scholarly journals Study on the Crop Irrigation Water Requirement Based on Cropwat in Jinghuiqu Irrigation Area

Author(s):  
Qiguang Dong
2019 ◽  
Vol 10 (2) ◽  
pp. 61-68
Author(s):  
Hanan Shalsabillah ◽  
Khairul Amri ◽  
Gusta Gunawan

The Irrigation Area of Air Nipis is located in Regency of South Bengkulu at Bengkulu Province with irrigation area 3.116 Ha. Planning and management of irrigation systems is one of the important steps to determine the irrigation water requirement as a whole. The purpose of this research is aim to analyze the water requirement to get value prediction of minimum and maximum irrigation water requirement in irrigation area of Air Nipis using the CROPWAT Version 8.0 method. Irrigation water requirements obtained from CROPWAT Version 8.0 are based on climate data, soil data and plants.The parameters that were reference plant evapotranspiration, effective rainfall, soil treatment, soil data, and plants. The results of the research showed that the maximum irrigation requirement for calculation using CROPWAT 8.0 software occurred in the first 10 days of December (14,49 m3/sec), while the minimum irrigation water requirements for CROPWAT 8.0 occurs in mid to end March (0,04 m3/sec).


2019 ◽  
Vol 8 (4) ◽  
pp. 2859-2866

The rapid increase of desertification’s degradation is one of the worst environmental and economic threats for dry areas. Climate changes, very year impacts thousands of areas across the globe. The high cost of electricity and diesel-based fuel affects photovoltaic water pumping requirements for irrigation in many parts of the world. Solar irradiance in every dry place is extremely high due the drought increase. Thus, using solar energy for water pumping is a promising alternative sources of energy. Undertaking irrigation for a particular place and crop requires not only skills in the irrigation planning but also in the power requirement of the entire system. A reliable and accurate estimation of ET rate and irrigation water requirement (IWR) are soundly important in irrigation field. This sought to accurately estimate the irrigation power requirement by using PVsyst software on nine different pumps technologies combinations with different type of converters at 100m, 150m, 180m, and 200m of Total dynamic Head (TDH). The study has been conducted in four sections, the first section dealt with the assessment of the collected data, the second section with the simulations, the third one with the irrigation water requirement and finally irrigation water requirement. The results found in study show that IPR of a crop is majorly depend on the TDH. Among the nine combinations, results show that the Maximum Power Point Tracking (MPPT) technology is the best in terms of power requirement of selected the crop. Furthermore, the maximum and minimum values of the irrigation water requirement for millet crop was found to be 12.9 mm/day and 4.9mm/day respectively.


2020 ◽  
Vol 4 (4) ◽  
pp. 412-421
Author(s):  
Mahendra Rizqi ◽  
Muhammad Yasar Yasar ◽  
Dewi Sri Jayanti

Abstrak. Salah satu usaha peningkatan produksi pangan khususnya padi adalah tersedianya air irigasi di areal sawah sesuai dengan kebutuhan. Kebutuhan air yang diperlukan  pada areal irigasi besarnya bervariasi sesuai keadaan untuk memenuhi kebutuhan evapotranspirasi, kehilangan air, kebutuhan air untuk tanaman dengan memperhatikan jumlah air yang diberikan oleh alam melalui hujan dan kontribusi air tanah. Pengaplikasian CROPWAT 8.0 ini sangat membantu dalam pengelolaan data sehingga menghasilkan data yang dapat digunakan. Tujuan penelitian ini adalah untuk menghitung kebutuhan air irigasi pada Daerah Irigasi Krueng Jreu dengan menggunakan software CROPWAT 8.0. Metode penelitian adalah menentukan parameter, pengumpulan data dan pengolahan data.  Data yang digunakan dalam penelitian ini adalah data luas areal yang dialiri, data-data untuk menghitung evapotranspirasi meliputi temperatur, kelembaban relatif, kecepatan angin, lama penyinaran matahari, curah hujan, pola dan jadwal tanam yang dianjurkan di daerah penelitian. Hasil penelitian yang telah dilakukan diperoleh  Nilai evapotranspirasi potensial (ET0)  rata-rata  di Daerah Irigasi Krueng Jreu adalah sebesar 3,75 mm/hari, curah hujan efektif (Re) rata-rata di Daerah Irigasi Krueng Jreu adalah sebesar 3,09 mm/hari, kebutuhan air untuk penyiapan lahan adalah sebesar 11,35 mm/hari untuk Bulan November dan sebesar 11,71 mm/hari untuk Bulan Mei, kebutuhan bersih air di sawah (NFR) untuk padi rendeng dan padi gadu yaitu sebesar  11,22 mm/hari dan 25,34 mm/hari, dan kebutuhan air pada pintu pengambilan (DR) untuk padi rendeng dan padi gadu yaitu sebesar 17,27 mm/hari dan 38,98 mm/hari. Kebutuhan air irigasi di Darah Irigasi Krueng Jreu dengan total luas area sebesar 3.287 ha dengan kebutuhan air irigasi pola tanam padi-padi yang dimulai awal pengolahan lahan pada awal Bulan November maka didapatkan kebutuhan air irigasi maksimal yaitu terjadi pada Bulan Juli dengan perhitungan CROPWAT yaitu sebesar 14,9 m3/detik dan untuk perhitungan manual yaitu sebesar 6,26 m3/detik. Kebutuhan air irigasi minimum yaitu terjadi pada Bulan Desember dengan perhitungan CROPWAT yaitu sebesar 0,00 m3/detik dan perhitungan manual yaitu sebesar 0,45 m3/detik.Analysis of Irrigation Water Requirement Using CROPWAT 8.0 in Krueng Jreu Irrigation Area  of Aceh Besar RegencyAbstract. One of the efforts to increase food production, especially rice, is the availability of irrigation water in paddy fields according to their needs. The required water needs in the area of irrigation varies according the State needs for evapotranspiration, water loss, water needs for plants with attention to the amount of water given by nature through the rain and the contribution of groundwater. The application of  Cropwat 8.0 is very helpful in managing data so as to produce data that can be used. The purpose of this study was to calculate irrigation water requirements in the Krueng Jreu Irrigation Area using Cropwat 8.0 software. The research method is determining parameters, data collection and data processing. The data used in this study is the data area that is flowed, the data for calculating evapotranspiration include: temperature, relative humidity, wind speed, duration of solar radiation, rainfall, patterns, and planting schedules recommended in the study area. Based on the results of the research that has been carried out, it can be concluded as follows: the average evapotranspiration value (ET0) in the Krueng Jreu Irrigation Area is 3,75 mm/day, the effective rainfall (Re) in the Krueng Jreu Irrigation Area is amounting to 3,09 mm/day, water requirements for land preparation of 11,35 mm/day in November and 11,71 mm/day in Mei, clean water requirements in rice fields (NFR) for rendeng rice and gadu rice which amounted to 11,22 mm/day and 25,34 mm/day, and water requirements on the retrieval gate (DR) for rendeng rice and gadu rice were equal to 17,27 mm/day and 38,98 mm/day. Irrigation water needs in Krueng Jreu Irrigation Blood with a total area of 3.287 ha with irrigation water requirements for rice-paddy cropping patterns that were started at the beginning of land processing at the beginning of November the maximum irrigation water needs were obtained in July with  Cropwat calculations that is equal to 14,9 m3/second and for manual calculations amounting to 6,26 m3/sec. For minimum irrigation water needs, that occurs in December with a Cropwat calculation is 0,00 m3/second and manual calculation of 0,45 m3/sec.


2020 ◽  
Vol 8 (5) ◽  
pp. 1060-1068
Author(s):  
Santhosh UN ◽  
Desai BK ◽  
Satyanarayana Rao ◽  
Masthana Reddy BG ◽  
Vinay Krishnamurthy ◽  
...  

1985 ◽  
pp. 755-765
Author(s):  
Shie-Yui Liong ◽  
Ongko Sutjahyo ◽  
Bernard Rasli

2019 ◽  
Author(s):  
MAYA AMALIA ACHYADI ◽  
KOICHIRO OHGUSHI ◽  
TOSHIHIRO MORITA ◽  
SU WAI THIN ◽  
WATARU KAWAHARA

Sign in / Sign up

Export Citation Format

Share Document