Modified direct feedback linearization Excitation Controller for transient stability and voltage regulation of SMIB power system

2018 ◽  
Author(s):  
Salma KESKES ◽  
Nouha Bouchiba ◽  
Souhir SALLEM ◽  
Larbi CHRIFI-ALAOUI ◽  
M.B.A. KAMMOUN
Keyword(s):  
Power System ◽  
Feedback Linearization ◽  
Transient Stability ◽  
Voltage Regulation ◽  
Direct Feedback

scholarly journals Analysis and design of different controllers for non-linear power systems

2013 ◽  
Vol 2 (3) ◽  
pp. 216
Author(s):  
Rekha Chaudhary ◽  
Arun Kumar Singh
Keyword(s):  
Power Systems ◽  
Power System ◽  
Feedback Linearization ◽  
Transient Stability ◽  
Voltage Regulation ◽  
Analysis And Design ◽  
Non Linear ◽  
Terminal Voltage ◽  
Initial Power ◽  
Direct Feedback

The objective of this paper is to design controller for non-linear power system using Direct Feedback Linearization technique to improve the transient stability and to achieve better voltage regulation. In case of fault in the power system, power angle and the terminal voltage are the parameters which are to be monitored. The simulation has been carried out taking different values of initial power angles and results were obtained for power angle and terminal voltage. To overcome the demerits of DFL-LQ optimal controller and DFL voltage regulator, co-ordinated controller is proposed. Simulation results show that transient stability of a power system under a large sudden fault has been improved by using co-ordinated controller.

scholarly journals A Novel Approach to PID Controller Design for Improvement of Transient Stability and Voltage Regulation of Nonlinear Power System

2016 ◽  
Vol 6 (5) ◽  
pp. 2225
Author(s):  
Rekha Chaudhary ◽  
Arun Kumar Singh ◽  
Saligram Agrawal
Keyword(s):  
Power System ◽  
Pid Controller ◽  
Feedback Linearization ◽  
State Feedback ◽  
Transient Stability ◽  
Controller Design ◽  
Design Method ◽  
Voltage Regulation ◽  
Fault System ◽  
Controlled System

<p>In this paper, a novel design method for determining the optimal PID controller parameters for non-linear power system using the particle swarm optimization (PSO) algorithm is presented. The direct feedback linearization (DFL) technique is used to linearize the nonlinear system for computing the PID (DFL-PID) controller parameters. By taking an example of single machine infinite bus (SMIB) power system it has been shown that PSO based PID controller stabilizes the system and restores the pre-fault system performance after fault is cleared and line is restored. The performance of this controlled system is compared with the performance of DFL-state feedback controlled power system. It has been shown that the performance of DFL-PID controlled system is superior compared to DFL-state feedback controlled system. For simulation MATLAB 7 software is used. </p>

A Novel Approach to PID Controller Design for Improvement of Transient Stability and Voltage Regulation of Nonlinear Power System

2016 ◽  
Vol 6 (5) ◽  
pp. 2225
Author(s):  
Rekha Chaudhary ◽  
Arun Kumar Singh ◽  
Saligram Agrawal
Keyword(s):  
Power System ◽  
Pid Controller ◽  
Feedback Linearization ◽  
State Feedback ◽  
Transient Stability ◽  
Controller Design ◽  
Design Method ◽  
Voltage Regulation ◽  
Fault System ◽  
Controlled System

<p>In this paper, a novel design method for determining the optimal PID controller parameters for non-linear power system using the particle swarm optimization (PSO) algorithm is presented. The direct feedback linearization (DFL) technique is used to linearize the nonlinear system for computing the PID (DFL-PID) controller parameters. By taking an example of single machine infinite bus (SMIB) power system it has been shown that PSO based PID controller stabilizes the system and restores the pre-fault system performance after fault is cleared and line is restored. The performance of this controlled system is compared with the performance of DFL-state feedback controlled power system. It has been shown that the performance of DFL-PID controlled system is superior compared to DFL-state feedback controlled system. For simulation MATLAB 7 software is used. </p>

A Simple Design Approach for Excitation Controller and Power System Stabilizer

2010 ◽  
Author(s):  
G. Fusco ◽  
M. Russo
Keyword(s):  
Power System ◽  
Transient Stability ◽  
Short Circuit ◽  
Design Procedure ◽  
Voltage Regulation ◽  
Operating Conditions ◽  
Power System Stabilizer ◽  
Simple Design ◽  
Wide Range ◽  
System Stabilizer

This paper proposes a simple design procedure to solve the problem of controlling generator transient stability following large disturbances in power systems. A state-feedback excitation controller and power system stabilizer are designed to guarantee robustness against uncertainty in the system parameters. These controllers ensure satisfactory swing damping and quick decay of the voltage regulation error over a wide range of operating conditions. The controller performance is evaluated in a case study in which a three-phase short-circuit fault near the generator terminals in a four-bus power system is simulated.

scholarly journals Investigating the impacts of the SVCs and the SCs affecting to the transient stability in multi-machine power system

2016 ◽  
Vol 19 (2) ◽  
pp. 16-24
Author(s):  
Quang Huu Vinh Luu
Keyword(s):  
Power System ◽  
Transient Stability ◽  
Reactive Power ◽  
Voltage Regulation ◽  
State Variables ◽  
Static Var Compensators ◽  
Transient Energy ◽  
Voltage Frequency ◽  
Power Outputs ◽  
Synchronous Condensers

A new algorithm simulating the impacts of the VAR supporting devices such as the static var compensators (SVCs) and the synchronous condensers (SCs) under condition of symmetrical disturbances in multi-machine power system is mentioned. Some typical numerical examples are presented in this article. The comparisons of variation of the state parameters, such as the voltage, frequency, reactive power outputs and asynchronous torques…are simulated under condition of the action of the automatic voltage regulation systems of generators and of the VAR supporting devices. The transient energy margins are calculated and compared to assess the transient stability in multi-machine power system. Basing on this algorithm, the PC program uses the elements of the eigen-image matrix to bring the specific advantages for the simulation of the transient features of state variables.

Coordination Control Strategy for Active and Reactive Power of DFIG Based on Exact Feedback Linearization under Grid Fault Condition

2011 ◽  
Vol 48-49 ◽  
pp. 335-344
Author(s):  
Meng Zeng Cheng ◽  
Zhen Lan Dou ◽  
Xu Cai
Keyword(s):  
Nonlinear Control ◽  
Power System ◽  
Control Strategy ◽  
Feedback Linearization ◽  
Transient Stability ◽  
Reactive Power ◽  
Control Method ◽  
Linear Quadratic Regulator ◽  
Linear Quadratic ◽  
Nonlinear Control Method

In this paper, a control strategy for operation of rotor side converter (RSC) of Doubly Fed Induction Generators (DFIG) is developed by injecting reactive power into the grid in order to support the grid voltage during and after grid fault events. The novel nonlinear control method is based on differential geometry theory, and exact feedback linearization is applied for control system design of DFIG. Then the optimal control for the linearized system is obtained through introducing the linear quadratic regulator (LQR) design method. Simulation results on a single machine infinite bus power system show that the proposed nonlinear control method can inject reactive power to fault grid rapidly, reduce the oscillation of active power and improve the transient stability of power system.

Sign in / Sign up

Export Citation Format

Share Document