Deciphering fine electrical conductivity structures in the crust from MT data using the equivalent conductivity formula

Author(s):  
Shuyu Liu ◽  
Yixian Xu ◽  
Bo Yang ◽  
Zeqiu Guo ◽  
Yuan Shi ◽  
...  
1968 ◽  
Vol 23 (6) ◽  
pp. 926-932
Author(s):  
Vittoriano Wagner ◽  
Sandro Forcheri

The electrical conductivity of molten (Na—Rb)NO3 and (Tl—Rb)NO3 was determined.While the equivalent conductivity of the first system shows the usual negative deviation from additivity, that of the second one varies nearly linearly with composition.After discussing the conductivity isotherms in terms of some proposed models, an excess conductivity isotherm is presented, derived on the basis of simple assumptions about the trend of both cationic mobilities.


If the measure of the electrical conductivity of a solution be divided by that of the concentration expressed in gramme-equivalents per unit volume, we obtain a quantity which may be called the equivalent conductivity of the solution. If the conductivity of the solvent used be subtracted from that of the solution, the corresponding quantity may be taken as giving the equivalent conductivity of the solute. As is well known, the equivalent conductivity of neutral salts when dissolved in water approaches a limiting value as the dilution is increased, and, in terms of the ionisation theory, this limiting value corresponds with complete ionisation.


Alloy Digest ◽  
1987 ◽  
Vol 36 (1) ◽  

Abstract ZHC COPPER is a high-electrical-conductivity alloy developed to satisfy the requirements of high-power electronic circuits. It has high strength compared to other metals of equivalent conductivity, good bend formability, excellent stress-relaxation resistance and is readily soldered. It also is known as Olin Alloy C151. This datasheet provides information on composition, physical properties, microstructure, hardness, elasticity, and tensile properties. It also includes information on corrosion resistance as well as forming, heat treating, and joining. Filing Code: Cu-520. Producer or source: Olin Brass.


2013 ◽  
Vol 433-435 ◽  
pp. 1894-1897
Author(s):  
Long Dou ◽  
Bin Chen ◽  
Hai Lin Chen

A numerical method for modeling equivalent electrical conductivity of closed-cell aluminum foams material based on CST software has been presented. The equivalent electrical conductivity is calculated through summing up the total loss produced in the multicomponent aluminum foams model which has been analyzed by the CST software. The influences of porosity on the electrical conductivities are investigated numerically and the mathematical formulas of the relationship between porosity and conductivity are also shown. The validity of the proposed model was verified through applications of the model in many practical problems, where excellent agreement between measured and calculated results was obtained.


The first section of the present paper contains an account of a continuation of the work described in the 'Proceedings of the Royal Society,’ A, vol. 76, p. 577, 1905, and a statement of the object of the investigation may be reproduced from that place : “ If the measure of the electrical conductivity of a solution be divided by that of the concentration expressed in gramme-equivalents per unit volume, we obtain a quantity which may be called the equivalent conductivity of the solution. If the conductivity of the solvent used be subtracted from that of the solution, the corresponding quantity may be taken as giving the equivalent conductivity of the solute.


2020 ◽  
Vol 61 (1) ◽  
pp. 81-85
Author(s):  
Vera A. Petrukhina ◽  
◽  
Pavel I. Fedorov ◽  
Ksenia A. Konnova ◽  
Maria V. Yakimova ◽  
...  

Earlier, we studied the electrical conductivity of inorganic salts in a number of alcohols (ethanol, propanol-2, and butanol-1) at room temperature and found that alcoholic solutions of inorganic salts are weak electrolytes. It is known that an increase in the temperature of salt solutions leads to an increase in electrical conductivity due to an increase in the mobility of their ions in the solvent medium. To study the temperature dependence of the electrical conductivity of aqueous solutions of electrolytes, we proposed an approach based on the study of the effect of temperature on the equivalent electrical conductivity of solutions at infinite dilution λ∞. Using this approach, we studied the electrical conductivity of aqueous solutions of a number inorganic salts (nitrates, acetates, and phosphates), carboxylic acids, and amino acids as a function of temperature. It was found that for these solutions the dependence λ∞(Т) is described by the exponential Arrhenius equation λ∞ = Аexp(-E/(RT)). This equation was used to describe the temperature dependence of the ultimate equivalent conductivity for solutions of a number of inorganic salts (calcium and nitrate calcium, cadmium, lithium and potassium iodides, chloride, iodide and ammonium nitrate, silver nitrate and sodium bromide) in ethanol. This article investigated and demonstrated the possibility of describing the experimental data λ∞(Т) for solutions of ethylates, propylates and isopropylates of sodium and potassium in the corresponding alcohols (ethylates in ethanol, propylates in propanol, isopropylates in isopropyl alcohol) using the same equation.


2019 ◽  
Vol 57 (1) ◽  
pp. 154-158
Author(s):  
Vera A. Petrukhina ◽  
◽  
Tatiana A. Kirillova ◽  
Ludmila Yu. Tcareva ◽  
Ekaterina V. Andreeva ◽  
...  

Electrical conductivity of solutions depends on the nature of the solute and solvent. It is associated with the mobility of ions that are formed during the dissociation of substances in the corresponding solvents. In solvents with large dielectric constant values, substances dissociate into their constituent ions to a greater degree. The dielectric constant of water at room temperature is 78.25. It is a universal solvent and most salts dissolve in it with the decomposition into ions. In proton solvents containing mobile hydrogen ions, salts also dissolve with dissociation into ions. Such solvents include alcohols, the dielectric constant of which is significantly less than the dielectric constant of water. To describe the electrical conductivity of salt solutions in solvents with small dielectric constant, it is proposed to use the Pisarzhevsky-Valden equation in literature. This equation assumes that solvents have a similar chemical nature and the mechanism of salt ion solvation by molecules of different solvents is the same. The degree of solvation changes significantly from one solvent to another for salts containing small ions. This is due to the different solvation of ions in different solvents. Therefore, for such solutions, Pisarzhevsky-Valden equation should not be satisfied. To account for the mechanism of ion solvation in different solvents, A.M. Shkodin proposed an equation that takes into account the dielectric constant of solvent. In this regard the possibility of describing the equivalent conductivity of alcohol solutions of salts with infinite dilution by the equations of Pisarzewski-Valden and Shkodin has been studied in this article. Electrical conductivity of the studied solutions was judged by the specific χ and equivalent to λ electrical conductivities. These two conductivities are related by the equation λ = χ/С, where С is the solution concentration. In this article, for salt solutions of with different concentrations in a certain alcohol, the values of χ and λ were found. By analyzing the dependences 1/λ = f(λС), the values of the limiting equivalent conductivity (λ∞) were found at C = 0. For solutions of each salt in different alcohols, the possibility of describing the obtained values of λ∞ by the Pisarzhevsky-Valden (λ∞· = const) and Shkodin (λ∞· = А·exp(-B/D), where  and D are viscosity and the dielectric constant of alcohol; A, B = const). It was found that the experimental data obtained for solutions of sodium iodite and chlorides of cobalt, iron (3), lithium, calcium, nickel, copper, zinc in alcohols (ethanol, propanol-2 and batanol-1) are better described by the Shkodin equation.


1978 ◽  
Vol 33 (5) ◽  
pp. 601-609
Author(s):  
F. Schneider

The electrical conductivity of tetrabutylammonium picrate is measured in the liquid crystal phases of two 4-alkyloxy-4'-cyanobiphenyls as a function of the temperature and of the electrolyte concentration. The conductivity is corrected for the electrode polarization and the dielectric relaxation which are determined from the frequency dependence of the conductivity. The equivalent conductivity values in the nematic phase of a mixture of 4-pentyloxy-4'- cyanobiphenyl and 4-heptyloxy-4'-cyanobiphenyl are extrapolated to infinite dilution. The electrical conductivity in 4-octyloxy-4'-cyanobiphenyl is measured in the nematic and in the smectic phase. It changes continuously with the temperature in the region of the phase transition. The anisotropy ratio for both liquid crystals under investigation yields a strong dependence upon the concentration of the electrolyte. This behaviour is compared with results obtained for other liquid crystals


1967 ◽  
Vol 22 (2) ◽  
pp. 208-212 ◽  
Author(s):  
Arnold Kvist

The electrical conductivity of solid and molten Li2SO4—Ag2SO4 has been measured for different concentration values. Density measurements of molten Li2SO4, Ag2SO4 and equimolar (Li, Ag) 2SO4 show that the system can be considered ideal. The equivalent conductivity of molten (Li, Ag)2SO4 can be calculated from the conductivities of the pure salts by assuming that the cations are moving in groups, each group containing about four cations.


1952 ◽  
Vol 30 (12) ◽  
pp. 922-923 ◽  
Author(s):  
June Byrne ◽  
Helen Fleming ◽  
F. E. W. Wetmore

Conductivity and density data have been obtained for the system silver nitrate – sodium nitrate. The Arrhenius energy of activation for electrical migration in sodium nitrate and in the binary melts decreases with rising temperature above the melting point, as was shown previously for silver nitrate. The equivalent conductivity isotherms for the binary melts are almost linear in the mole fraction.


Sign in / Sign up

Export Citation Format

Share Document