scholarly journals Experiments with laser-irradiated cylindrical targets

1991 ◽  
Vol 9 (3) ◽  
pp. 725-747 ◽  
Author(s):  
C. Stöckl ◽  
G. D. Tsakiris
Keyword(s):  
Light Propagation ◽  
Energy Transport ◽  
Laser Light ◽  
Laser Energy ◽  
Axial Direction ◽  
Radiative Energy ◽  
Capillary Length ◽  
Inner Diameter ◽  
Laser Heated ◽  
Good Agreement

Results of novel experiments with laser-heated capillary targets are presented. In these experiments the interior of gold capillaries having a 200- or 700-μm inner diameter and a 2–12-mm length was axially irradiated by injection of the laser energy through one of the end openings. A frequency-doubled Nd:glass laser (λ = 0.53 μm) was employed, delivering 8-J energy in 3 ns. The experiments showed no significant backreflection of laser light. Depending on the capillary diameter and length, most of the laser energy is either transmitted or absorbed inside the capillary. The transmission of laser light was measured as a function of capillary length and found to be in good agreement with the predictions of a simple theoretical model. Two extreme cases could be identified. Capillaries with a 700-μm diameter show uninhibited laser light propagation due to multireflections off the inner wall. In contrast, at the entrance of capillaries with a 200-μm inner diameter a plasma plug forms that absorbs most of the laser energy. In both cases significant energy transport was observed to occur in the axial direction. A stable and strongly radiating plasma column is formed along the capillary axis by the collision of the radially imploding plasma. During the collision, part of the hydrodynamic energy of the plasma is converted into radiative energy. In a special case-a lower limit of ≊7% could be inferred for the conversion efficiency from laser light into X-ray radiation emitted from the rear opening of the capillary.

scholarly journals A simple model for soft X-ray conversion efficiency from laser-irradiated gold disk targets

1984 ◽  
Vol 2 (3) ◽  
pp. 303-307 ◽  
Author(s):  
P. H. Y. Lee ◽  
H. G. Ahlstrom
Keyword(s):  
Heat Conduction ◽  
Simple Model ◽  
Conversion Efficiency ◽  
Laser Light ◽  
Laser Intensity ◽  
Laser Energy ◽  
High Irradiance ◽  
X Rays ◽  
X Ray ◽  
Laser Heated

Simple arguments are used to construct a model to explain the conversion efficiency of absorbed laser energy into soft X-rays from laser-irradiated targets. In this model, we postulate that the energy available for conversion is bounded at some low irradiance limit by heat conduction away from the laser heated spot, while at some high irradiance limit it is bounded by the energy lost in plasma blowoff. Consequently, at some appropriate laser intensity, where the sum energy of the conduction and blowoff losses is at a minimum, the X-ray conversion efficiency should reach a maximum. A specific example for gold disk targets irradiated by 0·53 μm laser light will be treated. Simple heuristic scalings of blowoff and conduction as functions of laser intensity are obtained.

scholarly journals Numerical modeling of quantum beam generation from ultra-intense laser-matter interactions

2015 ◽  
Vol 33 (2) ◽  
pp. 151-155 ◽  
Author(s):  
Tatsufumi Nakamura ◽  
Takehito Hayakawa
Keyword(s):  
Energy Transport ◽  
Laser Energy ◽  
Radiation Reaction ◽  
High Energy ◽  
Intense Laser ◽  
Incident Laser ◽  
Particle In Cell ◽  
Transport Code ◽  
Incident Laser Energy ◽  
Good Agreement

AbstractWhen intense laser beams interact with solid targets, high-energy photons are effectively generated via radiation reaction effect. These photons receive a large portion of the incident laser energy, and the energy transport by photons through the target is crucial for the understanding of the laser–matter interactions. In order to understand the energy transport, we newly developed a Particle-in-Cell code which includes the photon–matter interactions by introducing photon macro-particles. Test simulations are performed and compared with simulations using a particle transport code, which shows a good agreement.

Holographic moving picture recording and observation of ultrashort pulsed laser light propagation

2008 ◽  
Vol 36 (Supplement) ◽  
pp. 201-202
Author(s):  
Yasuhiro Awatsuji ◽  
Kenzo Nishio ◽  
Shogo Ura ◽  
Toshihiro Kubota
Keyword(s):  
Light Propagation ◽  
Laser Light ◽  
Pulsed Laser ◽  
Ultrashort Pulsed Laser

Stability and collapse of holes in liquid layers

2018 ◽  
Vol 855 ◽  
pp. 1130-1155 ◽  
Author(s):  
Cunjing Lv ◽  
Michael Eigenbrod ◽  
Steffen Hardt
Keyword(s):  
Liquid Film ◽  
Power Laws ◽  
Theoretical Models ◽  
Liquid Volume ◽  
Capillary Length ◽  
Minimum Thickness ◽  
The Stability ◽  
Film Profile ◽  
Hole Closure ◽  
Good Agreement

We investigate experimentally and theoretically the stability and collapse of holes in liquid layers on bounded substrates with various wettabilities. It is shown that for a liquid layer with a thickness of the order of the capillary length, a stable hole exists when the hole diameter is bigger than a critical value $d_{c}$. Consequently, a further increase of the liquid volume causes the hole to collapse. It is found that$d_{c}$increases with the size of the container, but its dependence on the contact angle is very weak. The experimental results are compared with theory, and good agreement is obtained. Moreover, we present investigations of the dynamics of the hole and the evolution of the liquid film profile after the collapse. The diameter of the hole during collapse and the minimum thickness of the liquid film shortly after the collapse obey different power laws with time. Simple theoretical models are developed which indicate that the collapse of the hole is triggered by surface tension and the subsequent closure process results from inertia, whereas the growth of the liquid column after hole closure results from the balance between the capillary force and inertia. Corresponding scaling coefficients are determined.

Effect of Focusing Plane on Laser Blow-off Shock Waves from Confined Aluminum and Copper Foils

2021 ◽  
Author(s):  
Nagaraju Guthikonda ◽  
Sai Shiva S ◽  
E. Manikanta ◽  
Kameswari P S L D ◽  
V. R. Ikkurthi ◽  
...  
Keyword(s):  
Laser Energy ◽  
Plasma Temperature ◽  
Laser Pulses ◽  
Ambient Air ◽  
Rear Side ◽  
Hydrodynamic Simulations ◽  
Enhanced Absorption ◽  
532 Nm ◽  
Lower Plasma Density ◽  
Good Agreement

Abstract We present results on the dynamics of laser-induced blow-off shockwave generation from the rear side of 20 µm thick aluminum and copper foil confined with a glass (BK7) substrate. These foils are irradiated by 10 ns, 532 nm laser pulses of energy 25 – 200 mJ corresponding to the intensity range 0.2 – 10 GW/cm2. The plasma temperature at the glass-foil interface is observed to play an important role in the coupling of laser energy to the foil. From our experiments and 1D hydrodynamic simulations, we confirm that moving the glass-foil interface away from the focal plane led to (a) enhanced absorption of the laser beam by the foil resulting in ~ 30 % higher blow-off shock velocities (b) significant changes in the material ejection in terms of increased blow-off mass of the foil (c) lower plasma density and temperatures. The material ejection as well as blow-off shock velocity is higher for Al compared to Cu. The simulated shock evolution in ambient air shows a reasonably good agreement with the experimental results.

Radiative Energy Transport

2021 ◽  
pp. 73-83
Author(s):  
Tianshu Liu ◽  
John P. Sullivan ◽  
Keisuke Asai ◽  
Christian Klein ◽  
Yasuhiro Egami
Keyword(s):  
Energy Transport ◽  
Radiative Energy ◽  
Radiative Energy Transport

scholarly journals Study of second harmonic emissions for characterization of laser–plasma X-ray sources

1998 ◽  
Vol 16 (2) ◽  
pp. 397-404 ◽  
Author(s):  
A. Giulietti ◽  
C. Beneduce ◽  
T. Ceccotti ◽  
D. Giulietti ◽  
L.A. Gizzi ◽  
...  
Keyword(s):  
Laser Beam ◽  
Transport Process ◽  
Energy Transport ◽  
Laser Light ◽  
Second Harmonic ◽  
Target Position ◽  
Laser Pulses ◽  
Strongly Correlated ◽  
X Ray

An investigation of second harmonic (SH) and X-ray emissions from Al plasmas produced by 3-ns, 1.064-μm laser pulses at 1014 W/cm2 is reported. The SH and X-ray yields are strongly correlated as a function of the target position with respect to the laser beam focus. The SH originates from the underdense coronal plasma and has a filamentary source, while the X-ray source is uniform. The results suggest that, although the X-ray emission is significantly enhanced by the filamentation of the laser light in the corona, there is a smoothing effect in the energy transport process toward the overdense region.

Sign in / Sign up

Export Citation Format

Share Document