Polarization-independent reflection grating in second-order Littrow for high laser resolving power

Laser Physics ◽  
2020 ◽  
Vol 30 (11) ◽  
pp. 116201
Author(s):  
Jimin Fang ◽  
Bo Wang
1959 ◽  
Vol 14 (9) ◽  
pp. 822-827 ◽  
Author(s):  
H. A. Tasman ◽  
A. J. H. Boerboom ◽  
H. Wachsmuth

In previous papers 1.2we presented the radial second order imaging properties of inhomogeneous magnetic sector fields with normal incidence and exit at plane boundaries. These fields may provide very high mass resolving power and mass dispersion without increase in radius or decrease of slit widths. In the present paper the calculations are extended to include the effect of oblique incidence and exit at curved boundaries. The influence of the fringing fields on axial focusing when the boundaries are oblique, is accounted for. It is shown that the second order angular aberration may Le eliminated by appropriate curvature of the boundaries.


2021 ◽  
Vol 27 (1) ◽  
pp. 3-12
Author(s):  
Bjoern Raupers ◽  
Hana Medhat ◽  
Juergen Grotemeyer ◽  
Frank Gunzer

Ion traps like the Orbitrap are well known mass analyzers with very high resolving power. This resolving power is achieved with help of ions orbiting around an inner electrode for long time, in general up to a few seconds, since the mass signal is obtained by calculating the Fourier Transform of the induced signal caused by the ion motion. A similar principle is applied in the Cassinian Ion Trap of second order, where the ions move in a periodic pattern in-between two inner electrodes. The Cassinian ion trap has the potential to offer mass resolving power comparable to the Orbitrap with advantages regarding the experimental implementation. In this paper we have investigated the details of the ion motion analyzing experimental data and the results of different numerical methods, with focus on increasing the resolving power by increasing the oscillation frequency for ions in a high field ion trap. In this context the influence of the trap door, a tunnel through which the ions are injected into the trap, on the ion velocity becomes especially important.


2006 ◽  
Vol 260 (2) ◽  
pp. 567-570 ◽  
Author(s):  
Fufei Pang ◽  
Feng Liu ◽  
Xiuyou Han ◽  
Haiwen Cai ◽  
Ronghui Qu ◽  
...  

In a previous paper (Nevin 1938)*, the author has given an analysis of the (0, 1) λ 6438, (0, 0) λ 6026, and (1, 0) λ 5632 bands of the first negative band spectrum of oxygen and has shown that the system is due to a transition 4 ∑ - g → 4 Π u . The present paper contains an analysis of the (0, 2) λ 6856 and (2, 0) λ 5295 bands. Using the method described in (I) to excite the spectrum, a discharge through helium containing a small amount of oxygen, the plates of the band λ 6856 taken in the second order of the grating could be measured only as far as λ 6720 on account of the large number of ghosts and the blackening produced below this point by the enormously over-exposed helium line λ 6678. To photograph the remainder of the band it was necessary to use a hollow cathode discharge through commercial oxygen as described by Frerichs (1926). This source is considerably less intense than the discharge through helium the exposures with which, in the case of the present band, were between 12 and 18 hr. with Ilford Astra III plates. To reduce the exposures to a reasonable time a cylindrical lens made by Hilger, 15 cm. long and 5 cm. wide with a focal length of 30 cm., was mounted at right angles to the axis of the spectrograph between the grating and the plate as described by Oldenberg (1932). The lens was mounted so that its axis could be adjusted exactly perpendicular to the slit and the grating rulings, a point of the highest importance if the definition is not to be impaired. As far as could be judged there was no loss of resolving power over the length of plate covered by the lens. Satisfactory exposures of a range of 180A were obtained in about 6 hr. with the hollow cathode discharge taking a current of 0.8 amp. The plates were measured with respect to third order iron standards. The λ 5295 band had already been photographed in the second order at the same time as the bands analysed in (I). However, to complete the analysis it was found necessary to take a third order plate, and to save time the arrangement described above was used, the entire band being obtained on a single plate with an exposure of 5 hr. The resolving power attained on this plate with sharp lines was about 200,000. The theoretical resolving power of the grating in this order is 250,000, so the reduction caused by the lens must have been very small. * Referred to as (I) throughout this paper.


2016 ◽  
Vol 30 (16) ◽  
pp. 1650195
Author(s):  
Wenhao Shu ◽  
Bo Wang ◽  
Hao Pei ◽  
Hongtao Li ◽  
Li Chen ◽  
...  

A new structure of microstructure reflection three-port beam splitter grating is described in this paper. The grating includes two dielectric layers and a metal slab on the substrate, where incident waves are reflected into the zeroth-order and the ± first-order with polarization-independent property. With the optimized grating profile, reflection efficiencies’ ratios between the first-order and the zeroth-order can reach 0.998 and 1.001 for TE and TM polarizations, respectively. Especially, the reflection grating can diffract efficiencies more than 30% into the ± first-order and the zeroth-order with the incident angular bandwidth of −1.9–1.9[Formula: see text] for TM polarization, which can have merits compared with single-layer transmission grating.


1959 ◽  
Vol 14 (9) ◽  
pp. 818-822 ◽  
Author(s):  
H. Wachsmuth ◽  
A. J. H. Boerboom ◽  
H. A. Tasman

In a previous article 1 we pointed out the possible advantages of inhomogeneous magnetic sector fields for mass spectrometers, as these fields permit a substantial increase in mass dispersion and resolving power without change in radius or slit widths. In the said paper 1 we calculated the coefficients of the second order aberrations in the median plane, as well as the field shape required to eliminate the second order angular aberration in the median plane. In the present paper we calculate the second order aberrations outside the median plane referring to focusing in the radial direction. Again the influence of fringing fields is being neglected, and the field boundaries are supposed to be plane and normal to the main path at the point where it enters and leaves the field.


2006 ◽  
Author(s):  
Yong Wook Lee ◽  
Hyun-Tak Kim ◽  
Bong-Jun Kim ◽  
Byung-Gyu Chae ◽  
Sungyoul Choi ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document