Electric–dielectric properties and complex impedance analysis of La0.5Ca0.5−xAgxMnO3 manganites

RSC Advances ◽  
2015 ◽  
Vol 5 (3) ◽  
pp. 2177-2184 ◽  
Author(s):  
M. Smari ◽  
H. Rahmouni ◽  
N. Elghoul ◽  
I. Walha ◽  
E. Dhahri ◽  
...  
Keyword(s):  
Dielectric Properties ◽  
Impedance Spectroscopy ◽  
Complex Impedance ◽  
Impedance Analysis ◽  
Spectroscopy Technique ◽  
Complex Impedance Analysis ◽  
Impedance Spectroscopy Technique

The electric and dielectric properties of La0.5Ca0.5−xAgxMnO3 (LCMO–Ag with x = 0 and x = 0.4) were investigated using the impedance spectroscopy technique.

scholarly journals The effects of calcination and doping on structural and dielectric properties of CaCu3-xCoxTi4O12 ceramic

2019 ◽  
Vol 8 (3) ◽  
pp. 234
Author(s):  
Nasr Hadi ◽  
Tajdine Lamcharfi ◽  
Farid Abdi ◽  
Nor-Said Echtoui ◽  
Ahmed Harrach ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Complex Impedance ◽  
Impedance Analysis ◽  
Xrd Analysis ◽  
Secondary Phases ◽  
Solid State Method ◽  
Complex Impedance Analysis ◽  
Oxide Powders ◽  
Increasing Temperature

<p class="Abstract"><span lang="EN-US">The influences of calcination temperature and doping with cobalt in A–site on structural and dielectric properties of CaCu<sub>3-x</sub>Co<sub>x</sub>Ti<sub>4</sub>O<sub>12</sub> (CCCxTO, x = 0.00, 0.02 and 0.10) ceramics sintered at 1050 <sup>0</sup>C for 8h were investigated. The ceramic samples are prepared by the conventional solid-state method using high purity oxide powders, and they are calcined at 850 °C, 950 °C and 1050 <sup>0</sup>C for 4h. The X-ray diffraction (XRD) analysis of pure and doped CCTO samples calcined at 950 °C and 1050 <sup>0</sup>C showed no traces of any other secondary phases, while impurity phases alongside CCTO phase in the x=0.00 sample calcined at 850 <sup>0</sup>C was observed. Scanning electron microscopy (SEM) investigation showed an increase in grain size with increasing of Co content and calcining temperature. Dielectric measurements indicated that the dielectric constant of the pure CCTO calcined at 1050 <sup>0</sup>C/4h has a low value in the frequency range of 1kHz up to 1MHz, whereas the substitution of Co up to x = 0.10 into CCTO caused a huge increase in the dielectric constant value of the calcined samples which is equal to 153419 and 18957 at 950 <sup>°</sup>C and 1050 <sup>0</sup>C respectively. The complex impedance analysis of all samples shows a decrease in resistance with an increasing temperature, which suggests a semiconductor nature of the samples.</span></p>

Dielectric Properties and Complex Impedance Analysis of BT–BMT–BS Ceramics

2016 ◽  
Vol 45 (8) ◽  
pp. 4083-4088 ◽  
Author(s):  
Raz Muhammad ◽  
Amir Khesro ◽  
Muhammad Uzair
Keyword(s):  
Dielectric Properties ◽  
Complex Impedance ◽  
Impedance Analysis ◽  
Complex Impedance Analysis

scholarly journals Суперионная проводимость твердых растворов (TlGaSe-=SUB=-2-=/SUB=-)-=SUB=-1-x-=/SUB=-(TlInS-=SUB=-2-=/SUB=-)-=SUB=-x-=/SUB=-

2018 ◽  
Vol 52 (10) ◽  
pp. 1111
Author(s):  
Р.М. Сардарлы ◽  
А.П. Абдуллаев ◽  
Н.А. Алиева ◽  
Ф.Т. Салманов ◽  
М.Ю. Юсифов ◽  
...  
Keyword(s):  
Phase Transition ◽  
Solid Solution ◽  
Electrical Conductivity ◽  
Impedance Spectroscopy ◽  
Complex Impedance ◽  
Relaxation Processes ◽  
Spectroscopy Technique ◽  
Abrupt Increase ◽  
Impedance Spectroscopy Technique ◽  
Frequency Dependences

AbstractSamples of (TlGaSe_2)_1 – _ x (TlInS_2)_ x solid solutions are synthesized. The frequency dependences (2 × 10^1–10^6 Hz) of components of the total complex impedance are studied by the impedance spectroscopy technique and relaxation processes are investigated depending on the composition of the (TlGaSe_2)_1 – _ x (TlInS_2)_ x solid solution in the solubility region ( x = 0–0.4). Corresponding diagrams on the ( Z ''– Z ') complex plane are analyzed using the equivalent substitutional circuit method. An anomaly in the temperature dependence of the electrical conductivity, which manifests itself in an abrupt increase in the conductivity, is found for the studied (TlGaSe_2)_1 – _ x (TlInS_2)_ x solid solution at 400 K. This peculiarity is associated with the phase transition into the superionic state.

scholarly journals The effects of calcination and doping on structural and dielectric properties of CaCu3-xCoxTi4O12 ceramic

2019 ◽  
Vol 8 (3) ◽  
pp. 234-244
Author(s):  
Nasr Hadi ◽  
Tajdine Lamcharfi ◽  
Farid Abdi ◽  
Nor-Said Echtoui ◽  
Ahmed Harrach ◽  
...  
Keyword(s):  
Dielectric Constant ◽  
Dielectric Properties ◽  
Complex Impedance ◽  
Impedance Analysis ◽  
Xrd Analysis ◽  
Secondary Phases ◽  
Solid State Method ◽  
Complex Impedance Analysis ◽  
Oxide Powders ◽  
Increasing Temperature

The influences of calcination temperature and doping with cobalt in A–site on structural and dielectric properties of CaCu3-xCoxTi4O12 (CCCxTO, x = 0.00, 0.02 and 0.10) ceramics sintered at 1050 0C for 8h were investigated. The ceramic samples are prepared by the conventional solid-state method using high purity oxide powders, and they are calcined at 850 °C, 950 °C and 1050 0C for 4h. The X-ray diffraction (XRD) analysis of pure and doped CCTO samples calcined at 950 °C and 1050 0C showed no traces of any other secondary phases, while impurity phases alongside CCTO phase in the x=0.00 sample calcined at 850 0C was observed. Scanning electron microscopy (SEM) investigation showed an increase in grain size with increasing of Co content and calcining temperature. Dielectric measurements indicated that the dielectric constant of the pure CCTO calcined at 1050 0C/4h has a low value in the frequency range of 1kHz up to 1MHz, whereas the substitution of Co up to x = 0.10 into CCTO caused a huge increase in the dielectric constant value of the calcined samples which is equal to 153419 and 18957 at 950 °C and 1050 0C respectively. The complex impedance analysis of all samples shows a decrease in resistance with an increasing temperature, which suggests a semiconductor nature of the samples.

Grain boundary effects in NTC-PTC composite thermistor materials

1999 ◽  
Vol 14 (1) ◽  
pp. 120-123 ◽  
Author(s):  
D. J. Wang ◽  
J. Qiu ◽  
Y. C. Guo ◽  
Z. L. Gui ◽  
L. T. Li
Keyword(s):  
Energy Level ◽  
Grain Boundary ◽  
Boundary Effect ◽  
Complex Impedance ◽  
Negative Temperature ◽  
Impedance Analysis ◽  
Composite Effect ◽  
Complex Impedance Analysis ◽  
Temperature Coefficient Of Resistivity ◽  
Grain Boundary Effect

Yttrium-doped (Sr0.45Pb0.55)TiO3 ceramics have been studied by complex impedance analysis. As a sort of NTC-PTC composite thermistor, it exhibited a significantly large negative temperature coefficient of resistivity below Tc in addition to the ordinary PTC characteristics above Tc. It is found that the NTC effect in NTC-PTC materials was not originated from the deep energy level of donor (bulk behavior), but from the electrical behavior of the grain boundary. Therefore, the NTC-PTC composite effect was assumed to be a grain boundary effect, and yttrium was a donor at shallow energy level. The NTC-PTC ceramics were grain boundary controlled materials.

Upshot of Concentration of Zirconium (IV) Oxynitrate Hexa Hydrate on Preparation and Analyses of Zirconium Oxide (ZrO2) Nanoparticles by Modified Co-Precipitation Method

2021 ◽  
Vol 21 (11) ◽  
pp. 5707-5713
Author(s):  
M. Ramachandran ◽  
R. Subadevi ◽  
P. Rajkumar ◽  
R. Muthupradeepa ◽  
R. Yuvakkumar ◽  
...  
Keyword(s):  
Ionic Conductivity ◽  
Complex Impedance ◽  
Impedance Analysis ◽  
Raw Material ◽  
Precipitation Method ◽  
Zro2 Nanoparticles ◽  
Fixed Amount ◽  
Complex Impedance Analysis ◽  
Dta Analysis ◽  
Co Precipitation

In the present work, pure nanocrystalline monoclinic Zirconia (ZrO2) has been successfully synthesized and optimized by the modified co-precipitation method. The concentration of raw material has been optimized with the fixed amount of precipitation agent (Potassium hydroxide KOH). The thermal history of the precursor has been examined through TG/DTA analysis. All the samples are subjected to study the structure, fingerprints of the molecular vibrations, and morphology analyses. The representative sample has been analyzed through Transmission Electron Microscope (TEM) and X-ray Photo Electron Spectroscopy (XPS) analyses. The as-prepared sample exhibits the better crystallinity and surface morphology with lesser particle size (190 nm) when the raw material concentration is 0.2 M. The as-prepared ZrO2 filler (0, 3, 6, 9, and 12 wt.%) is spread through the enhanced polymer electrolyte P(S-MMA) (27 Wt.%)-LiClO4 (8 wt.%)-EC + PC (1;1 of 65 wt.%) complex system via solution casting method. The as-synthesized electrolyte films are examined via complex impedance analysis. P(S-MMA) (27 wt.%)-LiCIO4 (8 wt.%)-EC + PC (1 ;1 of 65 wt.%)-6 wt.% of ZrO2 shows the high ionic conductivity 2.35 × 10–3 Scm–1. Temperature-dependent ionic conductivity studies obey the non-linear behavior. The enhanced ZrO2 has been expected to enhance the other electrochemical properties of the lithium secondary battery.

Sign in / Sign up

Export Citation Format

Share Document