Combination of Graph Reduction and Tie-set Techniques for Network Reliability Assessment

Author(s):  
Nazik Aljbur ◽  
Musaria K. Mahmood ◽  
Indrit Myderrizi
2021 ◽  
Vol 334 ◽  
pp. 02009
Author(s):  
Maxim Sharov ◽  
Alexey Levashev ◽  
Alexander Mikhailov

In the frame of the project «Criteria of traffic control quality and effectiveness in Russian Federation» the Transportation Laboratory of ISTU was invoved into elaboration of network performance appraisal. Two alternative congestion measures were considered. The ratio of peak period to free flow travel times was proposed as a test criterion of urban highway network reliability.


Author(s):  
Марина Николаевна Ильина ◽  
Дмитрий Васильевич Ларюшкин

Источником информации о техническом состоянии трубопроводов тепловых сетей объектов магистральных нефтепроводов ПАО «Транснефть» являются результаты их обслуживания и ремонта, технического освидетельствования, гидравлических испытаний и т. д. На основании этих данных проводятся расчеты показателей надежности, по итогам анализа которых осуществляется планирование дальнейшего технического обслуживания и ремонта. Однако при оценке надежности систем теплоснабжения необходимо учитывать не только срок эксплуатации и величину амортизационного износа, но и реальное состояние в конкретных условиях функционирования. Учесть многообразие факторов, которые влияют на работоспособность трубопроводов системы теплоснабжения, и тем самым повысить точность расчетов при оценке их остаточного ресурса позволяет применение кластерного анализа в дополнение к используемой методике оценки надежности тепловых сетей. В рамках настоящей работы оценка надежности объектов АО «Связьтранснефть» с применением кластерного анализа проведена на примере равнозначных участков тепловых сетей двух узлов связи, расположенных в Краснодарском крае и Республике Саха (Якутия). Currently, information about technical condition of pipelines of heat supply systems at the facilities of the main oil pipelines of PJSC Transneft is formed based on the results of maintenance and repair, technical inspection, hydraulic tests, etc. Upon these data, calculations of reliability indicators of heat networks are carried out, based on the analysis of calculations further maintenance and repairs are planned. However, when assessing the reliability of heat supply systems, it is necessary to take into account not only the service life and the amount of depreciation wear of heat network elements, but also their real state in specific operating conditions. The use of cluster analysis in addition to the currently used method of heat network reliability assessment allows us to take into account the variety of factors that affect the operability of pipelines of the heat supply system, and thereby increase the accuracy of calculations when assessing their residual resource. Within the framework of this work, the reliability assessment of Svyaztransneft JSC facilities using cluster analysis was carried out on the example of equivalent sections of heat networks of two communication nodes located in the Krasnodar Territory and the Republic of Sakha (Yakutia).


Energies ◽  
2019 ◽  
Vol 12 (16) ◽  
pp. 3202
Author(s):  
Alberto Escalera ◽  
Edgardo D. Castronuovo ◽  
Milan Prodanović ◽  
Javier Roldán-Pérez

Modern power distribution networks assume the connection of Distributed Generators (DGs) and energy storage systems as well as the application of advanced demand management techniques. After a network fault these technologies and techniques can contribute individually to the supply restoration of the interrupted areas and help improve the network reliability. However, the optimal coordination of control actions between these resources will lead to their most efficient use, maximizing the network reliability improvement. Until now, the effect of such networks with optimal coordination has not been considered in reliability studies. In this paper, DGs, energy storage and demand management techniques are jointly modelled and evaluated for reliability assessment. A novel methodology is proposed for the calculation of the reliability indices. It evaluates the optimal coordination of energy storage and demand management in order to reduce the energy-not-supplied during outages. The formulation proposed for the calculation of the reliability indices (including the modelling of optimal coordination) is described in detail. The methodology is applied to two distribution systems combining DGs, energy storage and demand management. Results demonstrate the capability of the proposed method to assess the reliability of such type of networks and emphasise the impact of the optimal coordination on reliability.


2012 ◽  
Vol 433-440 ◽  
pp. 1802-1810 ◽  
Author(s):  
Lin Guan ◽  
Hao Hao Wang ◽  
Sheng Min Qiu

A new algorithm as well as the software design for large-scale distribution network reliability assessment is proposed in this paper. The algorithm, based on fault traversal algorithm, obtains network information from the GIS. The structure of distribution network data storage formats is described, facilitating automatic output of the feeders’ topological and corresponding information from the GIS. Also the judgment of load transfer is discussed and the method for reliability assessment introduced in this paper. Moreover, The impact of the scheduled outage is taken into account in the assessment model, making the results more in accordance with the actual situation. Test Cases show that the proposed method features good accuracy and effectiveness when applied to the reliability assessment of large-scale distribution networks.


Sign in / Sign up

Export Citation Format

Share Document