Design and analysis of a non linear, low confinement loss Photonic Crystal Fiber with Liquid Crystal and air filled holes

Author(s):  
N Anand ◽  
S. K. Sudheer ◽  
V. P. Mahadevan Pillai
2019 ◽  
Vol 9 (20) ◽  
pp. 4445 ◽  
Author(s):  
Amir Ahmadian ◽  
Yashar Esfahani Monfared

In this paper, we propose a novel design of a photonic crystal fiber (PCF) with tellurite-cladding, three rings of air-holes and elliptical concentration of As2S3 in the fiber core. The combined effect of tight mode confinement (an effective mode area of nearly 0.6 µm2), large non-linear refractive index of As2S3 and significant variation between the effective modal index values of the two orthogonal states of the fundamental guided mode leads to extreme non-linear coefficient and birefringence values, all achieved at the zero dispersion wavelength (ZDW) of 1550 nm. The corresponding birefringence and non-linear coefficient (7 × 10−3 and 28 W−1 m−1, respectively) are more than three orders of magnitude larger than that of the regular silica-based highly non-linear PCFs. In addition, we numerically demonstrate that by modifying the core and air-hole dimensions one can easily control the dispersion curve and tune the ZDW of the proposed fiber to any excitation wavelength ranging from near-infrared to short-wave-infrared, including optical telecommunication windows close to 1550 nm. The superior characteristics of the proposed elliptical-core composite PCF including extreme non-linearity, nearly-zero confinement loss (2.47 × 10−12 dB/cm), the ability to maintain polarization of light, and tunable ZDW can open the door to new possibilities in non-linear optics, optical telecommunications, optical signal processing, and sensing devices.


Photonics ◽  
2021 ◽  
Vol 8 (4) ◽  
pp. 122
Author(s):  
Fahad Ahmed Al-Zahrani ◽  
Md. Anowar Kabir

The orbital angular momentum (OAM) of light is used for increasing the optical communication capacity in the mode division multiplexing (MDM) technique. A novel and simple structure of ring-core photonic crystal fiber (RC-PCF) is proposed in this paper. The ring core is doped by the Schott sulfur difluoride material and the cladding region is composed of fused silica with one layer of well-patterned air-holes. The guiding of Terahertz (THz) OAM beams with 58 OAM modes over 0.70 THz (0.20 THz–0.90 THz) frequency is supported by this proposed RC-PCF. The OAM modes are well-separated for their large refractive index difference above 10−4. The dispersion profile of each mode is varied in the range of 0.23–7.77 ps/THz/cm. The ultra-low confinement loss around 10−9 dB/cm and better mode purity up to 0.932 is achieved by this RC-PCF. For these good properties, the proposed fiber is a promising candidate to be applied in the THz OAM transmission systems with high feasibility and high capacity.


Optik ◽  
2016 ◽  
Vol 127 (1) ◽  
pp. 15-20
Author(s):  
Zhaolun Liu ◽  
Jing An ◽  
Hailong Liu ◽  
Shubei Liu ◽  
Haili Du ◽  
...  

2018 ◽  
Vol 0 (0) ◽  
Author(s):  
Izaddeen Kabir Yakasai ◽  
Atta Rahman ◽  
Pg Emeroylariffion Abas ◽  
Feroza Begum

AbstractA porous core photonic crystal fiber (PCF) for transmitting terahertz waves is reported and characterized using finite element method. It is shown that by enveloping an octagonal core consisting of only circular air holes in a hexagonal cladding, it is possible to attain low effective material loss that is 73.8% lower than the bulk material absorption loss at 1.0 THz operating frequency. Moreover, a low confinement loss of 7.53×10–5 cm−1 and dispersion profile of 1.0823±0.06 ps/THz/cm within 0.7–1 THz are obtained using carefully selected geometrical design parameters. Other guiding properties such as single-mode operation, bending loss, and effective area are also investigated. The structural design of this porous core PCF is comparatively simple since it contains noncomplex lattices and circular shaped air holes; and therefore, may be implemented using existing fabrication techniques. Due to its auspicious guiding properties, the proposed fiber may be used in single mode terahertz imaging and other short distance terahertz applications.


2018 ◽  
Vol 0 (0) ◽  
Author(s):  
Mohammad Rakibul Islam ◽  
Md. Arif Hossain ◽  
Syed Iftekhar Ali ◽  
Jakeya Sultana ◽  
Md. Saiful Islam

AbstractA novel photonic crystal fiber (PCF) based on TOPAS, consisting only rectangular slots is presented and analyzed in this paper. The PCF promises not only an extremely low effective material loss (EML) but also a flattened dispersion over a broad frequency range. The modal characteristics of the proposed fiber have been thoroughly investigated using finite element method. The fiber confirms a low EML of 0.009 to 0.01 cm−1 in the frequency range of 0.77–1.05 THz and a flattened dispersion of 0.22±0.01 ps/THz/cm. Besides, some other significant characteristics like birefringence, single mode operation and confinement loss have also been inspected. The simplicity of the fiber makes it easily realizable using the existing fabrication technologies. Thus it is anticipated that the new fiber has the potential to ensure polarization preserving transmission of terahertz signals and to serve as an efficient medium in the terahertz frequency range.


Sign in / Sign up

Export Citation Format

Share Document