scholarly journals Adsorption of Heavy Metal from Palm Oil Mill Effluent on the Mixed Media Used For the Preparation of Composite Adsorbent

2017 ◽  
Vol 103 ◽  
pp. 06020 ◽  
Author(s):  
Adeleke Abdulrahman Oyekanmi ◽  
Ab Aziz Abdul Latiff ◽  
Zawawi Daud ◽  
NurFalilah Mat Daud ◽  
Paran Gani
2014 ◽  
Vol 625 ◽  
pp. 822-825 ◽  
Author(s):  
Muhammad Afzaal ◽  
Balasubramanian Periyasamy ◽  
Mohd Azmuddin Abdullah

Packed bed column studies were carried out to evaluate the performance of naturalCeiba pentandra(L). Gaertn. (kapok) for the heavy metal removal from Palm Oil Mill Effluent (POME) under varying flow rate (5-10 ml/min) and packing density (0.04-0.08 g/cm3). A multilevel factorial design based on Packing density and flow rate of the influent was developed. Maximum metal reductions for Fe, Mn and Zn were 2.06 ppm, 0.081 ppm, and 0.064 ppm respectively obtained at 0.08 g/cm3packing density and 5 ml/min flow rate. The results suggest the suitability of raw kapok fiber for low-cost removal of heavy metals.


Membranes ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 566
Author(s):  
Ruwaida Abdul Wahid ◽  
Wei Lun Ang ◽  
Abdul Wahab Mohammad ◽  
Daniel James Johnson ◽  
Nidal Hilal

Fertilizer-drawn forward osmosis (FDFO) is a potential alternative to recover and reuse water and nutrients from agricultural wastewater, such as palm oil mill effluent that consists of 95% water and is rich in nutrients. This study investigated the potential of commercial fertilizers as draw solution (DS) in FDFO to treat anaerobic palm oil mill effluent (An-POME). The process parameters affecting FO were studied and optimized, which were then applied to fertilizer selection based on FO performance and fouling propensity. Six commonly used fertilizers were screened and assessed in terms of pure water flux (Jw) and reverse salt flux (JS). Ammonium sulfate ((NH4)2SO4), mono-ammonium phosphate (MAP), and potassium chloride (KCl) were further evaluated with An-POME. MAP showed the best performance against An-POME, with a high average water flux, low flux decline, the highest performance ratio (PR), and highest water recovery of 5.9% for a 4-h operation. In a 24-h fouling run, the average flux decline and water recovered were 84% and 15%, respectively. Both hydraulic flushing and osmotic backwashing cleaning were able to effectively restore the water flux. The results demonstrated that FDFO using commercial fertilizers has the potential for the treatment of An-POME for water recovery. Nevertheless, further investigation is needed to address challenges such as JS and the dilution factor of DS for direct use of fertigation.


Sign in / Sign up

Export Citation Format

Share Document