An x-ray diffraction and EXAFS study of the electric-field-induced ferroelectric phase

1996 ◽  
Vol 8 (11) ◽  
pp. 1615-1620 ◽  
Author(s):  
V A Shuvaeva ◽  
M Yu Antipin ◽  
O E Fesenko ◽  
Yu T Struchkov
2000 ◽  
Vol 655 ◽  
Author(s):  
Matt Poulsen ◽  
S. Adenwalla ◽  
Stephen Ducharme ◽  
V.M. Fridkin ◽  
S.P. Palto ◽  
...  

AbstractX-ray diffraction was used to probe the structural changes associated with the conversion of the paraelectric phase to the ferroelectric phase that results from the application of a large external electric field. The samples under study are ultrathin (150 to 250 Å) Langmuir-Blodgett films of the copolymer vinylidene fluoride (70%) with trifluoroethylene (30%) deposited on aluminum-coated silicon. Theta-2theta X-ray diffraction was used to measure the change in inter-layer spacing perpendicular to the film surface. Upon heating at zero external electric field, the crystalline films undergo a structural phase transition, at 100± 5°C, from the all-trans ferroelectric phase to the trans-gauche paraelectric phase. [1,2] Above the phase transition temperature, the non-polar paraelectric phase can be converted back to the polar ferroelectric phase, in a smooth continuous process, using a large external electric field (∼1 GV/m). For example, at 100° C the ferroelectric phase first appears above 0.2 GV/m and increases steadily in proportion while the paraelectric phase decreases until complete conversion to the ferroelectric phase is achieved at approximately 0.6 GV/m.


2000 ◽  
Vol 658 ◽  
Author(s):  
G. Arunmozhi ◽  
E. Nogueira ◽  
E.de Matos Gomes ◽  
S. Lanceros-Mendez ◽  
M. Margarida ◽  
...  

ABSTRACTFerroelectric triglycine sulphate crystals have been grown under the influence of an intense electric field of 6×104 V/m. Relative to crystals grown under ambient conditions (TGS) the crystals grown under the electric field (TGS-E) display a dielectric permittivity a factor of two lower. Significant differences are observed in the Curie-Weiss behavior of the ferroelectric phase, in the x-ray diffraction patterns and in the differential calorimetry measurements.


2010 ◽  
Vol 43 (2) ◽  
pp. 227-236 ◽  
Author(s):  
Leandro M. Acuña ◽  
Diego G. Lamas ◽  
Rodolfo O. Fuentes ◽  
Ismael O. Fábregas ◽  
Márcia C. A. Fantini ◽  
...  

The local atomic structures around the Zr atom of pure (undoped) ZrO2nanopowders with different average crystallite sizes, ranging from 7 to 40 nm, have been investigated. The nanopowders were synthesized by different wet-chemical routes, but all exhibit the high-temperature tetragonal phase stabilized at room temperature, as established by synchrotron radiation X-ray diffraction. The extended X-ray absorption fine structure (EXAFS) technique was applied to analyze the local structure around the Zr atoms. Several authors have studied this system using the EXAFS technique without obtaining a good agreement between crystallographic and EXAFS data. In this work, it is shown that the local structure of ZrO2nanopowders can be described by a model consisting of two oxygen subshells (4 + 4 atoms) with different Zr—O distances, in agreement with those independently determined by X-ray diffraction. However, the EXAFS study shows that the second oxygen subshell exhibits a Debye–Waller (DW) parameter much higher than that of the first oxygen subshell, a result that cannot be explained by the crystallographic model accepted for the tetragonal phase of zirconia-based materials. However, as proposed by other authors, the difference in the DW parameters between the two oxygen subshells around the Zr atoms can be explained by the existence of oxygen displacements perpendicular to thezdirection; these mainly affect the second oxygen subshell because of the directional character of the EXAFS DW parameter, in contradiction to the crystallographic value. It is also established that this model is similar to another model having three oxygen subshells, with a 4 + 2 + 2 distribution of atoms, with only one DW parameter for all oxygen subshells. Both models are in good agreement with the crystal structure determined by X-ray diffraction experiments.


2021 ◽  
Vol 118 (13) ◽  
pp. 132903
Author(s):  
Mao-Hua Zhang ◽  
Changhao Zhao ◽  
Lovro Fulanović ◽  
Jürgen Rödel ◽  
Nikola Novak ◽  
...  

2017 ◽  
Vol 111 (8) ◽  
pp. 082907 ◽  
Author(s):  
Seiji Nakashima ◽  
Osami Sakata ◽  
Hiroshi Funakubo ◽  
Takao Shimizu ◽  
Daichi Ichinose ◽  
...  

2021 ◽  
Vol 54 (3) ◽  
Author(s):  
Semën Gorfman ◽  
David Spirito ◽  
Netanela Cohen ◽  
Peter Siffalovic ◽  
Peter Nadazdy ◽  
...  

Laboratory X-ray diffractometers play a crucial role in X-ray crystallography and materials science. Such instruments still vastly outnumber synchrotron facilities and are responsible for most of the X-ray characterization of materials around the world. The efforts to enhance the design and performance of in-house X-ray diffraction instruments benefit a broad research community. Here, the realization of a custom-built multipurpose four-circle diffractometer in the laboratory for X-ray crystallography of functional materials at Tel Aviv University, Israel, is reported. The instrument is equipped with a microfocus Cu-based X-ray source, collimating X-ray optics, four-bounce monochromator, four-circle goniometer, large (PILATUS3 R 1M) pixel area detector, analyser crystal and scintillating counter. It is suitable for a broad range of tasks in X-ray crystallography/structure analysis and materials science. All the relevant X-ray beam parameters (total flux, flux density, beam divergence, monochromaticity) are reported and several applications such as determination of the crystal orientation matrix and high-resolution reciprocal-space mapping are demonstrated. The diffractometer is suitable for measuring X-ray diffraction in situ under an external electric field, as demonstrated by the measurement of electric-field-dependent rocking curves of a quartz single crystal. The diffractometer can be used as an independent research instrument, but also as a training platform and for preparation for synchrotron experiments.


Sign in / Sign up

Export Citation Format

Share Document