Thermal Design Methodology for Low Flow Rate Single-Phase and Two-Phase Micro-Channel Heat Sinks

Author(s):  
S. Lee ◽  
Weilin Qu
Water ◽  
2019 ◽  
Vol 11 (12) ◽  
pp. 2554 ◽  
Author(s):  
Seung-Jun Kim ◽  
Jun-Won Suh ◽  
Young-Seok Choi ◽  
Jungwan Park ◽  
No-Hyun Park ◽  
...  

Pump-turbines are often used to provide a stable power supply with a constant frequency in response to intermittent renewable energy resources. However, existing pumped-storage power stations often operate under off-design conditions because of the increasing amounts of inconsistent renewable resources that have been added to the grid. Under off-design low flow rate conditions, inter-blade vortex and vortex rope phenomena usually develop in the runner and draft tube passages, respectively, in turbine mode. These vortices cause complicated flow patterns and pressure fluctuations that destabilize the operation of the pump-turbine system. Therefore, this study investigates the influence of correlation between the inter-blade vortex and vortex rope phenomena under low flow rate conditions. Three-dimensional steady- and unsteady-state Reynolds-averaged Navier–Stokes equations were calculated with a two-phase flow analysis using a shear stress transport as the turbulence model. The inter-blade vortices in the runner passages were captured well at the low flow rate conditions, and the vortex rope was found to develop within a specific range of low flow rates. These vortex regions showed a blockage effect and complicated flow characteristics with backflow in the passages. Moreover, higher unsteady pressure characteristics occurred at locations where the vortices were especially pronounced.


1984 ◽  
Vol 21 (7) ◽  
pp. 491-500 ◽  
Author(s):  
Kenji FUKUDA ◽  
Akihiko KATO ◽  
Shu HASEGAWA

Author(s):  
Marat S. Gayazov ◽  
Rim A. Valiullin ◽  
Rashid K. Yarullin

This article presents the results of experimental studies of the applicability and range of consumption parameters of the heat tag method for solving practical problems in a horizontal well where an induction heater was used as a heat source. The research was carried out on the certified thermohydrodynamic stand of BSU and in the laboratory of thermometry. The results of the study showed that the method can be applied in a single-phase and two-phase stratified flow with an error of no more than 8%. It was found that the shape and type of the source of the artificial thermoanomaly does not affect the results of measuring local flow rates with an output of the total flow rate. The results of the work defined threshold flow rate (100 m3/day water or light oil for a column of diameter D = 4 ½ꞌꞌ) using an inductor of limited power (P ≈ 1 kW), as well as the requirements to configuration of downhole instruments, providing the possibility of estimating the interval of the phase costs in marginal horizontal wells. The motion front and the evolution of the heat mark along the length of the stand for a stratified horizontal (sub-horizontal) flow consisting of hydraulic oil and process water are demonstrated.


Sign in / Sign up

Export Citation Format

Share Document