Solid-state nanopores integrated with low-noise preamplifiers for high-bandwidth DNA analysis

Author(s):  
Jacob Rosenstein ◽  
Vishva Ray ◽  
Marija Drndic ◽  
Kenneth L. Shepard
Nanoscale ◽  
2021 ◽  
Author(s):  
Nasim Farajpour ◽  
Lauren Lastra ◽  
Vinay Sharma ◽  
Kevin Freedman

Nanopore sensing is a promising tool with widespread application in single-molecule detection. Borosilicate glass nanopores are a viable alternative to other solid-state nanopores due to low noise and cost-efficient fabrication....


2013 ◽  
Vol 115 (1) ◽  
pp. 137-139
Author(s):  
Qianqian Liu ◽  
Min Yang ◽  
Yi Yao ◽  
Ling Zhao ◽  
Bin Li ◽  
...  
Keyword(s):  

2021 ◽  
Vol 48 (5) ◽  
pp. 0501002
Author(s):  
张宽收 Zhang Kuanshou ◽  
卢华东 Lu Huadong ◽  
李渊骥 Li Yuanji ◽  
冯晋霞 Feng Jinxia

2019 ◽  
Vol 11 (7) ◽  
pp. 635-644 ◽  
Author(s):  
T. Shivan ◽  
E. Kaule ◽  
M. Hossain ◽  
R. Doerner ◽  
T. Johansen ◽  
...  

AbstractThis paper reports on an ultra-wideband low-noise distributed amplifier (LNDA) in a transferred-substrate InP double heterojunction bipolar transistor (DHBT) technology which exhibits a uniform low-noise characteristic over a large frequency range. To obtain very high bandwidth, a distributed architecture has been chosen with cascode unit gain cells. Each unit cell consists of two cascode-connected transistors with 500 nm emitter length and ft/fmax of ~360/492 GHz, respectively. Due to optimum line-impedance matching, low common-base transistor capacitance, and low collector-current operation, the circuit exhibits a low-noise figure (NF) over a broad frequency range. A 3-dB bandwidth from 40 to 185 GHz is measured, with an NF of 8 dB within the frequency range between 75 and 105 GHz. Moreover, this circuit demonstrates the widest 3-dB bandwidth operation among all reported single-stage amplifiers with a cascode configuration. Additionally, this work has proposed that the noise sources of the InP DHBTs are largely uncorrelated. As a result, a reliable prediction can be done for the NF of ultra-wideband circuits beyond the frequency range of the measurement equipment.


1966 ◽  
Vol 31 (4) ◽  
pp. 209 ◽  
Author(s):  
J. Frilley ◽  
G. Grandchamp

Author(s):  
A.S. Mayer ◽  
A. Klenner ◽  
A.R. Johnson ◽  
K. Luke ◽  
M.R.E. Lamont ◽  
...  

2005 ◽  
Vol 14 (02) ◽  
pp. 267-279 ◽  
Author(s):  
M. B. GUERMAZ ◽  
L. BOUZERARA ◽  
H. ESCID ◽  
M. T. BELAROUSSI

This paper describes and analyzes a low-noise and high-bandwidth transimpedance amplifier featuring a large dynamic range. The designed amplifier is configured on three identical stages that use an active load compensated by an active resistor to improve the stability performance of the amplifier. This topology displays a transimpedance gain of 150 kΩ, which is necessary to obtain a high sensitivity. This structure operates at 5 V power supply voltage, exhibits a gain bandwidth product of 18 THzΩ and a low-noise level of about [Formula: see text]. This transimpedance amplifier can reach a transmission speed of 240 Mb/s for a photocurrent of 0.5 μA. For a photocurrent of 9.5 μA, a transmission speed of 622 Mb/s can be achieved by using an optical fiber connection containing four channels. The predicted performance is verified by simulations using PSPICE and MAGIC tools with 0.8 μm CMOS AMS parameters.


Sign in / Sign up

Export Citation Format

Share Document