Comparative Experimental Analysis on Dual Fuel with Biodiesel -Acetylene in Reactivity Controlled Compression Ignition Engine

In the current work, an effort is made to study the influence of injection timing (IT) and injection duration (ID) of manifold injected fuels (MIF) in the reactivity controlled compression ignition (RCCI) engine. Compressed natural gas (CNG) and compressed biogas (CBG) are used as the MIF along with diesel and blends of Thevetia Peruviana methyl ester (TPME) are used as the direct injected fuels (DIF). The ITs of the MIF that were studied includes 45°ATDC, 50°ATDC, and 55°ATDC. Also, present study includes impact of various IDs of the MIF such as 3, 6, and 9 ms on RCCI mode of combustion. The complete experimental work is conducted at 75% of rated power. The results show that among the different ITs studied, the D+CNG mixture exhibits higher brake thermal efficiency (BTE), about 29.32% is observed at 50° ATDC IT, which is about 1.77, 3.58, 5.56, 7.51, and 8.54% higher than D+CBG, B20+CNG, B20+CBG, B100+CNG, and B100+CBG fuel combinations. The highest BTE, about 30.25%, is found for the D+CNG fuel combination at 6 ms ID, which is about 1.69, 3.48, 5.32%, 7.24, and 9.16% higher as compared with the D+CBG, B20+CNG, B20+CBG, B100+CNG, and B100+CBG fuel combinations. At all ITs and IDs, higher emissions of nitric oxide (NOx) along with lower emissions of smoke, carbon monoxide (CO), and hydrocarbon (HC) are found for D+CNG mixture as related to other fuel mixtures. At all ITs and IDs, D+CNG gives higher In-cylinder pressure (ICP) and heat release rate (HRR) as compared with other fuel combinations.

Download Full-text

Mapping the combustion modes of a dual-fuel compression ignition engine

International Journal of Engine Research ◽

10.1177/14680874211018376 ◽

2021 ◽

pp. 146808742110183

Author(s):

Jonathan Martin ◽

André Boehman

Keyword(s):

Direct Injection ◽

Fuel Combustion ◽

Dual Fuel ◽

Compression Ignition ◽

Compression Ignition Engine ◽

Combustion Modes ◽

Si Engines ◽

Dual Fuel Combustion ◽

Soot Emissions ◽

Ci Engines

Compression-ignition (CI) engines can produce higher thermal efficiency (TE) and thus lower carbon dioxide (CO2) emissions than spark-ignition (SI) engines. Unfortunately, the overall fuel economy of CI engine vehicles is limited by their emissions of nitrogen oxides (NOx) and soot, which must be mitigated with costly, resource- and energy-intensive aftertreatment. NOx and soot could also be mitigated by adding premixed gasoline to complement the conventional, non-premixed direct injection (DI) of diesel fuel in CI engines. Several such “dual-fuel” combustion modes have been introduced in recent years, but these modes are usually studied individually at discrete conditions. This paper introduces a mapping system for dual-fuel CI modes that links together several previously studied modes across a continuous two-dimensional diagram. This system includes the conventional diesel combustion (CDC) and conventional dual-fuel (CDF) modes; the well-explored advanced combustion modes of HCCI, RCCI, PCCI, and PPCI; and a previously discovered but relatively unexplored combustion mode that is herein titled “Piston-split Dual-Fuel Combustion” or PDFC. Tests show that dual-fuel CI engines can simultaneously increase TE and lower NOx and/or soot emissions at high loads through the use of Partial HCCI (PHCCI). At low loads, PHCCI is not possible, but either PDFC or RCCI can be used to further improve NOx and/or soot emissions, albeit at slightly lower TE. These results lead to a “partial dual-fuel” multi-mode strategy of PHCCI at high loads and CDC at low loads, linked together by PDFC. Drive cycle simulations show that this strategy, when tuned to balance NOx and soot reductions, can reduce engine-out CO2 emissions by about 1% while reducing NOx and soot by about 20% each with respect to CDC. This increases emissions of unburnt hydrocarbons (UHC), still in a treatable range (2.0 g/kWh) but five times as high as CDC, requiring changes in aftertreatment strategy.

Download Full-text

IMPACT OF OPERATING PARAMETERS ON ENERGY EFFICIENCY AND REGULATED EMISSIONS OF DUAL FUEL DIRECT INJECTED REACTIVITY-CONTROLLED COMPRESSION-IGNITION COMBUSTION

Energy Sources Part A Recovery Utilization and Environmental Effects ◽

10.1080/15567036.2021.1919791 ◽

2021 ◽

pp. 1-22

Author(s):

Murugan Rangasamy ◽

Parthasarthi Kesavan ◽

Yogesh Vaidhiyanathan ◽

Ganesh Duraisamy ◽

Charles Augustin V

Keyword(s):

Energy Efficiency ◽

Dual Fuel ◽

Operating Parameters ◽

Compression Ignition ◽

Reactivity Controlled Compression Ignition ◽

Compression Ignition Combustion

Download Full-text

Complete Vegetable Oil Fueled Dual Fuel Compression Ignition Engine

10.4271/2001-28-0067 ◽

2001 ◽

Cited By ~ 27

Author(s):

M. Senthil Kumar ◽

A. Ramesh ◽

B. Nagalingam

Keyword(s):

Vegetable Oil ◽

Dual Fuel ◽

Compression Ignition ◽

Compression Ignition Engine

Download Full-text

Generator gas as a fuel to power a diesel engine

Thermal Science ◽

10.2298/tsci130228063t ◽

2014 ◽

Vol 18 (1) ◽

pp. 205-216 ◽

Cited By ~ 17

Author(s):

Wojciech Tutak ◽

Arkadiusz Jamrozik

Keyword(s):

Sewage Sludge ◽

Liquid Fuel ◽

Treatment Plant ◽

Calorific Value ◽

Dual Fuel ◽

Compression Ignition ◽

Compression Ignition Engine ◽

Additional Advantage ◽

Electric Generator ◽

Generator Gas

The results of gasification process of dried sewage sludge and use of generator gas as a fuel for dual fuel turbocharged compression ignition engine are presented. The results of gasifying showed that during gasification of sewage sludge is possible to obtain generator gas of a calorific value in the range of 2.15 ? 2.59 MJ/m3. It turned out that the generator gas can be effectively used as a fuel to the compression ignition engine. Because of gas composition, it was possible to run engine with partload conditions. In dual fuel operation the high value of indicated efficiency was achieved equal to 35%, so better than the efficiency of 30% attainable when being fed with 100% liquid fuel. The dual fuel engine version developed within the project can be recommended to be used in practice in a dried sewage sludge gasification plant as a dual fuel engine driving the electric generator loaded with the active electric power limited to 40 kW (which accounts for approx. 50% of its rated power), because it is at this power that the optimal conditions of operation of an engine dual fuel powered by liquid fuel and generator gas are achieved. An additional advantage is the utilization of waste generated in the wastewater treatment plant.

Download Full-text