scholarly journals Preliminary Results of Numerical Simulation of Slug Flow in a Regular T-Junction

2018 ◽  
Vol 225 ◽  
pp. 03001
Author(s):  
Minh Tran ◽  
Zeeshan Memon ◽  
William Pao ◽  
Fakhruldin M Hashim
Keyword(s):  
Slug Flow ◽  
Two Phase Flow ◽  
Separation Efficiency ◽  
Flow Behavior ◽  
Three Dimensional ◽  
Piping System ◽  
Phase Flow ◽  
Two Phase ◽  
Ansys Fluent ◽  
System A

Excessive liquid carryover in T-junction due to splitting nature of two-phase flow causes serious issues in piping system. A three-dimensional numerical model is employed to investigate two-phase flow split behavior of slug flow in a circular-section regular T-junction with 0.0752 m diameter. The Volume of Fraction method combined with k-ε turbulence model and initial sinusoidal perturbation in ANSYS FLUENT is adopted to characterize the effect of slug flow behavior on the phase separation efficiency. The preliminary result reveals that the simulation work can study slug flow split in great detail and the slug characteristic plays an important role in understanding split behavior.

Numerical Simulation of the Transient Development of Slug Flow in Horizontal Pipes

2016 ◽  
Vol 819 ◽  
pp. 300-304 ◽  
Author(s):  
Zahid Ibrahim Al-Hashimy ◽  
Hussain H. Al-Kayiem ◽  
Mohammad Shakir Nasif ◽  
Abdalellah. O. Mohmmed
Keyword(s):  
Flow Regime ◽  
Slug Flow ◽  
Two Phase Flow ◽  
Piping System ◽  
Phase Flow ◽  
Two Phase ◽  
Horizontal Pipe ◽  
Horizontal Pipes ◽  
Flow Phenomena ◽  
Multi Phase Flow

Slug flow regime in two and multi-phase flow in pipes is a complicated flow phenomena representing challenge in the design of the piping system. In the present work, water/air two phase flow was modeled and simulated as 3 dimensional, transient, and incompressible flow using Volume of Fluid technique in STAR-CCM+ software. The simulation was conducted to predict and evaluate the air-water slug flow in a horizontal pipe with 0.16 m diameter and 7 m long. The superficial velocities for both phases were extracted from Baker chart slug zone. The results were validated against experimental bench marking referenced in Baker chart and the proposed VOF technique shows a good capability in simulating the development of the slug flow regime. This model could be utilized for simulation of various two phase flow regimes.

Eulerian-Eulerian Modeling of Disperse Two-Phase Flow in a Gas-Liquid Cylindrical Cyclone

2004 ◽  
Author(s):  
Miguel A. Reyes-Gutie´rrez ◽  
Luis R. Rojas-Solo´rzano ◽  
Jose´ Colmenares ◽  
Juan C. Mari´n-Moreno ◽  
Antonio J. Mele´ndez-Rami´rez
Keyword(s):  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Behavior ◽  
Three Dimensional ◽  
Momentum Equation ◽  
Surface Shape ◽  
Phase Flow ◽  
Atmospheric Conditions ◽  
Two Phase ◽  
Cylindrical Cyclone

This work presents a three-dimensional CFD study of a two-phase flow field in a Gas-Liquid Cylindrical Cyclone (GLCC) using CFX4.3™, a commercial code based on the finite volume method. The numerical analysis was made for air-water mixtures at near atmospheric conditions, while both liquid and gas flow rates were changed. The two-phase flow behavior is modeled using an Eulerian-Eulerian approach, considering both phases as an interpenetrating continuum. This method computed the inter-phase phenomena by including a source term in the momentum equation to consider the drag between the liquid and gas phases. The gas phase is modeled as a bimodal bubble size distribution to allow for the presence of free- and entrapment gas, simultaneously. The results (free surface shape and liquid angular velocity) show a reasonable match with experimental data. The CFD technique here proposed, demonstrates to satisfactorily reproduce angular velocities of the phases and their spatial distribution inside the GLCC. Computed results also proved to be useful in forecasting bubble and droplet trajectories, from which gas carry under (GCU) and liquid carry over (LCO) might be estimated. Nevertheless, moderate differences found between the computed GCU and experimental measurements, suggests that new adjustments may be done to the numerical model to improve its accuracy.

scholarly journals A Numerical study of Two-Phase flow through a Rectangular Duct with a Convergence Ribs

2018 ◽  
Vol 7 (4.19) ◽  
pp. 969
Author(s):  
Riyadh. S.Al-Turaihi ◽  
Abbas Sahi Shareef ◽  
Ali Abdalaimma
Keyword(s):  
Pressure Drop ◽  
Two Phase Flow ◽  
Numerical Study ◽  
Three Dimensional ◽  
Pressure Profile ◽  
Phase Flow ◽  
Three Dimensional Model ◽  
Test Channel ◽  
Two Phase ◽  
Ansys Fluent

Two-phase flow in ribbed convergent rectangular upward vertical duct was studied.Water and air were usedas materials for two-phase. Numerical studies have been performed to test the influence of increased air and water discharges on the pressure profile and pressure drop through the convergent section, as the effect of increasing the convergent angle on the pressure difference across the convergent section was studied.Water inlet discharges used were between (5-20 L/min), and air discharges were between (5.833-16.666 L/min). Two test channels with convergent angles (10 and 15 degrees) were used.Computational fluid dynamics for a three-dimensional model was simulated with ANSYS fluent 18 depending on the boundary condition and governed by equations of Eulerian multiphase flow model.The results indicated that the pressure along the test channel raises as water and air discharge rise. It was observedtoo the pressure drop increases with the increase of the convergence angle.  

Eulerian-Eulerian Modeling of Disperse Two-Phase Flow in a Gas-Liquid Cylindrical Cyclone

2005 ◽  
Vol 128 (4) ◽  
pp. 832-837 ◽  
Author(s):  
Miguel A. Reyes-Gutiérrez ◽  
Luis R. Rojas-Solórzano ◽  
Juan C. Marín-Moreno ◽  
Antonio J. Meléndez-Ramírez ◽  
José Colmenares
Keyword(s):  
Gas Flow ◽  
Two Phase Flow ◽  
Flow Behavior ◽  
Three Dimensional ◽  
Momentum Equation ◽  
Surface Shape ◽  
Phase Flow ◽  
Atmospheric Conditions ◽  
Two Phase ◽  
Cylindrical Cyclone

This work presents a three-dimensional computational fluid dynamics (CFD) study of a two-phase flow field in a gas-liquid cylindrical cyclone (GLCC) using CFX4.3™, a commercial code based on the finite volume method. The numerical analysis was made for air-water mixtures at near atmospheric conditions, while both liquid and gas flow rates were changed. The two-phase flow behavior is modeled using an Eulerian-Eulerian approach, considering both phases as an interpenetrating continuum. This method computed the inter-phase phenomena by including a source term in the momentum equation to consider the drag between the liquid and gas phases. The gas phase is modeled as a bimodal bubble size distribution to allow for the presence of free- and entrapment gas, simultaneously. The results (free surface shape and liquid angular velocity) show a reasonable match with experimental data. The CFD technique here proposed demonstrates to satisfactorily reproduce angular velocities of the phases and their spatial distribution inside the GLCC. Computed results also proved to be useful in forecasting bubble and droplet trajectories, from which gas carry under (GCU) and liquid carry over might be estimated. Nevertheless, moderate differences found between the computed GCU and experimental measurements suggest that new adjustments may be done to the numerical model to improve its accuracy.

On Instabilities in Horizontal Two-Phase Flow

1994 ◽  
Vol 59 (12) ◽  
pp. 2595-2603
Author(s):  
Lothar Ebner ◽  
Marie Fialová
Keyword(s):  
Differential Equation ◽  
Flow Regime ◽  
Slug Flow ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Annular Flows ◽  
Flow Regime Maps

Two regions of instabilities in horizontal two-phase flow were detected. The first was found in the transition from slug to annular flow, the second between stratified and slug flow. The existence of oscillations between the slug and annular flows can explain the differences in the limitation of the slug flow in flow regime maps proposed by different authors. Coexistence of these two regimes is similar to bistable behaviour of some differential equation solutions.

Upward Vertical Two-Phase Flow Through an Annulus—Part II: Modeling Bubble, Slug, and Annular Flow

1992 ◽  
Vol 114 (1) ◽  
pp. 14-30 ◽  
Author(s):  
E. F. Caetano ◽  
O. Shoham ◽  
J. P. Brill
Keyword(s):  
Flow Pattern ◽  
Annular Flow ◽  
Two Phase Flow ◽  
Flow Behavior ◽  
Bubble Flow ◽  
Phase Flow ◽  
Two Phase ◽  
Flow Through ◽  
Physical Phenomena ◽  
Good Agreement

Mechanistic models have been developed for each of the existing two-phase flow patterns in an annulus, namely bubble flow, dispersed bubble flow, slug flow, and annular flow. These models are based on two-phase flow physical phenomena and incorporate annulus characteristics such as casing and tubing diameters and degree of eccentricity. The models also apply the new predictive means for friction factor and Taylor bubble rise velocity presented in Part I. Given a set of flow conditions, the existing flow pattern in the system can be predicted. The developed models are applied next for predicting the flow behavior, including the average volumetric liquid holdup and the average total pressure gradient for the existing flow pattern. In general, good agreement was observed between the experimental data and model predictions.

A Combined Eulerian and Lagrangian Method for Prediction of Evaporating Sprays

2002 ◽  
Vol 124 (3) ◽  
pp. 481-488 ◽  
Author(s):  
M. Burger ◽  
G. Klose ◽  
G. Rottenkolber ◽  
R. Schmehl ◽  
D. Giebert ◽  
...  
Keyword(s):  
Two Phase Flow ◽  
Initial Conditions ◽  
Three Dimensional ◽  
Lagrangian Method ◽  
Phase Flow ◽  
Two Phase Flows ◽  
Two Phase ◽  
Lagrangian Methods ◽  
Eulerian Method ◽  
Lagrangian Modeling

Polydisperse sprays in complex three-dimensional flow systems are important in many technical applications. Numerical descriptions of sprays are used to achieve a fast and accurate prediction of complex two-phase flows. The Eulerian and Lagrangian methods are two essentially different approaches for the modeling of disperse two-phase flows. Both methods have been implemented into the same computational fluid dynamics package which is based on a three-dimensional body-fitted finite volume method. Considering sprays represented by a small number of droplet starting conditions, the Eulerian method is clearly superior in terms of computational efficiency. However, with respect to complex polydisperse sprays, the Lagrangian technique gives a higher accuracy. In addition, Lagrangian modeling of secondary effects such as spray-wall interaction enhances the physical description of the two-phase flow. Therefore, in the present approach the Eulerian and the Lagrangian methods have been combined in a hybrid method. The Eulerian method is used to determine a preliminary solution of the two-phase flow field. Subsequently, the Lagrangian method is employed to improve the accuracy of the first solution using detailed sets of initial conditions. Consequently, this combined approach improves the overall convergence behavior of the simulation. In the final section, the advantages of each method are discussed when predicting an evaporating spray in an intake manifold of an internal combustion engine.

scholarly journals Numerical Simulation and Analysis on Spray Drift Movement of Multirotor Plant Protection Unmanned Aerial Vehicle

Energies ◽  
2018 ◽  
Vol 11 (9) ◽  
pp. 2399 ◽  
Author(s):  
Fengbo Yang ◽  
Xinyu Xue ◽  
Chen Cai ◽  
Zhu Sun ◽  
Qingqing Zhou
Keyword(s):  
Fluid Dynamics ◽  
Computational Fluid Dynamics ◽  
Droplet Size ◽  
Wind Field ◽  
Flow Model ◽  
Two Phase Flow ◽  
Plant Protection ◽  
Three Dimensional ◽  
Phase Flow ◽  
Two Phase

In recent years, multirotor unmanned aerial vehicles (UAVs) have become more and more important in the field of plant protection in China. Multirotor unmanned plant protection UAVs have been widely used in vast plains, hills, mountains, and other regions, and become an integral part of China’s agricultural mechanization and modernization. The easy takeoff and landing performances of UAVs are urgently required for timely and effective spraying, especially in dispersed plots and hilly mountains. However, the unclearness of wind field distribution leads to more serious droplet drift problems. The drift and distribution of droplets, which depend on airflow distribution characteristics of UAVs and the droplet size of the nozzle, are directly related to the control effect of pesticide and crop growth in different growth periods. This paper proposes an approach to research the influence of the downwash and windward airflow on the motion distribution of droplet group for the SLK-5 six-rotor plant protection UAV. At first, based on the Navier-Stokes (N-S) equation and SST k–ε turbulence model, the three-dimensional wind field numerical model is established for a six-rotor plant protection UAV under 3 kg load condition. Droplet discrete phase is added to N-S equation, the momentum and energy equations are also corrected for continuous phase to establish a two-phase flow model, and a three-dimensional two-phase flow model is finally established for the six-rotor plant protection UAV. By comparing with the experiment, this paper verifies the feasibility and accuracy of a computational fluid dynamics (CFD) method in the calculation of wind field and spraying two-phase flow field. Analyses are carried out through the combination of computational fluid dynamics and radial basis neural network, and this paper, finally, discusses the influence of windward airflow and droplet size on the movement of droplet groups.

Sign in / Sign up

Export Citation Format

Share Document