scholarly journals Non-equilibrium dynamics of dense gas under tight confinement

2016 ◽  
Vol 794 ◽  
pp. 252-266 ◽  
Author(s):  
Lei Wu ◽  
Haihu Liu ◽  
Jason M. Reese ◽  
Yonghao Zhang

The force-driven Poiseuille flow of dense gases between two parallel plates is investigated through the numerical solution of the generalized Enskog equation for two-dimensional hard discs. We focus on the competing effects of the mean free path ${\it\lambda}$, the channel width $L$ and the disc diameter ${\it\sigma}$. For elastic collisions between hard discs, the normalized mass flow rate in the hydrodynamic limit increases with $L/{\it\sigma}$ for a fixed Knudsen number (defined as $Kn={\it\lambda}/L$), but is always smaller than that predicted by the Boltzmann equation. Also, for a fixed $L/{\it\sigma}$, the mass flow rate in the hydrodynamic flow regime is not a monotonically decreasing function of $Kn$ but has a maximum when the solid fraction is approximately 0.3. Under ultra-tight confinement, the famous Knudsen minimum disappears, and the mass flow rate increases with $Kn$, and is larger than that predicted by the Boltzmann equation in the free-molecular flow regime; for a fixed $Kn$, the smaller $L/{\it\sigma}$ is, the larger the mass flow rate. In the transitional flow regime, however, the variation of the mass flow rate with $L/{\it\sigma}$ is not monotonic for a fixed $Kn$: the minimum mass flow rate occurs at $L/{\it\sigma}\approx 2{-}3$. For inelastic collisions, the energy dissipation between the hard discs always enhances the mass flow rate. Anomalous slip velocity is also found, which decreases with increasing Knudsen number. The mechanism for these exotic behaviours is analysed.

2014 ◽  
Vol 136 (8) ◽  
Author(s):  
Toshiyuki Doi

Plane thermal transpiration of a rarefied gas between two walls of Maxwell-type boundaries with different accommodation coefficients is studied based on the linearized Boltzmann equation for a hard-sphere molecular gas. The Boltzmann equation is solved numerically using a finite difference method, in which the collision integral is evaluated by the numerical kernel method. The detailed numerical data, including the mass and heat flow rates of the gas, are provided over a wide range of the Knudsen number and the entire range of the accommodation coefficients. Unlike in the plane Poiseuille flow, the dependence of the mass flow rate on the accommodation coefficients shows different characteristics depending on the Knudsen number. When the Knudsen number is relatively large, the mass flow rate of the gas increases monotonically with the decrease in either of the accommodation coefficients like in Poiseuille flow. When the Knudsen number is small, in contrast, the mass flow rate does not vary monotonically but exhibits a minimum with the decrease in either of the accommodation coefficients. The mechanism of this phenomenon is discussed based on the flow field of the gas.


2008 ◽  
Vol 131 (1) ◽  
Author(s):  
T. Ewart ◽  
J. L. Firpo ◽  
I. A. Graur ◽  
P. Perrier ◽  
J. G. Méolans

A direct simulation Monte Carlo method (DSMC) solver, adapted to the subsonic microflow, is developed under the object-conception language (C++). Some technical details critical in these DSMC computations are provided. The numerical simulations of gas flow in a microchannel are carried out using the developed DSMC solver. Streamwise velocity distributions in the slip flow regime are compared with the analytical solution based on the Navier–Stokes equations with the velocity slip boundary condition. Satisfactory agreements have been achieved. Furthermore, the domain of the validity of this continuum approach is discussed. Simulations are then extended to the transitional flow regime. Streamwise velocity distributions are also compared with the results of the numerical solutions of the linearized Boltzmann equation. We emphasize the influence of the accommodation coefficient on the velocity profiles and on the mass flow rate. The simulation results on the mass flow rate are compared with the experimental data, which allow us to validate the “experimental” technique of the determination of the accommodation coefficient.


Author(s):  
Timothe´e Ewart ◽  
Irina A. Graur ◽  
Jean-Luc Firpo ◽  
Alexey Polikarpov ◽  
Pierre Perrier ◽  
...  

A DSMC solver, adapted to the subsonic micro flow, is developed under the object-conception language (C++). Some technical details critical in these DSMC computations are provided. The numerical simulations of gas flow in micro channel are carried out using developed DSMC solver. Streamwise velocity distributions in the slip flow regime are compared with the analytical solution based on the Navier-Stokes equations with the velocity slip boundary condition. Satisfactory agreements have been achieved. Furthermore, the domain of the validity of this continuum approach is discussed. Simulations are then extended to transitional flow regime. Streamwise velocity distributions are also compared with the results of the numerical solutions of the linearized Boltzmann equation. We emphasize the influence of the accommodation coefficient on the velocity profiles and on the mass flow rate. The simulation results on the mass flow rate are compared with the experimental data, that allow us to validate the “experimental” technique of the determination of the accommodation coefficient.


Author(s):  
Timothe´e Ewart ◽  
Irina A. Graour ◽  
Pierre Perrier ◽  
J. Gilbert Me´olans

An experimental investigation in a single silica microtube in isothermal stationary flow for various gases is made from the hydrodynamic to the near free molecular regime to study the reflection/accommodation process at the wall. This kind of investigation requires, more than other Micro-Electro-Mechanical-Systems (MEMS) experiments, a powerful experimental platform to measure very small mass flow rate. A global analytic expression, based on the Navier-Stokes (NS) equations with second order boundary conditions, is used to yield the Tangential Momentum Accommodation Coefficient (TMAC) in 0.003–0.3 Knudsen number range. Otherwise, the experimental results of the mass flow rate is compared with theoretical values calculated from kinetic approaches using variable TMAC as fitting parameter over the 0.3–30 Knudsen number range. Finally, whatever the theoretical approach the TMAC values obtained from the different gas-surface pairs are rather close one to other, but the TMAC values seem decreasing when the molecular mass increases.


Author(s):  
Ernane Silva ◽  
Cesar J. Deschamps ◽  
Marcos Rojas-Cárdenas

The exchange of momentum and energy in gas flows through microchannels is significantly influenced by the gas-surface interaction. At this scale often the gas is rarefied and therefore non-equilibrium effects in the fluid flow can arise in a layer which extends for a distance equivalent to the mean free path from the walls. Typical examples of non-equilibrium phenomena for rarefied gas flows are slip at the wall, thermal transpiration and temperature jump at the wall. The aim of the present study is to experimentally investigate the non-equilibrium effects present in an isothermal pressure induced flow for a large range of rarefaction conditions. The isothermal slip at the wall is usually characterized by the tangential momentum accommodation coefficient (TMAC). This coefficient depends on the molecular nature of the gas and on the physical characteristics of the surface, such as material and roughness. In particular this paper explores the influence of the surface material on the TMAC through measurements of the mass flow rate in capillaries for the special case of nitrogen. Commercially available microtubes of three different metallic materials — stainless steel, copper, and brass — were considered in the analysis. Measurements were performed with a dynamic measurement technique based on the constant volume method and comprehend the transitional flow regime and most part of the slip regime. Theoretical results obtained from the solution of the Boltzmann equation via the BGK kinetic model, which is a simplified approximation for the collisional term, were compared to the experimental results.


1991 ◽  
Vol 113 (1) ◽  
pp. 108-115 ◽  
Author(s):  
S. H. Kim ◽  
N. K. Anand ◽  
L. S. Fletcher

Laminar free convective heat transfer in channels formed between series of vertical parallel plates with an embedded line heat source was studied numerically. These channels resemble cooling passages in electronic equipment. The effect of a repeated boundary condition and wall conduction on mass flow rate (M), maximum surface temperature (θh,max and θc,max), and average surface Nusselt number (Nuh and Nuc) is discussed. Calculations were made for Gr*=10 to 106, K=0.1, 1, 10, and 100, and t/B=0.1 and 0.3. The effect of a repeated boundary condition decreases the maximum hot surface temperature and increases the maximum cold surface temperature. The effect of a repeated boundary condition with wall conduction increases the mass flow rate. The maximum increase in mass flow rate due to wall conduction is found to be 155 percent. The maximum decrease in average hot surface Nusselt number due to wall conduction (t/B and K) occurs at Gr*=106 and is 18 percent. Channels subjected to a repeated boundary condition approach that of a symmetrically heated channel subjected to uniform wall temperature conditions at K≥100.


Author(s):  
M. Hadj Nacer ◽  
Pierre Perrier ◽  
Irina Graur

The mass flow rate through microchannels with rectangular cross section is measured for the wide Knudsen number range (0.0025–26.2) in isothermal steady conditions. The experimental technique called ‘Constant Volume Method’ is used for the measurements. This method consists of measuring the small pressure variations in the tanks upstream and downstream of the microchannel. The measurements of the mass flow rate are carried out for three gases (Helium, Nitrogen and Argon). The microchannel internal surfaces are covered with a thin layer of gold with mean roughness Ra = 0.87nm (RMS). The continuum approach (Navier-Stokes equations) with first order velocity slip boundary condition was used in the slip regime (Knudsen number varies from 0.0025 to 0.1) to obtain the experimental velocity slip and accommodation coefficients associated to the Maxwell kinetic boundary condition. In the transitional and near free molecular regimes the linearized kinetic BGK model was used to calculate numerically the mass flow rate. From the comparison of the numerical and measured values of the mass flow rate the accommodation coefficient was also deduced.


Author(s):  
Yongli Li ◽  
Christine Barrot ◽  
Lucien Baldas ◽  
Ste´phane Colin ◽  
Ju¨rgen J. Brandner ◽  
...  

A new setup was developed for gas mixing analysis in T-shaped microchannels. The principle of the flow rate measurement was based on the Constant Volume (CV) method [1]. The mass flow rate measurements of two gases N2 / CO2 mixing in a T mixer were carried out in the slip flow regime and followed by a simulation work for comparison. The mass flow rate has a magnitude of 10−8 or 10−7 kg/s and has good agreement with simulation for the lowest inlet over outlet pressures ratios and moderate agreement for the highest inlet over outlet pressures ratios.


Author(s):  
Dhruv Singh ◽  
Xiaohui Guo ◽  
Alina Alexeenko ◽  
Jayathi Y. Murthy ◽  
Timothy S. Fisher

A physically rigorous computational algorithm is developed and applied to calculate sub-continuum thermal transport in structures containing semiconductor-gas interfaces. The solution is based on a finite volume discretization of the Boltzmann equation for gas molecules (in the gas phase) and phonons (in the semiconductor). A partial equilibrium is assumed between gas molecules and phonons at the interface of the two media, and the degree of this equilibrium is determined by the accommodation coefficients of gas molecules and phonons on either side of the interface. Energy balance is imposed to obtain a value of the interface temperature. The problem of heat transfer between two parallel plates is investigated. A range of transport regimes is studied, varying from ballistic phonon transport and free molecular flow to continuum heat transfer in both gas and solid. In particular, the thermal interface resistance (or temperature slip) at a gas-solid interface is extracted in the mesoscopic regime where a solution of the Boltzmann equation is necessary. This modeling approach is expected to find applications in the study of heat conduction through microparticle beds, gas flows in microchannel heat sinks and in determining gas gap conductance in thermal interface materials.


2020 ◽  
Vol 20 (3) ◽  
pp. 869-877
Author(s):  
O.V. Zhilyaev ◽  
V.N. Kovalnogov

This work represents the decision of the problem of nonstationary one-dimensioned flow of fluid in a straight pipeline. It shows the method to generate non-stationary flow regime based on utilizing additional pipeline in which mechanical oscillations of fluid are being excited. Pressure difference along the length of oscillating fluid appears to be a measure for the density of the fluid and for its mass flow rate. The possibility of creating a new instrument for measuring the density and mass flow rate of a fluid based on results obtained is shown.


Sign in / Sign up

Export Citation Format

Share Document