Note on the Possibility of Flight by Human Power

1937 ◽  
Vol 41 (319) ◽  
pp. 609-611
Author(s):  
H. C. H. Townend

The object of this note is to draw attention to a few facts which, taken together, suggest that, from a purely aerodynamic point of view, the difficulties involved in flight by human power may not be as great as is generally supposed.Some years ago, in a lecture delivered to the Royal Aeronautical Society, the German soaring pilot, Lippisch, referred to an account of dynamic soaring given by Lanchester in his “ Aerodonetics ” and to some wind tunnel experiments made in Vienna.

2009 ◽  
Vol 26 (7) ◽  
pp. 1427-1432 ◽  
Author(s):  
M. Thurai ◽  
V. N. Bringi ◽  
M. Szakáll ◽  
S. K. Mitra ◽  
K. V. Beard ◽  
...  

Abstract Comparisons of drop shapes between measurements made using 2D video disdrometer (2DVD) and wind-tunnel experiments are presented. Comparisons are made in terms of the mean drop shapes and the axis ratio distributions. Very close agreement of the mean shapes is seen between the two sets of measurements; the same applies to the mean axis ratio versus drop diameter. Also, in both sets of measurements, an increase in the oscillation amplitudes with increasing drop diameter is observed. In the case of the 2DVD, a small increase in the skewness was also detected. Given that the two sets of measurements were conducted in very different conditions, the agreement between the two sets of data implies a certain “robustness” in the mean shape of oscillating drops that may be extended to natural raindrop oscillations, at least in steady rainfall and above the surface layer.


2017 ◽  
Vol 260 ◽  
pp. 85-91 ◽  
Author(s):  
Gurvan Jodin ◽  
Johannes Scheller ◽  
Eric Duhayon ◽  
Jean François Rouchon ◽  
Marianna Braza

Amongst current aircraft research topics, morphing wing is of great interest for improving the aerodynamic performance. A morphing wing prototype has been designed for wind tunnel experiments. The rear part of the wing - corresponding to the retracted flap - is actuated via a hybrid actuation system using both low frequency camber control and a high frequency vibrating trailing edge. The camber is modified via surface embedded shape memory alloys. The trailing edge vibrates thanks to piezoelectric macro-fiber composites. The actuated camber, amplitude and frequency ranges are characterized. To accurately control the camber, six independent shape memory alloy wires are controlled through nested closed-loops. A significant reduction in power consumption is possible via this control strategy. The effects on flow via morphing have been measured during wind tunnel experiments. This low scale mock-up aims to demonstrate the hybrid morphing concept, according to actuator capabilities point of view as well as aerodynamic performance.


2015 ◽  
Vol 724 ◽  
pp. 166-170
Author(s):  
Pu Qing Wang ◽  
Yan Tao Li ◽  
Yuan Ming Dou ◽  
Jing Jing Zhang

At the present stage, no detailed specifications and codes about wind effects on low-rise buildings in rural areas were made in Chinese. In order to reduce casualties and property loss due to wind damage, the investigation of wind tunnel experiments were carried out. The results indicate that the influence of purlin and front and rear eaves on wind load should be considered in building design. Because a specific blowing angle of wind would produce the largest wind load in the surface of the house. In the structure design, the value of shape coefficient should be increased to a certain degree and also amplify according to windward and leeward roofs.


Author(s):  
Petar Kazakov ◽  
Atanas Iliev ◽  
Emil Ivanov ◽  
Dobri Rusev

Significant technical progress has been made in recent years in the development of algae-based bioenergy, and much of industrial and academic R&D projects have diverged from the biofuels strategy. This report summarizes the conclusions of a recently concluded symposium analyzing the prospects for using micro- and macroalgae as a feedstock for biofuels and bioenergy. It discusses international activities for the development of bio-energy and non-energy algae bioproducts, advances in the use of macroalgae (both non-cultivated and cultivated algae). Applications for various biochemical and thermochemical uses, bio-refining capabilities for various products, as well as an in-depth review of the process from the point of view of economy and energy sustainability are also given.


2011 ◽  
Vol 60 (1) ◽  
pp. 87-102 ◽  
Author(s):  
Andrea Farsang ◽  
József Szatmári ◽  
Gábor Négyesi ◽  
Máté Bartus ◽  
Károly Barta

Összefoglalva megállapítható, hogy nagyobb szélsebesség hatására több talajanyag erodálódott, és ezzel együtt megnőtt az áthalmozott tápanyag mennyisége is. Minden vizsgált szélsebesség esetében a szélerózió következtében 3–7%-kal megnőtt az 1 mm és annál nagyobb szemcsék, illetve aggregátumok aránya a kiindulási talajanyag felső 0–1 cm-es rétegében. A finomabb szemcse-, illetve aggregátum-átmérők esetén a fújatást követően csökkenést tapasztaltunk. A leginkább a 315 μm és az annál kisebb szemcsék aránya csökkent, átlagosan 1–2%-kal. A minták kémiai és fizikai elemzéseiből megállapítható, hogy a láda utáni humuszosabb, aggregátumosabb szerkezetű minták N-tartalma nagyobb, mint az alapmintáé. A fogók mintáiban nem tapasztaltunk feldúsulást egy vizsgált elem esetében sem, a fogókban összegyűlt talajanyag kálium- és foszfortartalma is kisebb volt, mint az alapmintáé. Ennek oka, hogy az itt csapdázódott üledékben kisebb a tápanyag-megkötődés helyéül szolgáló leiszapolható rész aránya, mint a kiindulási talajanyagban. A vizsgálatainkból látszik, hogy a szélerózió hatására a lebegtetve, illetve ugráltatva áthalmozott talajszemcsékkel és aggregátumokkal szállított humusz 500–3500 kg/ha nagyságrendben mozoghat a vizsgált csernozjom területen akár egyetlen szélesemény hatására is. A kálium-áthalmozódás mértéke elérheti a 100 kg/ha értéket, a foszforé a 70 kg/ha-t, a nitrogénveszteség mértéke pedig akár 200–300 kg/ha is lehet egy szélesemény alkalmával. E tápanyagmennyiség nagy része több száz méter, de akár kilométeres távolságokra is távozhat a területről. Az általunk végzett szélcsatornás vizsgálatok eredményei becslésnek tekinthetők, hiszen vizsgálatunk során növénymaradvány-mentes, szitált és légszáraz talajanyaggal dolgoztunk. A szitálás eredményeként csupán a 2 mm-es és annál kisebb aggregátumok maradtak meg, ami azonban az intenzív művelés alá vont, porosodott, leromlott szerkezetű talajfelszín körülményeit jól közelíti. Ugyanakkor a természetben zajló széleróziós eseményeknek a szélcsatorna-kísérlet csak leegyszerűsített modellváltozata, hiszen az általunk szimulált szélesemények 15 percig tartottak, s nem tudtunk széllökéseket előállítani, melyek a széleróziós események alakulásában nagy jelentőségűek. Ennek tudatában kell a kapott eredményeket értékelni, mégis érdemes velük foglalkozni. A terepi mérésekkel szemben a szélcsatornában végzett vizsgálatoknak éppen az a legfontosabb előnye, hogy ellenőrzött, kontrollált körülmények között végezzük a méréseket, így rengeteg olyan szempontot meg tudunk vizsgálni, amit terepi mérésekkel lehetetlen lenne. Ilyen szempontok a pontos szélsebesség és szélirány hatása, az erodált felület nagysága és tulajdonságai. Kutatásunk következő lépése a szélcsatornás kísérletekkel vizsgált mintaterületeken terepi, mobil szélcsatornás vizsgálatok végzése, valamint terepi üledékcsapdák elhelyezésével a valós szélesemények által elszállított talaj mennyiségének és minőségének meghatározása. Célunk mind pontosabb képet alkotni a hazai jó minőségű csernozjom talajok szélerózió okozta tápanyagveszteségének mértékéről. A mezőgazdasági művelés alatt álló csernozjom területek feltalajában a tápanyag és szerves anyag szélerózió útján történő mozgási törvényszerűségeinek feltárása több szempontból is hasznos: segítséget jelent a területi tervezésben, a defláció szempontjából optimális területhasználat és művelési módok meghatározásában. Képet kapunk arról, hogy a legnagyobb gazdasági potenciállal rendelkező termőtalajunk milyen veszélyeknek van kitéve, s hogy a nem megfelelő időben, nem megfelelő nedvességviszonyok mellett történő talajművelés következtében kialakuló szerkezetromlás (porosodás) miatti deflációs károk milyen tápanyagveszteséggel járhatnak együtt.


2021 ◽  
Vol 21 (1-2) ◽  
pp. 56-71
Author(s):  
Janet van Niekerk ◽  
Haakon Bakka ◽  
Håvard Rue

The methodological advancements made in the field of joint models are numerous. None the less, the case of competing risks joint models has largely been neglected, especially from a practitioner's point of view. In the relevant works on competing risks joint models, the assumptions of a Gaussian linear longitudinal series and proportional cause-specific hazard functions, amongst others, have remained unchallenged. In this article, we provide a framework based on R-INLA to apply competing risks joint models in a unifying way such that non-Gaussian longitudinal data, spatial structures, times-dependent splines and various latent association structures, to mention a few, are all embraced in our approach. Our motivation stems from the SANAD trial which exhibits non-linear longitudinal trajectories and competing risks for failure of treatment. We also present a discrete competing risks joint model for longitudinal count data as well as a spatial competing risks joint model as specific examples.


2018 ◽  
Vol 65 (1) ◽  
pp. 93-125
Author(s):  
G. Bordogna ◽  
J.A. Keuning ◽  
R.H.M. Huijsmans ◽  
M. Belloli

Sign in / Sign up

Export Citation Format

Share Document