Solvent effects on adsorption kinetics, dye monolayer, and cell performance of porphyrin-sensitized solar cells

RSC Advances ◽  
2016 ◽  
Vol 6 (115) ◽  
pp. 114037-114045
Author(s):  
Wenhui Li ◽  
Aili Zhu ◽  
Adam Stewart ◽  
Zonghao Liu ◽  
Yi-Bing Cheng ◽  
...  

The effect of three dye loading solvents (THF, ethanol, and n-butanol) on the adsorption kinetics, the binding mode of the dye molecules on the TiO2 nanoparticles, and photovoltaic performance in dye-sensitized solar cells was reported.

2011 ◽  
Vol 497 ◽  
pp. 61-66 ◽  
Author(s):  
Kenji Kakiage ◽  
Masaki Yamamura ◽  
Toru Kyomen ◽  
Masafumi Unno ◽  
Minoru Hanaya

The effects of the silyl-anchor group number on the adsorption and the sensitizing properties were examined in sensitizing dyes for dye-sensitized solar cells by using 4-alkoxysilyl and 2,4-dialkoxysilyl azobenzenes. The TiO2electrode with the 2,4-disilyl dye exhibited higher durability to water and better photovoltaic performance than that with the 4-monosilyl dye, although the amount of 2,4-disilyl dye molecules adsorbed on the TiO2electrode was slightly smaller than in the case of 4-monosilyl dye.


2017 ◽  
Vol 2017 ◽  
pp. 1-5 ◽  
Author(s):  
Zainal Arifin ◽  
Sudjito Soeparman ◽  
Denny Widhiyanuriyawan ◽  
Suyitno Suyitno

Dye-sensitized solar cells (DSSCs) based on natural sensitizers have become a topic of significant research because of their urgency and importance in the energy conversion field and the following advantages: ease of fabrication, low-cost solar cell, and usage of nontoxic materials. In this study, the chlorophyll extracted from papaya leaves was used as a natural sensitizer. Dye molecules were adsorbed by TiO2 nanoparticle surfaces when submerged in the dye solution for 24 h. The concentration of the dye solution influences both the amount of dye loading and the DSSC performance. The amount of adsorbed dye molecules by TiO2 nanoparticle was calculated using a desorption method. As the concentration of dye solution was increased, the dye loading capacity and power conversion efficiency increased. Above 90 mM dye solution concentration, however, the DSSC efficiency decreased because dye precipitated on the TiO2 nanostructure. These characteristics of DSSCs were analyzed under the irradiation of 100 mW/cm2. The best performance of DSSCs was obtained at 90 mM dye solution, with the values of Voc, Jsc,  FF, and efficiency of DSSCs being 0.561 V, 0.402 mA/cm2, 41.65%, and 0.094%, respectively.


RSC Advances ◽  
2019 ◽  
Vol 9 (6) ◽  
pp. 3056-3062 ◽  
Author(s):  
Xiong He ◽  
Jingyu Zhang ◽  
Yan Guo ◽  
Jinghua Liu ◽  
Xin Li

Hierarchical NP-MS combines the beneficial properties of improved scattering capability, dye loading ability, electron transport and inhibited charge recombination. The photoelectric conversion efficiency up to 7.32% has been obtained.


2013 ◽  
Vol 2013 ◽  
pp. 1-11 ◽  
Author(s):  
Jie Qu ◽  
Chao Lai

Titanium dioxide (TiO2) is star materials due to its remarkable optical and electronic properties, resulting in various applications, especially in the fields of dye-sensitized solar cells (DSSCs). Photoanode is the most important part of the DSSCs, which help to adsorb dye molecules and transport the injected electrons. The size, structure, and morphology of TiO2photoanode have been found to show significant influence on the photovoltaic performance of DSSCs. In this paper, we briefly summarize the synthesis and properties of one-dimensional (1D) TiO2nanomaterials (bare 1D TiO2nanomaterial and 1D hierarchical TiO2) and their photovoltaic performance in DSSCs.


2020 ◽  
Vol 44 (30) ◽  
pp. 12909-12915
Author(s):  
Yi-Qiao Yan ◽  
Yi-Zhou Zhu ◽  
Pan-Pan Dai ◽  
Jun Han ◽  
Mao Yan ◽  
...  

Effects of hetero-donors on the photovoltaic performance of tetraphenylethylene-based organic dyes were systematically investigated.


Materials ◽  
2021 ◽  
Vol 14 (9) ◽  
pp. 2150
Author(s):  
Ji-Hye Kim ◽  
Sung-Yoon Park ◽  
Dong-Hyuk Lim ◽  
So-Young Lim ◽  
Jonghoon Choi ◽  
...  

Organic solvents used for electrolytes of dye-sensitized solar cells (DSSCs) are generally not only toxic and explosive but also prone to leakage due to volatility and low surface tension. The representative dyes of DSSCs are ruthenium-complex molecules, which are expensive and require a complicated synthesis process. In this paper, the eco-friendly DSSCs were presented based on water-based electrolytes and a commercially available organic dye. The effect of aging time after the device fabrication and the electrolyte composition on the photovoltaic performance of the eco-friendly DSSCs were investigated. Plasma treatment of TiO2 was adopted to improve the dye adsorption as well as the wettability of the water-based electrolytes on TiO2. It turned out that the plasma treatment was an effective way of improving the photovoltaic performance of the eco-friendly DSSCs by increasing the efficiency by 3.4 times. For more eco-friendly DSSCs, the organic-synthetic dye was replaced by chlorophyll extracted from spinach. With the plasma treatment, the efficiency of the eco-friendly DSSCs based on water-electrolytes and chlorophyll was comparable to those of the previously reported chlorophyll-based DSSCs with non-aqueous electrolytes.


Molecules ◽  
2020 ◽  
Vol 25 (1) ◽  
pp. 198 ◽  
Author(s):  
Michèle Chevrier ◽  
Alberto Fattori ◽  
Laurent Lasser ◽  
Clément Kotras ◽  
Clémence Rose ◽  
...  

Chlorophyll a derivatives were integrated in “all solid-state” dye sensitized solar cells (DSSCs) with a mesoporous TiO2 electrode and 2′,2′,7,7′-tetrakis[N,N-di(4-methoxyphenyl)amino]-9,9′-spirobifluorene as the hole-transport material. Despite modest power conversion efficiencies (PCEs) between 0.26% and 0.55% achieved for these chlorin dyes, a systematic investigation was carried out in order to elucidate their main limitations. To provide a comprehensive understanding of the parameters (structure, nature of the anchoring group, adsorption …) and their relationship with the PCEs, density functional theory (DFT) calculations, optical and photovoltaic studies and electron paramagnetic resonance analysis exploiting the 4-carboxy-TEMPO spin probe were combined. The recombination kinetics, the frontier molecular orbitals of these DSSCs and the adsorption efficiency onto the TiO2 surface were found to be the key parameters that govern their photovoltaic response.


2017 ◽  
Vol 2017 ◽  
pp. 1-10 ◽  
Author(s):  
Carolynne Zie Wei Sie ◽  
Zainab Ngaini

Sensitization of heavy metal free organic dyes onto TiO2 thin films has gained much attention in dye sensitized solar cells (DSSCs). A series of new kojic acid based organic dyes KA1–4 were synthesized via nucleophilic substitution of azobenzene bearing different vinyl chains A1–4 with kojyl chloride 4. Azo dyes KA1–4 were characterized for photophysical properties employing absorption spectrometry and photovoltaic characteristic in TiO2 thin film. The presence of vinyl chain in A1–4 improved the photovoltaic performance from 0.20 to 0.60%. The introduction of kojic acid obtained from sago waste further increases the efficiency to 0.82–1.54%. Based on photovoltaic performance, KA4 achieved the highest solar to electrical energy conversion efficiency (η = 1.54%) in the series.


Sign in / Sign up

Export Citation Format

Share Document