scholarly journals Free Volume Investigation of Polymers of Intrinsic Microporosity (PIMs): PIM-1 and PIM1 Copolymers Incorporating Ethanoanthracene Units

2010 ◽  
Vol 43 (14) ◽  
pp. 6075-6084 ◽  
Author(s):  
Thomas Emmler ◽  
Kathleen Heinrich ◽  
Detlev Fritsch ◽  
Peter M. Budd ◽  
Nhamo Chaukura ◽  
...  
Membranes ◽  
2015 ◽  
Vol 5 (2) ◽  
pp. 214-227 ◽  
Author(s):  
Muntazim Khan ◽  
Volkan Filiz ◽  
Thomas Emmler ◽  
Volker Abetz ◽  
Toenjes Koschine ◽  
...  

2014 ◽  
Vol 2 (30) ◽  
pp. 11742-11752 ◽  
Author(s):  
Amanda G. McDermott ◽  
Peter M. Budd ◽  
Neil B. McKeown ◽  
Coray M. Colina ◽  
James Runt

X-ray scattering patterns from these high free-volume polymeric glasses contain a feature strongly associated with porosity; it is sensitive to time, temperature and film thickness in a manner consistent with physical aging, which impacts membrane performance in gas separations.


Membranes ◽  
2019 ◽  
Vol 9 (3) ◽  
pp. 41 ◽  
Author(s):  
Colin Scholes ◽  
Shinji Kanehashi

Polymers of intrinsic microporosity (PIMs) are a promising membrane material for gas separation, because of their high free volume and micro-cavity size distribution. This is countered by PIMs-based membranes being highly susceptible to physical aging, which dramatically reduces their permselectivity over extended periods of time. Supercritical carbon dioxide is known to plasticize and partially solubilise polymers, altering the underlying membrane morphology, and hence impacting the gas separation properties. This investigation reports on the change in PIM-1 membranes after being exposed to supercritical CO2 for two- and eight-hour intervals, followed by two depressurization protocols, a rapid depressurization and a slow depressurization. The exposure times enables the impact contact time with supercritical CO2 has on the membrane morphology to be investigated, as well as the subsequent depressurization event. The density of the post supercritical CO2 exposed membranes, irrespective of exposure time and depressurization, were greater than the untreated membrane. This indicated that supercritical CO2 had solubilised the polymer chain, enabling PIM-1 to rearrange and contract the free volume micro-cavities present. As a consequence, the permeabilities of He, CH4, O2 and CO2 were all reduced for the supercritical CO2-treated membranes compared to the original membrane, while N2 permeability remained unchanged. Importantly, the physical aging properties of the supercritical CO2-treated membranes altered, with only minor reductions in N2, CH4 and O2 permeabilities observed over extended periods of time. In contrast, He and CO2 permeabilities experienced similar physical aging in the supercritical treated membranes to that of the original membrane. This was interpreted as the supercritical CO2 treatment enabling micro-cavity contraction to favour the smaller CO2 molecule, due to size exclusion of the larger N2, CH4 and O2 molecules. Therefore, physical aging of the treated membranes only had minor impact on N2, CH4 and O2 permeability; while the smaller He and CO2 gases experience greater permeability loss. This result implies that supercritical CO2 exposure has potential to limit physical aging performance loss in PIM-1 based membranes for O2/N2 separation.


Polymers ◽  
2021 ◽  
Vol 14 (1) ◽  
pp. 119
Author(s):  
Esra Caliskan ◽  
Sergey Shishatskiy ◽  
Silvio Neumann ◽  
Volker Abetz ◽  
Volkan Filiz

In the present work, a set of anthracene maleimide monomers with different aliphatic side groups obtained by Diels Alder reactions were used as precursors for a series of polymers of intrinsic microporosity (PIM) based homo- and copolymers that were successfully synthesized and characterized. Polymers with different sizes and shapes of aliphatic side groups were characterized by size-exclusion chromatography (SEC), (nuclear magnetic resonance) 1H-NMR, thermogravimetric (TG) analysis coupled with Fourier-Transform-Infrared (FTIR) spectroscopy (TG-FTIR) and density measurements. The TG-FTIR measurement of the monomer-containing methyl side group revealed that the maleimide group decomposes prior to the anthracene backbone. Thermal treatment of homopolymer methyl-100 thick film was conducted to establish retro-Diels Alder rearrangement of the homopolymer. Gas and water vapor transport properties of homopolymers and copolymers were investigated by time-lag measurements. Homopolymers with bulky side groups (i-propyl-100 and t-butyl-100) experienced a strong impact of these side groups in fractional free volume (FFV) and penetrant permeability, compared to the homopolymers with linear alkyl side chains. The effect of anthracene maleimide derivatives with a variety of aliphatic side groups on water vapor transport is discussed. The maleimide moiety increased the water affinity of the homopolymers. Phenyl-100 exhibited a high water solubility, which is related to a higher amount of aromatic rings in the polymer. Copolymers (methyl-50 and t-butyl-50) showed higher CO2 and CH4 permeability compared to PIM-1. In summary, the introduction of bulky substituents increased free volume and permeability whilst the maleimide moiety enhanced the water vapor affinity of the polymers.


2016 ◽  
Vol 52 (39) ◽  
pp. 6553-6556 ◽  
Author(s):  
Jian Zhang ◽  
Hong Kang ◽  
Jacob Martin ◽  
Shouhai Zhang ◽  
Sylvie Thomas ◽  
...  

We present a new strategy to improve the rigidity of PIM-1 through the introduction of 8-membered ring locking into the flexible spiro-carbon pivot point to produce a more rigid interlocked polycyclic structure.


Polymer ◽  
2014 ◽  
Vol 55 (1) ◽  
pp. 326-329 ◽  
Author(s):  
James Vile ◽  
Mariolino Carta ◽  
C. Grazia Bezzu ◽  
Benson M. Kariuki ◽  
Neil B. McKeown

Sign in / Sign up

Export Citation Format

Share Document