Wind tunnel testing of wind turbines can provide valuable insights into wind turbine performance and provides a simple process to test and improve existing designs. However, the scale of most wind turbines is significantly larger than most existing wind tunnels, thus, the scaling required for testing in a typical wind tunnel presents multiple challenges. When wind turbines are scaled, often only geometric similarity and tip speed ratio matching are employed. Scaling in this manner can result in impractical rotational velocities. For wind tunnel tests that involve Reynolds numbers less than approximately 500,000, Reynolds number matching is necessary. When including Reynolds number matching in the scaling process, keeping rotational velocities realistic becomes even more challenging and preventing impractical freestream velocities becomes difficult. Turbine models of 0.5, 0.4, and 0.3 m diameter, resulting in wind tunnel blockages up to 52.8%, were tested in order to demonstrate scaling using Reynolds number matching and to validate blockage corrections found in the literature. Reynolds numbers over the blades ranged from 20,000 to 150,000 and the tip speed ratio ranged from 3 to 4 at the maximum power point for each wind speed tested.
Experimental wind tunnel testing of linear individual pitch control for two-bladed wind turbines
