxiu Que ◽  
Y Zhou ◽  
Y.L Lam ◽  
Y.C Chan ◽  
C.H Kam




Author(s):  
M. A. Kirk ◽  
M. C. Baker ◽  
B. J. Kestel ◽  
H. W. Weber

It is well known that a number of compound superconductors with the A15 structure undergo a martensite transformation when cooled to the superconducting state. Nb3Sn is one of those compounds that transforms, at least partially, from a cubic to tetragonal structure near 43 K. To our knowledge this transformation in Nb3Sn has not been studied by TEM. In fact, the only low temperature TEM study of an A15 material, V3Si, was performed by Goringe and Valdre over 20 years ago. They found the martensite structure in some foil areas at temperatures between 11 and 29 K, accompanied by faults that consisted of coherent twin boundaries on {110} planes. In pursuing our studies of irradiation defects in superconductors, we are the first to observe by TEM a similar martensite structure in Nb3Sn.Samples of Nb3Sn suitable for TEM studies have been produced by both a liquid solute diffusion reaction and by sputter deposition of thin films.



2009 ◽  
Vol 94 (22) ◽  
pp. 222110 ◽  
Author(s):  
S. S. N. Bharadwaja ◽  
C. Venkatasubramanian ◽  
N. Fieldhouse ◽  
S. Ashok ◽  
M. W. Horn ◽  
...  


2021 ◽  
Vol 26 ◽  
pp. 102050
Author(s):  
Mehdi Dehghani ◽  
Ershad Parvazian ◽  
Nastaran Alamgir Tehrani ◽  
Nima Taghavinia ◽  
Mahmoud Samadpour


Sign in / Sign up

Export Citation Format

Share Document