Influence of the negative thermal‐expansion coefficient on the luminescence properties of (CdMnMg)Te

1996 ◽  
Vol 79 (11) ◽  
pp. 8704-8711 ◽  
Author(s):  
H. Schenk ◽  
M. Wolf ◽  
G. Mackh ◽  
U. Zehnder ◽  
W. Ossau ◽  
...  
Keyword(s):  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Negative Thermal Expansion ◽  
Luminescence Properties

Synthesis of ZrW2O8 Ceramics and Composites from Aqueous Sol-Gel Precursors

2006 ◽  
Vol 45 ◽  
pp. 218-222
Author(s):  
Klaartje de Buysser ◽  
Serge Hoste ◽  
Isabel Van Driessche
Keyword(s):  
Phase Transition ◽  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Sol Gel ◽  
Negative Thermal Expansion ◽  
Oxide Mixture ◽  
Stability Range ◽  
Cubic Symmetry ◽  
Geometrical Effect

The thermal expansion of a ceramic material in general leads to a positive thermal expansion coefficient (α). In the last decennium, several families of materials which exhibit negative thermal expansion, arising from a specific geometrical effect in their so-called open framework structures, have been discovered. Usually, this negative thermal expansion coefficient is small, anisotropic and the phenomena occur in a very small temperature interval. ZrW2O8 is an exception because of its large and isotropic negative thermal expansion coefficient (NTE) in a temperature range from 0.5K to 1050K. A cubic symmetry is found over the entire stability range with a phase transition from α-ZrW2O8 to β-ZrW2O8 near 430K. This phase transition is noticed by a change in α. The aqueous citrate-gel method is a suitable synthesis route for negative thermal expansion ceramics and will give a fine, pure and homogenous oxide mixture, well suitable for the preparation of ZrW2O8. The expansion coefficient of α–ZrW2O8 is -11 μm/m K whereas for the β- ZrW2O8 a value of -3 is obtained.

Effects of Heat-Treatment Temperature on the Properties of Negative CTE Eucryptite Ceramics

2010 ◽  
Vol 105-106 ◽  
pp. 123-125 ◽  
Author(s):  
Yong Li ◽  
Qi Hong Wei ◽  
Ling Li ◽  
Chong Hai Wang ◽  
Xiao Li Zhang ◽  
...  
Keyword(s):  
Heat Treatment ◽  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Heat Treatment Temperature ◽  
Bending Strength ◽  
Sol Gel ◽  
Negative Thermal Expansion ◽  
Treatment Temperature ◽  
Heat Treated

In this paper, negative thermal expansion coefficient eucryptite powders were prepared by sol-gel method using silica-sol as starting material. The raw blocks were obtained by dry pressing process after the powder was synthesized, and then the raw blocks were heat-treated at 600º, 1150º, 1280º, 1380º, 1420º and 1450°C, respectively. Variations of density, porosity and thermal expansion coefficient at different heat treatment temperatures were investigated. Phase transformation and fracture surface morphology of eucryptite heat-treated at different temperatures, respectively, were observed by XRD and SEM. The results indicate that, with the increasing heat- treatment temperature, the grain size and the bending strength increased, porosity decreased, thermal expansion coefficient decreased continuously. Negative thermal expansion coefficient of -5.3162×10-6~-7.4413×10-6 (0~800°C) was obtained. But when the heat-treatment temperature was more than 1420°C, porosity began to increase, bending strength began to decrease, which were the symbols of over-burning, while the main crystal phase didn’t change.

EPR Study of Gd3+local structure in ScF3crystal with negative thermal expansion coefficient

2015 ◽  
Vol 90 (11) ◽  
pp. 115801 ◽  
Author(s):  
A Antuzevics ◽  
U Rogulis ◽  
A Fedotovs ◽  
Dz Berzins ◽  
V N Voronov ◽  
...  
Keyword(s):  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Local Structure ◽  
Negative Thermal Expansion

Development of Porous Material with High Young’s Modulus and Low Thermal Expansion Coefficient in SiC-Vitrified Bonding Material-LiAlSiO4 System

2009 ◽  
Vol 620-622 ◽  
pp. 715-718 ◽  
Author(s):  
Tatsuya Ono ◽  
Koji Matsumaru ◽  
Isaías Juárez-Ramírez ◽  
Leticia M. Torres-Martínez ◽  
Kozo Ishizaki
Keyword(s):  
Thermal Expansion ◽  
Porous Material ◽  
Porous Materials ◽  
Young’S Modulus ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Large Scale ◽  
Young's Modulus ◽  
Negative Thermal Expansion ◽  
Low Thermal Expansion

Machines for manufacturing large scale flat displays are enlarging as the size of glasses increases. This work develops porous materials with a low thermal expansion coefficient and a high Young’s modulus. SiC and LiAlSiO4 were used for a positive and a negative thermal expansion materials, respectively. Compositions of powders for porous materials were determined to obtain a desirable Young’s modulus and thermal expansion coefficient by using SiC-VBM-LiAlSiO4 phase diagram at 20 % of porosity. The empirical values of Young’s modulus and a thermal expansion coefficient are close to the theoretical values by using the diagram. Fabricated porous material had high enough Young’s modulus of 87 GPa, and low enough thermal expansion coefficient of 2 x 10-6 K-1 at temperatures ranging from -17 °C to 190 °C with 22 % of porosity.

scholarly journals Structural and Thermal Unusual Properties in Invar Behavior of Ni-Mn Alloys

2020 ◽  
Vol 17 (2(SI)) ◽  
pp. 0629
Author(s):  
Salih Darweesh et al.
Keyword(s):  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Lattice Distortion ◽  
Negative Thermal Expansion ◽  
X Ray Diffraction ◽  
X Ray ◽  
Ferromagnetic Metals ◽  
Invar Effect

The Invar effect in 3D transition metal such as Ni and Mn, were prepared on a series composition of binary Ni1-xMnx system with x=0.3, 0.5, 0.8 by using powder metallurgy technique. In this work, the characterization of structural and thermal properties have been investigated experimentally by X-ray diffraction, thermal expansion coefficient and vibrating sample magnetometer (VSM) techniques. The results show that anonymously negative thermal expansion coefficient are changeable in the structure. The results were explained due to the instability relation between magnetic spins with lattice distortion on some of ferromagnetic metals.    

High Temperature Stability of Zirconium Tungstate

2020 ◽  
Vol 993 ◽  
pp. 771-775
Author(s):  
Ping Zhai ◽  
Xiao Feng Duan ◽  
Da Qian Chen
Keyword(s):  
Thermal Expansion ◽  
High Temperature ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Solid Phase ◽  
Coefficient Of Thermal Expansion ◽  
Negative Thermal Expansion ◽  
Tungstic Acid ◽  
High Temperature Stability ◽  
Zirconium Tungstate

In this paper, zirconium tungstate ceramic with negative thermal expansion coefficients was prepared from zirconium oxide and tungstic acid by solid phase synthesis and high temperature quenching technique with a sintering temperature of 1200 °C. The phase structure of the material was determined by X ray and the thermal expansion coefficient was measured by dilatometer, while the TG-DTA analysis of the prepared material was also carried out. The results showed that zirconium tungstate with high purity could be obtained by rapid chilled while fired at 1200 °C. The coefficient of thermal expansion at 300 °C was minus 8.5413 × 10-6K-1, which is identical with the theoretical value. The thermal expansion coefficient of the material was negative fired lower than 750 °C, while it was positive fired higher than 750 °C, and this indicates that the decomposition temperature of zirconium tungstate is about 750 °C.

scholarly journals Thermal expansion coefficient of few-layer MoS2 studied by temperature-dependent Raman spectroscopy

2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Zhongtao Lin ◽  
Wuguo Liu ◽  
Shibing Tian ◽  
Ke Zhu ◽  
Yuan Huang ◽  
...  
Keyword(s):  
Raman Spectroscopy ◽  
Thermal Expansion ◽  
Thermal Expansion Coefficient ◽  
Expansion Coefficient ◽  
Negative Thermal Expansion ◽  
Thermal Parameter ◽  
Temperature Dependent ◽  
Bending Vibrations ◽  
Thermal Expansion Coefficients ◽  
Expansion Coefficients

AbstractThe thermal expansion coefficient is an important thermal parameter that influences the performance of nanodevices based on two-dimensional materials. To obtain the thermal expansion coefficient of few-layer MoS2, suspended MoS2 and supported MoS2 were systematically investigated using Raman spectroscopy in the temperature range from 77 to 557 K. The temperature-dependent evolution of the Raman frequency shift for suspended MoS2 exhibited prominent differences from that for supported MoS2, obviously demonstrating the effect due to the thermal expansion coefficient mismatch between MoS2 and the substrate. The intrinsic thermal expansion coefficients of MoS2 with different numbers of layers were calculated. Interestingly, negative thermal expansion coefficients were obtained below 175 K, which was attributed to the bending vibrations in the MoS2 layer during cooling. Our results demonstrate that Raman spectroscopy is a feasible tool for investigating the thermal properties of few-layer MoS2 and will provide useful information for its further application in photoelectronic devices.

Sign in / Sign up

Export Citation Format

Share Document