scholarly journals Mode competition in modulated Taylor–Couette flow

2008 ◽  
Vol 601 ◽  
pp. 381-406 ◽  
Author(s):  
M. AVILA ◽  
M. J. BELISLE ◽  
J. M. LOPEZ ◽  
F. MARQUES ◽  
W. S. SARIC

The effects of harmonically oscillating the inner cylinder about a zero mean rotation in a Taylor–Couette flow are investigated experimentally and numerically. The resulting time-modulated circular Couette flow possesses a Z2 spatio-temporal symmetry which gives rise to two distinct modulated Taylor vortex flows. These flows are initiated at synchronous bifurcations, have the same spatial symmetries, but are characterized by different spatio-temporal symmetries and axial wavenumber. Mode competition between these two states has been investigated in the region where they bifurcate simultaneously. In the idealized numerical model, the two flows have been found to coexist and be stable in a narrow region of parameter space. However, in the physical experiment, neither state has been observed in the coexistence region. Instead, we observe noise-sustained flows with irregular time-dependent axial wavenumber. Movies are available with the online version of the paper.

2014 ◽  
Vol 748 ◽  
pp. 756-767 ◽  
Author(s):  
B. Martínez-Arias ◽  
J. Peixinho ◽  
O. Crumeyrolle ◽  
I. Mutabazi

AbstractTorque measurements in Taylor–Couette flow, with large radius ratio and large aspect ratio, over a range of velocities up to a Reynolds number of 24 000 are presented. Following a specific procedure, nine states with distinct numbers of vortices along the axis were found and the aspect ratios of the vortices were measured. The relationship between the speed and the torque for a given number of vortices is reported. In the turbulent Taylor vortex flow regime, at relatively high Reynolds number, a change in behaviour is observed corresponding to intersections of the torque–speed curves for different states. Before each intersection, the torque for a state with a larger number of vortices is higher. After each intersection, the torque for a state with a larger number of vortices is lower. The exponent, from the scaling laws of the torque, always depends on the aspect ratio of the vortices. When the Reynolds number is rescaled using the mean aspect ratio of the vortices, only a partial collapse of the exponent data is found.


2005 ◽  
Vol 540 (-1) ◽  
pp. 269 ◽  
Author(s):  
J. ABSHAGEN ◽  
J. M. LOPEZ ◽  
F. MARQUES ◽  
G. PFISTER

Author(s):  
Nariman Ashrafi

The effect of shear thinning on the stability of the Taylor-Couette flow (TCF) is explored for a Carreau-Bird fluid in the narrow-gap limit to simulate journal bearings in general. Also considered is the changing eccentricity to cover a wide range of applied situations such as bearings and even articulation of human joints. Here, a low-order dynamical system is obtained from the conservation of mass and momentum equations. In comparison with the Newtonian system, the present equations include additional nonlinear coupling in the velocity components through the viscosity. It is found that the critical Taylor number, corresponding to the loss of stability of the base (Couette) flow becomes lower s the shear-thinning effect increases. Similar to Newtonian fluids, there is an exchange of stability between the Couette and Taylor vortex flows. However, unlike the Newtonian model, the Taylor vortex cellular structure loses its stability in turn as the Taylor number reaches a critical value. At this point, A Hopf bifurcation emerges, which exists only for shear-thinning fluids. Variation of stresses in the narrow gap has been evaluated with significant applications in the non-Newtonian lubricant.


2021 ◽  
Vol 929 ◽  
Author(s):  
Tom Lacassagne ◽  
Theofilos Boulafentis ◽  
Neil Cagney ◽  
Stavroula Balabani

Particle suspensions in non-Newtonian liquid matrices are frequently encountered in nature and industrial applications. We here study the Taylor–Couette flow (TCF) of semidilute spherical particle suspensions (volume fraction $\leq 0.1$ ) in viscoelastic, constant-viscosity liquids (Boger fluids). We describe the influence of particle load on various flow transitions encountered in TCF of such fluids, and on the nature of these transitions. Particle addition is found to delay the onset of first- and second-order transitions, thus stabilising laminar flows. It also renders them hysteretic, suggesting an effect on the nature of bifurcations. The transition to elasto-inertial turbulence (EIT) is shown to be delayed by the presence of particles, and the features of EIT altered, with preserved spatio-temporal large scales. These results imply that particle loading and viscoelasticity, which are known to destabilise the flow when considered separately, can on the other hand compete with one another and ultimately stabilise the flow when considered together.


2019 ◽  
Vol 870 ◽  
pp. 901-940 ◽  
Author(s):  
Prashanth Ramesh ◽  
S. Bharadwaj ◽  
Meheboob Alam

Flow visualization and particle image velocimetry (PIV) measurements are used to unravel the pattern transition and velocity field in the Taylor–Couette flow (TCF) of neutrally buoyant non-Brownian spheres immersed in a Newtonian fluid. With increasing Reynolds number ($Re$) or the rotation rate of the inner cylinder, the bifurcation sequence in suspension TCF remains same as in its Newtonian counterpart (i.e. from the circular Couette flow (CCF) to stationary Taylor vortex flow (TVF) and then to travelling wavy Taylor vortices (WTV) with increasing $Re$) for small particle volume fractions ($\unicode[STIX]{x1D719}<0.05$). However, at $\unicode[STIX]{x1D719}\geqslant 0.05$, non-axisymmetric patterns such as (i) the spiral vortex flow (SVF) and (ii) two mixed or co-existing states of stationary (TVF, axisymmetric) and travelling (WTV or SVF, non-axisymmetric) waves, namely (iia) the ‘TVF$+$WTV’ and (iib) the ‘TVF$+$SVF’ states, are found, with the former as a primary bifurcation from CCF. While the SVF state appears both in the ramp-up and ramp-down experiments as in the work of Majji et al. (J. Fluid Mech., vol. 835, 2018, pp. 936–969), new co-existing patterns are found only during the ramp-up protocol. The secondary bifurcation TVF $\leftrightarrow$ WTV is found to be hysteretic or sub-critical for $\unicode[STIX]{x1D719}\geqslant 0.1$. In general, there is a reduction in the value of the critical Reynolds number, i.e. $Re_{c}(\unicode[STIX]{x1D719}\neq 0)<Re_{c}(\unicode[STIX]{x1D719}=0)$, for both primary and secondary transitions. The wave speeds of both travelling waves (WTV and SVF) are approximately half of the rotational velocity of the inner cylinder, with negligible dependence on $\unicode[STIX]{x1D719}$. The analysis of the radial–axial velocity field reveals that the Taylor vortices in a suspension are asymmetric and become increasingly anharmonic, with enhanced radial transport, with increasing particle loading. Instantaneous streamline patterns on the axial–radial plane confirm that the stationary Taylor vortices can indeed co-exist either with axially propagating spiral vortices or azimuthally propagating wavy Taylor vortices – their long-time stability is demonstrated. It is shown that the azimuthal velocity is considerably altered for $\unicode[STIX]{x1D719}\geqslant 0.05$, resembling shear-band type profiles, even in the CCF regime (i.e. at sub-critical Reynolds numbers) of suspension TCF; its possible role on the genesis of observed patterns as well as on the torque scaling is discussed.


2007 ◽  
Vol 587 ◽  
pp. 373-393 ◽  
Author(s):  
S. DONG

We investigate the dynamical and statistical features of turbulent Taylor–Couette flow (for a radius ratio 0.5) through three-dimensional direct numerical simulations (DNS) at Reynolds numbers ranging from 1000 to 8000. We show that in three-dimensional space the Görtler vortices are randomly distributed in banded regions on the wall, concentrating at the outflow boundaries of Taylor vortex cells, which spread over the entirecylinder surface with increasing Reynolds number. Görtler vortices cause streaky structures that form herringbone-like patterns near the wall. For the Reynolds numbers studied here, the average axial spacing of the streaks is approximately 100 viscous wall units, and the average tilting angle ranges from 16° to 20°. Simulationresults have been compared to the experimental data in the literature, and the flow dynamics and statistics are discussed in detail.


Author(s):  
Sang-Hyuk Lee ◽  
Hyoung-Bum Kim

Taylor-Couette flow has been studied extensively and lots of variables which affect the flow instability are being reported. The wall geometry effect of Taylor-Couette flow, however, has been less studied. In this study, we investigated the effect of axial slit of outer cylinder. This kind of configuration can be easily seen in rotating machinery. Particle image velocimetry method was used to measure the velocity fields in longitudinal and latitudinal planes. The index matching method was used to avoid light refraction. The velocity fields between the slit and plain model which has the smooth wall were compared. From the experiments, both models have the same flow mode below Re = 143. The transition from circular Couette flow to plain Taylor vortex flow began at Re = 103, and the next transition to wavy vortex flow occurred at 124. The effect of slit wall appeared when the Reynolds number is larger than Re = 143. Above this Reynolds number, there was no stable mode and plain and wavy Taylor vortex flow randomly appeared.


1998 ◽  
Vol 120 (1) ◽  
pp. 65-71 ◽  
Author(s):  
R. Kedia ◽  
M. L. Hunt ◽  
T. Colonius

Numerical simulations have been performed to study the effects of the gravitational and the centrifugal potentials on the stability of heated, incompressible Taylor-Couette flow. The flow is confined between two differentially heated, concentric cylinders, and the inner cylinder is allowed to rotate. The Navier-Stokes equations and the coupled energy equation are solved using a spectral method. To validate the code, comparisons are made with existing linear stability analysis and with experiments. The code is used to calculate the local and average heat transfer coefficients for a fixed Reynolds number (Re = 100) and a range of Grashof numbers. The investigation is primarily restricted to radius ratios 0.5 and 0.7 for fluids with Prandtl number of about 0.7. The variation of the local coefficients of heat transfer on the cylinder surface is investigated, and maps showing different stable states of the flow are presented. Results are also presented in terms of the equivalent conductivity, and show that heat transfer decreases with Grashof number in axisymmetric Taylor vortex flow regime, and increases with Grashof number after the flow becomes nonaxisymmetric.


2020 ◽  
Vol 897 ◽  
Author(s):  
R. Ayats ◽  
K. Deguchi ◽  
F. Mellibovsky ◽  
A. Meseguer


Sign in / Sign up

Export Citation Format

Share Document