On the System: Bromine-Water

1956 ◽  
Vol 78 (22) ◽  
pp. 5752-5756 ◽  
Author(s):  
Clinton M. Kelley ◽  
H. V. Tartar
Keyword(s):  



Fuel ◽  
2021 ◽  
Vol 289 ◽  
pp. 119838
Author(s):  
Xiaogang Mu ◽  
Jinfang Liu ◽  
Fei Gao ◽  
Cunbao Deng ◽  
Zhixin Jin ◽  
...  


1983 ◽  
Vol 5 (2) ◽  
pp. 70-73 ◽  
Author(s):  
S. M. Dreijer Van Der Glas ◽  
T. Schalekamp ◽  
H. J. De Jong ◽  
A. Bult


1980 ◽  
Vol 51 (9) ◽  
pp. 4905-4907 ◽  
Author(s):  
K. Kamimura ◽  
T. Suzuki ◽  
A. Kunioka


2013 ◽  
Vol 563 ◽  
pp. 269-273 ◽  
Author(s):  
Qi Zhang ◽  
Chungui Tian ◽  
Aiping Wu ◽  
Yu Hong ◽  
Mingxia Li ◽  
...  


1960 ◽  
Vol 13 (1) ◽  
pp. 106 ◽  
Author(s):  
EOP Thompson

In degradative work on oxytocin (Mueller, Pierce, and du Vigneaud 1953; Ressler, Trippett, and du Vigneaud 1953; du Vigneaud et al. 1954) it was found that whereas oxidation with performic acid gave a single product (I), oxidation with bromine water or treatment of (I) with bromine water gave two peptide fragments, resulting from cleavage of a dibromotyrosylisoleucyl bond.



Clay Minerals ◽  
1994 ◽  
Vol 29 (1) ◽  
pp. 77-85 ◽  
Author(s):  
P. Dreher ◽  
E.-A. Niederbudde

AbstractInterlayer K from two biotites of different origin was extracted with octadecylammonium chloride (ODA) and sodium chloride/sodium tetraphenylboron (STB) before and after oxidation with saturated bromine water (Br2). Potassium release, Fe oxidation and Fe ejection from octahedra were measured. With ODA and STB the untreated biotites released between 40 and 90% of initial interlayer K, the muscovite less than 5%. After Br2 treatment, substantially less K was extracted from both biotites. Suppression of K release was caused by the formation of octahedral vacancies formerly occupied by Fe. The extent of Fe ejection was not proportional to the extent of octahedral Fe oxidation. During Br2 treatment, the biotites transformed into hydrobiotite. The hydrobiotite sample, high in Fe ejection during preceding Br2 treatment, strongly resisted subsequent K extraction with STB, whereas the sample with minor Fe ejection transformed to vermiculite. Octadecylammonium chloride extracts K more effectively than STB from biotites intermediate between trioctahedral and dioctahedral structure and is considered to be suitable for the distinction between biotite K and muscovite K.





2000 ◽  
Vol 18 (3) ◽  
pp. 235-241 ◽  
Author(s):  
A. Bailey ◽  
S.E. Meech ◽  
M.R. Williams

A nutshell-based activated carbon was treated with hydrochloric acid to partially de-ash it. The de-ashed sample was then treated with bromine water and subsequently hydrogenated. The base sample was also treated with bromine water and then hydrogenated. The surface areas and pore volumes available to water vapour were unchanged by these treatments, although the polar surface area was considerably reduced in each case. The sample with the lowest surface polarity had the worst performance (shortest penetration time) when pre-humidified at 80% RH and tested with hexane. Examination of the humidity leaving the bed during the adsorption of hexane vapour suggested that the rate-determining step was the surface transport of displaced water and that removing the ash content hindered this transport considerably. Bromination followed by hydrogenation, although reducing the polarity, did not remove the ash content and may even have improved its ability to transport displaced water.



Sign in / Sign up

Export Citation Format

Share Document