Soft switching for power factor correction for server power supply unit

Author(s):  
H. Nakao ◽  
Yu. Yonezawa ◽  
Y. Nakashima ◽  
T. Sugimoto ◽  
T. Horie
2010 ◽  
Vol 29-32 ◽  
pp. 2422-2427
Author(s):  
Qian Hua Xiao ◽  
Hai Jing Liu

With the development of power electronics,the technology of Switching Mode Power Supply(SMPS) is gradually perfected. However,there is no end to the demand for a high power and high performance power supply. Nowadays, Power Factor Correction (PFC) technique is widely researched. This paper mainly analyzes the fundamental configuration of the switching power supply. And we study the basic structure and the operating principles of ZVT-boost soft-switching PFC circuit and the implementing principle of soft switch. For the power requirements, the two-stage PFC circuit is used. The forward stage is a single-phase Boost Power Factor Correction circuit and the backward stage main circuit is a full-bridge converter with the phase-shifting control soft-switching technique. Finally the simulating analysis is performed to the designed system.


2017 ◽  
Vol 32 (10) ◽  
pp. 7716-7726 ◽  
Author(s):  
Muntasir Alam ◽  
Wilson Eberle ◽  
Deepak S. Gautam ◽  
Chris Botting

2012 ◽  
Vol 433-440 ◽  
pp. 5549-5555
Author(s):  
Yun Tao Yue ◽  
Yan Lin

A novel scheme of low power communication power supply with high power factor and soft-switching is presented, a power factor corrector and dc/dc converter of passive lossless soft-switching is based on a ML4803 IC control. DC/DC converter introduces a novel two-transistor forward soft-switching technique, which realizes zero-voltage turn-on and turn-off, with no additional switches. a communication power supply module is developed in this paper. It has the characteristics of rapid dynamic response, high power factor, high efficiency and small bulk ect.


2021 ◽  
Author(s):  
Svetlana Podnebennaya ◽  
Vladimir Burlaka ◽  
Sergey Gulakov ◽  
Ekaterina Kudinova ◽  
Volodymyr Kysliak

2012 ◽  
Vol 424-425 ◽  
pp. 941-944
Author(s):  
Xue Mei Hu ◽  
Guo Tong Zhang

Correction Technology on active power factor is now widely used in AC-DC power supply circuit to eliminate harmonic of power system, to improve the power factor. Firstly the method of power factor correction technology is set out. Secondly, the basic principle of active power factor correction technology is analyzed, then the control method for active power factor correction technology is given. Finally the development trend of active power factor correction technology is analyzed.


PLoS ONE ◽  
2020 ◽  
Vol 15 (9) ◽  
pp. e0239008 ◽  
Author(s):  
Muhammad Abid ◽  
Fiaz Ahmad ◽  
Farman Ullah ◽  
Usman Habib ◽  
Saeed Nawaz ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document