scholarly journals Numerical study on small scale vertical axis wind turbine

2016 ◽  
Vol 114 ◽  
pp. 02088 ◽  
Author(s):  
Teresa Parra-Santos ◽  
Armando Gallegos ◽  
Cristóbal N. Uzarraga ◽  
Miguel A. Rodriguez
Keyword(s):  
Wind Turbine ◽  
Numerical Study ◽  
Vertical Axis ◽  
Small Scale ◽  
Vertical Axis Wind Turbine

Numerical Investigation of a Vertical Axis Wind Turbine Performance Characterization Using New Variable Pitch Control Scheme

2019 ◽  
Vol 142 (3) ◽  
Author(s):  
Amin A. Mohammed ◽  
Ahmet Z. Sahin ◽  
Hassen M. Ouakad
Keyword(s):  
Wind Turbine ◽  
Pitch Angle ◽  
Numerical Study ◽  
Average Power ◽  
Vertical Axis ◽  
Power Coefficient ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Variable Pitch ◽  
De Algorithm

Abstract A double multiple streamtube model coupled with variable pitch methodology is used to analyze the performance characteristics of a small-scale straight-bladed Darrieus type vertical axis wind turbine (SB-VAWT). The numerical study revealed that a fixed pitch of −2.5 deg could greatly enhance the performance of the wind turbine. However, no improvement is observed in the starting torque capacity. Furthermore, the performance of upwind and downwind zones has been investigated, and it is found that the VAWT starting capacity is improved by increasing/decreasing the pitch angle upwind/downwind of the turbine. To optimize the performance, four cases of variable pitch angle schemes of sinusoidal nature were examined. The parameters of the sinusoidal functions were optimized using differential evolution (DE) algorithm with different cost functions. The results showed improvement in the power coefficient, yet with low starting capacity enhancement. Among the objective functions used in DE algorithm, the negative of the average power coefficient is found to lead to the best starting capacity with moderate peak power coefficient.

Numerical Study of Pitch Angle on H-Type Vertical Axis Wind Turbine

2012 ◽  
Vol 499 ◽  
pp. 259-264
Author(s):  
Qi Yao ◽  
Ying Xue Yao ◽  
Liang Zhou ◽  
S.Y. Zheng
Keyword(s):  
Wind Turbine ◽  
Pitch Angle ◽  
Numerical Study ◽  
Vertical Axis ◽  
Azimuth Angle ◽  
Power Coefficient ◽  
Cfd Model ◽  
Vertical Axis Wind Turbine ◽  
Sliding Mesh ◽  
Mesh Technique

This paper presents a simulation study of an H-type vertical axis wind turbine. Two dimensional CFD model using sliding mesh technique was generated to help understand aerodynamics performance of this wind turbine. The effect of the pith angle on H-type vertical axis wind turbine was studied based on the computational model. As a result, this wind turbine could get the maximum power coefficient when pitch angle adjusted to a suited angle, furthermore, the effects of pitch angle and azimuth angle on single blade were investigated. The results will provide theoretical supports on study of variable pitch of wind turbine.

Computational fluid dynamic analysis of roof-mounted vertical-axis wind turbine with diffuser shroud, flange, and vanes

2018 ◽  
Vol 42 (4) ◽  
pp. 404-415
Author(s):  
H. Abu-Thuraia ◽  
C. Aygun ◽  
M. Paraschivoiu ◽  
M.A. Allard
Keyword(s):  
Wind Turbine ◽  
Urban Areas ◽  
Guide Vane ◽  
Fluid Dynamic ◽  
Vertical Axis ◽  
Power Coefficient ◽  
Small Scale ◽  
Vertical Axis Wind Turbine ◽  
Guide Vanes ◽  
Turbine Design

Advances in wind power and tidal power have matured considerably to offer clean and sustainable energy alternatives. Nevertheless, distributed small-scale energy production from wind in urban areas has been disappointing because of very low efficiencies of the turbines. A novel wind turbine design — a seven-bladed Savonius vertical-axis wind turbine (VAWT) that is horizontally oriented inside a diffuser shroud and mounted on top of a building — has been shown to overcome the drawback of low efficiency. The objective this study was to analyze the performance of this novel wind turbine design for different wind directions and for different guide vanes placed at the entrance of the diffuser shroud. The flow field over the turbine and guide vanes was analyzed using computational fluid dynamics (CFD) on a 3D grid for multiple tip-speed ratios (TSRs). Four wind directions and three guide-vane angles were analyzed. The wind-direction analysis indicates that the power coefficient decreases to about half when the wind is oriented at 45° to the main axis of the turbine. The analysis of the guide vanes indicates a maximum power coefficient of 0.33 at a vane angle of 55°.

Sign in / Sign up

Export Citation Format

Share Document