A Novel Design of Automatic Tracking and Maximum Power output Device for Silicon Photocell Array

Author(s):  
Ahmed Abdalah yusuf ◽  
Lingqin Yi ◽  
Xiang Si ◽  
Ning Yang
2004 ◽  
Vol 96 (4) ◽  
pp. 1277-1284 ◽  
Author(s):  
Roy L. P. G. Jentjens ◽  
Luke Moseley ◽  
Rosemary H. Waring ◽  
Leslie K. Harding ◽  
Asker E. Jeukendrup

The purpose of the present study was to examine whether combined ingestion of a large amount of fructose and glucose during cycling exercise would lead to exogenous carbohydrate oxidation rates >1 g/min. Eight trained cyclists (maximal O2consumption: 62 ± 3 ml·kg-1·min-1) performed four exercise trials in random order. Each trial consisted of 120 min of cycling at 50% maximum power output (63 ± 2% maximal O2consumption), while subjects received a solution providing either 1.2 g/min of glucose (Med-Glu), 1.8 g/min of glucose (High-Glu), 0.6 g/min of fructose + 1.2 g/min of glucose (Fruc+Glu), or water. The ingested fructose was labeled with [U-13C]fructose, and the ingested glucose was labeled with [U-14C]glucose. Peak exogenous carbohydrate oxidation rates were ∼55% higher ( P < 0.001) in Fruc+Glu (1.26 ± 0.07 g/min) compared with Med-Glu and High-Glu (0.80 ± 0.04 and 0.83 ± 0.05 g/min, respectively). Furthermore, the average exogenous carbohydrate oxidation rates over the 60- to 120-min exercise period were higher ( P < 0.001) in Fruc+Glu compared with Med-Glu and High-Glu (1.16 ± 0.06, 0.75 ± 0.04, and 0.75 ± 0.04 g/min, respectively). There was a trend toward a lower endogenous carbohydrate oxidation in Fruc+Glu compared with the other two carbohydrate trials, but this failed to reach statistical significance ( P = 0.075). The present results demonstrate that, when fructose and glucose are ingested simultaneously at high rates during cycling exercise, exogenous carbohydrate oxidation rates can reach peak values of ∼1.3 g/min.


1992 ◽  
Vol 170 (1) ◽  
pp. 143-154 ◽  
Author(s):  
M. ELIZABETH ANDERSON ◽  
IAN A. JOHNSTON

Fast muscle fibres were isolated from abdominal myotomes of Atlantic cod (Gadus morhua L.) ranging in size from 10 to 63 cm standard length (Ls). Muscle fibres were subjected to sinusoidal length changes about their resting length (Lf) and stimulated at a selected phase of the strain cycle. The work performed in each oscillatory cycle was calculated from plots of force against muscle length, the area of the resulting loop being net work. Strain and the number and timing of stimuli were adjusted to maximise positive work per cycle over a range of cycle frequencies at 8°C. Force, and hence power output, declined with increasing cycles of oscillation until reaching a steady state around the ninth cycle. The strain required for maximum power output (Wmax) was ±7-11% of Lf in fish shorter than 18 cm standard length, but decreased to ±5 % of Lf in larger fish. The cycle frequency required for Wmax also declined with increasing fish length, scaling to Ls−0.51 under steady-state conditions (cycles 9–12). At the optimum cycle frequency and strain the maximum contraction velocity scaled to Ls−0.79. The maximum stress (Pmax) produced within a cycle was highest in the second cycle, ranging from 51.3 kPa in 10 cm fish to 81.8 kPa in 60 cm fish (Pmax=28.2Ls0.25). Under steady-state conditions the maximum power output per kilogram wet muscle mass was found to range from 27.5 W in a 10 cm Ls cod to 16.4 W in a 60 cm Ls cod, scaling with Ls−0.29 and body mass (Mb)−0.10 Note: To whom reprint requests should be sent


2011 ◽  
Vol 110-116 ◽  
pp. 273-277
Author(s):  
Rahim Ebrahim ◽  
Mahmoud Reza Tadayon ◽  
Farshad Tahmasebi Gandomkari ◽  
Kamyar Mahbobian

Today, the world community is looking for fuel efficient and environmentally viable alternatives for many of the traditional energy conversion approaches. This development has further worked to increase the technical focus on conventional cycles for making them more optimum in terms of performance. Hence, the objective of this paper is to study the effect of ethanol-air equivalence ratio on the power output and the indicated thermal efficiency of an air standard Otto cycle. Optimization of the cycle has been performed for power output as well as for thermal efficiency with respect to compression ratio. The results show that the maximum power output, the optimal compression ratio corresponding to maximum power output point, the optimal compression ratio corresponding to maximum thermal efficiency point and the working range of the cycle first increase and then decrease as the equivalence ratio increases. The result obtained herein provides a guide to the performance evaluation and improvement for practical Otto engines.


1997 ◽  
Vol 200 (3) ◽  
pp. 503-509
Author(s):  
J Layland ◽  
I S Young ◽  
J D Altringham

The work loop technique was used to examine the effects of adrenaline on the mechanics of cardiac muscle contraction in vitro. The length for maximum active force (Lmax) and net work production (Lopt) for rat papillary muscles was determined under control conditions (without adrenaline). The concentration of adrenaline producing the maximum inotropic effect was determined. This concentration was used in the remainder of the experiments. Sinusoidal strain cycles about Lopt were performed over a physiologically relevant range of cycle frequencies (4-11 Hz). Maximum work and the frequency for maximum work increased from 1.91 J kg-1 at 3 Hz in controls to 2.97 J kg-1 at 6 Hz with adrenaline. Similarly, maximum power output and the frequency for maximum power output (fopt) increased from 8.62 W kg-1 at 6 Hz in controls to 19.95 W kg-1 at 8 Hz with adrenaline. We suggest that the power-frequency relationship, derived using the work loop technique, represents a useful index with which to assess the effects of pharmacological interventions on cardiac muscle contractility.


1998 ◽  
Vol 84 (4) ◽  
pp. 1260-1268 ◽  
Author(s):  
Wen-Zhi Zhan ◽  
Jon F. Watchko ◽  
Y. S. Prakash ◽  
Gary C. Sieck

Postnatal transitions in myosin heavy chain (MHC) isoform expression were found to be associated with changes in both isometric and isotonic contractile properties of rat diaphragm muscle (Diam). Expression of MHCneo predominated in neonatal Diam fibers but was usually coexpressed with MHCslow or MHC2A isoforms. Expression of MHCneo disappeared by day 28. Expression of MHC2X and MHC2B emerged at day 14 and increased thereafter. Associated with these MHC transitions in the Diam, maximum isometric tetanic force (Po), maximum shortening velocity, and maximum power output progressively increased during early postnatal development. Maximum power output of the Diam occurred at ∼40% Po at days 0 and 7 and at ∼30% Po in older animals. Susceptibility to isometric and isotonic fatigue, defined as a decline in force and power output during repetitive activation, respectively, increased with maturation. Isotonic endurance time, defined as the time for maximum power output to decline to zero, progressively decreased with maturation. In contrast, isometric endurance time, defined as the time for force to decline to 30–40% Po, remained >300 s until after day 28. We speculate that with the postnatal transition to MHC2X and MHC2Bexpression energy requirements for contraction increase, especially during isotonic shortening, leading to a greater imbalance between energy supply and demand.


Sign in / Sign up

Export Citation Format

Share Document