The Poly-SiC MSM Photodiode on Ceramic SiC Substrate for Low-Cost Ultraviolet Light Sensing Applications

Amorphous silicon PECVD photonic integrated devices are promising candidates for low cost sensing applications. This manuscript reports a simulation analysis about the impact on the overall efficiency caused by the lithography imperfections in the deposition process. The tolerance to the fabrication defects of a photonic sensor based on surface plasmonic resonance is analysed. The simulations are performed with FDTD and BPM algorithms. The device is a plasmonic interferometer composed by an a-Si:H waveguide covered by a thin gold layer. The sensing analysis is performed by equally splitting the input light into two arms, allowing the sensor to be calibrated by its reference arm. Two different 1 × 2 power splitter configurations are presented: a directional coupler and a multimode interference splitter. The waveguide sidewall roughness is considered as the major negative effect caused by deposition imperfections. The simulation results show that plasmonic effects can be excited in the interferometric waveguide structure, allowing a sensing device with enough sensitivity to support the functioning of a bio sensor for high throughput screening. In addition, the good tolerance to the waveguide wall roughness, points out the PECVD deposition technique as reliable method for the overall sensor system to be produced in a low-cost system. The large area deposition of photonics structures, allowed by the PECVD method, can be explored to design a multiplexed system for analysis of multiple biomarkers to further increase the tolerance to fabrication defects.

Download Full-text

Low Molecular Weight Microfibers with Light Sensing Properties

Materiale Plastice ◽

10.37358/mp.17.4.4920 ◽

2017 ◽

Vol 54 (4) ◽

pp. 655-658

Author(s):

Andrei Bejan ◽

Dragos Peptanariu ◽

Bogdan Chiricuta ◽

Elena Bicu ◽

Dalila Belei

Keyword(s):

Molecular Weight ◽

Low Molecular Weight ◽

X Ray Diffraction ◽

Aromatic Rings ◽

X Ray ◽

Force Microscopy ◽

Light Sensing ◽

Sensing Applications ◽

Atomic Force ◽

Low Molecular Weight Compounds

Microfibers were obtained from organic low molecular weight compounds based on heteroaromatic and aromatic rings connected by aliphatic spacers. The obtaining of microfibers was proved by scanning electron microscopy. The deciphering of the mechanism of microfiber formation has been elucidated by X-ray diffraction, infrared spectroscopy, and atomic force microscopy measurements. By exciting with light of different wavelength, florescence microscopy revealed a specific optical response, recommending these materials for light sensing applications.

Download Full-text

Current Trends in Polymer Based Sensors

Chemosensors ◽

10.3390/chemosensors9050108 ◽

2021 ◽

Vol 9 (5) ◽

pp. 108

Author(s):

Giancarla Alberti ◽

Camilla Zanoni ◽

Vittorio Losi ◽

Lisa Rita Magnaghi ◽

Raffaela Biesuz

Keyword(s):

Chemical Structure ◽

Low Cost ◽

Sensing Applications ◽

Current Trends ◽

Manufacturing Methods ◽

New Devices

This review illustrates various types of polymer and nanocomposite polymeric based sensors used in a wide variety of devices. Moreover, it provides an overview of the trends and challenges in sensor research. As fundamental components of new devices, polymers play an important role in sensing applications. Indeed, polymers offer many advantages for sensor technologies: their manufacturing methods are pretty simple, they are relatively low-cost materials, and they can be functionalized and placed on different substrates. Polymers can participate in sensing mechanisms or act as supports for the sensing units. Another good quality of polymer-based materials is that their chemical structure can be modified to enhance their reactivity, biocompatibility, resistance to degradation, and flexibility.

Download Full-text