Supersonic Turbulent Boundary Layers: Some Comparisons Between Experiment and a Simple Theory

1976 ◽  
Vol 27 (2) ◽  
pp. 87-98 ◽  
Author(s):  
J L Stollery
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Skin Friction ◽  
Boundary Layers ◽  
Turbulent Boundary Layers ◽  
Simple Theory ◽  
Axisymmetric Bodies ◽  
Explicit Expressions

SummaryComparisons are made between some measurements of skin friction and heat transfer over five axisymmetric bodies and the predictions of a simple theory. The development of the theory is outlined and explicit expressions obtained for all the gross turbulent boundary-layer characteristics (δ*,θ,H,Cf and St).

Investigation of Flat-Plate Hypersonic, Turbulent Boundary Layers With Heat Transfer

1961 ◽  
Vol 28 (3) ◽  
pp. 323-329 ◽  
Author(s):  
Eva M. Winkler
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Friction Coefficient ◽  
Mach Number ◽  
Flat Plate ◽  
Skin Friction ◽  
Boundary Layers ◽  
Skin Friction Coefficient ◽  
Turbulent Boundary Layers ◽  
Reynolds Analogy

Naturally turbulent boundary layers on a cooled flat plate have been investigated at several distances from the leading edge of the plate at a Mach number of 5.2 for three rates of steady-state heat transfer to the surface. Measurements of Pitot and static pressures and of total and wall temperatures made it possible to compute velocity profiles, static-temperature profiles, and boundary-layer parameters without resorting to assumptions. The data demonstrate that the Reynolds analogy between skin friction and heat transfer is valid for all conditions of the present experiments. With increasing rate of heat transfer to the surface, the skin-friction coefficient was found to decrease, a phenomenon opposite to that predicted by theories and empirical relations. On the basis of the present data and other published results of compressible and incompressible turbulent boundary-layer skin friction, a simple relation was devised which describes closely the variation of the skin-friction coefficient with Mach number, heat-transfer rate, and momentum-thickness Reynolds number.

Effects of sandpaper roughness and stream turbulence on the turbulent boundary layer

1999 ◽  
Vol 213 (5) ◽  
pp. 507-515 ◽  
Author(s):  
J. C. Gibbings ◽  
S. M. Al-Shukri
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Skin Friction ◽  
Boundary Layers ◽  
Pipe Flow ◽  
Shape Factor ◽  
Turbulent Boundary Layers ◽  
Experimental Measurements ◽  
Two Dimensional

This paper reports experimental measurements of two-dimensional turbulent boundary layers over sandpaper surfaces under turbulent streams to complement the Nikuradse experiments on pipe flow. The study included the recovery region downstream of the end of transition. Correlations are given for the thickness, the shape factor, the skin friction and the parameters of the velocity profile of the layer. Six further basic differences from the pipe flow are described to add to the five previously reported.

Prediction of Turbulent Boundary Layer Development in Conical Diffusers

1966 ◽  
Vol 8 (4) ◽  
pp. 426-436 ◽  
Author(s):  
A. D. Carmichael ◽  
G. N. Pustintsev
Keyword(s):  
Boundary Layer ◽  
Kinetic Energy ◽  
Turbulent Boundary Layer ◽  
Boundary Layers ◽  
Shape Factor ◽  
Turbulent Boundary Layers ◽  
Energy Deficit ◽  
Momentum Thickness ◽  
Boundary Layer Development ◽  
Layer Development

Methods of predicting the growth of turbulent boundary layers in conical diffusers using the kinetic-energy deficit equation were developed. Three different forms of auxiliary equations were used. Comparison between the measured and predicted results showed that there was fair agreement although there was a tendency to underestimate the predicted momentum thickness and over-estimate the predicted shape factor.

Recent Developments in Calculation Methods for Turbulent Boundary Layers With Pressure Gradients and Heat Transfer

1966 ◽  
Vol 33 (2) ◽  
pp. 429-437 ◽  
Author(s):  
J. C. Rotta
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Temperature Distribution ◽  
Velocity Profile ◽  
Boundary Layers ◽  
Turbulent Boundary Layers ◽  
Pressure Gradients ◽  
Calculation Methods ◽  
Recent Developments ◽  
Incompressible Boundary

A review is given of the recent development in turbulent boundary layers. At first, for the case of incompressible flow, the variation of the shape of velocity profile with the pressure gradient is discussed; also the temperature distribution and heat transfer in incompressible boundary layers are treated. Finally, problems of the turbulent boundary layer in compressible flow are considered.

Direct numerical simulation of complete transition to turbulence via oblique breakdown at Mach 3

2011 ◽  
Vol 674 ◽  
pp. 5-42 ◽  
Author(s):  
CHRISTIAN S. J. MAYER ◽  
DOMINIC A. VON TERZI ◽  
HERMANN F. FASEL
Keyword(s):  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Skin Friction ◽  
Boundary Layers ◽  
Wave Spectrum ◽  
Linear Stability Theory ◽  
Transition To Turbulence ◽  
Transitional Region ◽  
Mean Flow ◽  
Mach 3

A pair of oblique waves at low amplitudes is introduced in a supersonic flat-plate boundary layer at Mach 3. Its downstream development and the concomitant process of laminar to turbulent transition is then investigated numerically using linear-stability theory, parabolized stability equations and direct numerical simulations (DNS). In the present paper, the linear regime is studied first in great detail. The focus of the second part is the early and late nonlinear regimes. It is shown how the disturbance wave spectrum is filled up by nonlinear interactions and which flow structures arise and how these structures locally break down to small scales. Finally, the study answers the question whether a fully developed turbulent boundary layer can be reached by oblique breakdown. It is shown that the skin friction develops such as is typical of transitional and turbulent boundary layers. Initially, the skin friction coefficient increases in the streamwise direction in the transitional region and finally decays when the early turbulent state is reached. Downstream of the maximum in the skin friction, the flow loses its periodicity in time and possesses characteristic mean-flow and spectral properties of a turbulent boundary layer. The DNS data clearly demonstrate that oblique breakdown can lead to a fully developed turbulent boundary layer and therefore it is a relevant mechanism for transition in two-dimensional supersonic boundary layers.

Velocity Profiles of Turbulent Boundary Layers

1969 ◽  
Vol 73 (698) ◽  
pp. 143-147 ◽  
Author(s):  
M. K. Bull
Keyword(s):  
Experimental Data ◽  
Boundary Layer ◽  
Turbulent Boundary Layer ◽  
Velocity Profile ◽  
Boundary Layers ◽  
Experimental Work ◽  
Constant Pressure ◽  
Velocity Profiles ◽  
Turbulent Boundary Layers ◽  
Boundary Layer Equations

Although a numerical solution of the turbulent boundary-layer equations has been achieved by Mellor and Gibson for equilibrium layers, there are many occasions on which it is desirable to have closed-form expressions representing the velocity profile. Probably the best known and most widely used representation of both equilibrium and non-equilibrium layers is that of Coles. However, when velocity profiles are examined in detail it becomes apparent that considerable care is necessary in applying Coles's formulation, and it seems to be worthwhile to draw attention to some of the errors and inconsistencies which may arise if care is not exercised. This will be done mainly by the consideration of experimental data. In the work on constant pressure layers, emphasis tends to fall heavily on the author's own data previously reported in ref. 1, because the details of the measurements are readily available; other experimental work is introduced where the required values can be obtained easily from the published papers.

Sign in / Sign up

Export Citation Format

Share Document