Technique for compensation of errors in analogue multipliers

1989 ◽  
Vol 25 (5) ◽  
pp. 305 ◽  
Author(s):  
A. Cichocki ◽  
R. Unbehauen
2016 ◽  
Vol 16 (16) ◽  
pp. 10313-10332 ◽  
Author(s):  
Giancarlo Ciarelli ◽  
Sebnem Aksoyoglu ◽  
Monica Crippa ◽  
Jose-Luis Jimenez ◽  
Eriko Nemitz ◽  
...  

Abstract. Four periods of EMEP (European Monitoring and Evaluation Programme) intensive measurement campaigns (June 2006, January 2007, September–October 2008 and February–March 2009) were modelled using the regional air quality model CAMx with VBS (volatility basis set) approach for the first time in Europe within the framework of the EURODELTA-III model intercomparison exercise. More detailed analysis and sensitivity tests were performed for the period of February–March 2009 and June 2006 to investigate the uncertainties in emissions as well as to improve the modelling of organic aerosol (OA). Model performance for selected gas phase species and PM2.5 was evaluated using the European air quality database AirBase. Sulfur dioxide (SO2) and ozone (O3) were found to be overestimated for all the four periods, with O3 having the largest mean bias during June 2006 and January–February 2007 periods (8.9 pbb and 12.3 ppb mean biases respectively). In contrast, nitrogen dioxide (NO2) and carbon monoxide (CO) were found to be underestimated for all the four periods. CAMx reproduced both total concentrations and monthly variations of PM2.5 for all the four periods with average biases ranging from −2.1 to 1.0 µg m−3. Comparisons with AMS (aerosol mass spectrometer) measurements at different sites in Europe during February–March 2009 showed that in general the model overpredicts the inorganic aerosol fraction and underpredicts the organic one, such that the good agreement for PM2.5 is partly due to compensation of errors. The effect of the choice of VBS scheme on OA was investigated as well. Two sensitivity tests with volatility distributions based on previous chamber and ambient measurements data were performed. For February–March 2009 the chamber case reduced the total OA concentrations by about 42 % on average. In contrast, a test based on ambient measurement data increased OA concentrations by about 42 % for the same period bringing model and observations into better agreement. Comparison with the AMS data at the rural Swiss site Payerne in June 2006 shows no significant improvement in modelled OA concentration. Further sensitivity tests with increased biogenic and anthropogenic emissions suggest that OA in Payerne was affected by changes in emissions from residential heating during the February–March 2009 whereas it was more sensitive to biogenic precursors in June 2006.


Author(s):  
Christoph R. Gossweiler ◽  
Peter Kupferschmied ◽  
George Gyarmathy

A system for fast-response probe measurements in turbomachine flows has been developed and tested. The system has been designed for 40 kHz bandwidth and used with various in-house built probes accommodating up to 4 piezoresistive pressure transducers. The present generation of probes works accurately up to several bar pressure and 120°C temperature. The probes were found to be quite robust. The use of miniature pressure transducers placed in the head of probes showed that a precise packaging technique and a careful compensation of errors can considerably improve the accuracy of the pressure measurement. Methods for aerodynamic probe calibration and off-line data evaluation are briefly presented. These aimed, i.e. in the case of a 4-hole probe, at measuring the velocity fluctuations as characterised by yaw, pitch, total pressure and static pressure and at deriving mean values and spectral or turbulence parameters. Applications of the measuring system to turbomachinery flow in a radial compressor and to a turbulent pipe flow demonstrate the performance of the measuring system.


2020 ◽  
Vol 26 (11) ◽  
pp. 3469-3476
Author(s):  
Kyung-min Lee ◽  
Taehyeong Gu ◽  
Young-bong Bang

Procedia CIRP ◽  
2013 ◽  
Vol 7 ◽  
pp. 305-310 ◽  
Author(s):  
Ulrich Schneider ◽  
Manuel Drust ◽  
Arnold Puzik ◽  
Alexander Verl

1995 ◽  
Vol 117 (4) ◽  
pp. 611-617 ◽  
Author(s):  
C. R. Gossweiler ◽  
P. Kupferschmied ◽  
G. Gyarmathy

A system for fast-response probe measurements in turbomachine flows has been developed and tested. The system has been designed for 40 kHz bandwidth and used with various in-house built probes accommodating up to four piezoresistive pressure transducers. The present generation of probes works accurately up to several bar pressure and 120°C temperature. The probes were found to be quite robust. The use of a miniature pressure transducer placed in the head of a probe showed that a precise packaging technique and a careful compensation of errors can considerably improve the accuracy of the pressure measurement. Methods for aerodynamic probe calibration and off-line data evaluation are briefly presented. These aimed, e.g., in the case of a four-hole probe, at measuring the velocity fluctuations as characterized by yaw, pitch, total pressure, and static pressure and at deriving mean values and spectral or turbulence parameters. Applications of the measuring system to turbomachinery flow in a radial compressor and to a turbulent pipe flow demonstrate the performance of the measuring system.


Sign in / Sign up

Export Citation Format

Share Document