Fully Soft Switched Interleaved High Step-Up/Down Bidirectional Converter With No Pulsating Current at Low Voltage Source

2021 ◽  
pp. 1-1
Author(s):  
Mohsen Packnezhad ◽  
Hosein Farzanehfard
Keyword(s):  
Low Voltage ◽  
Voltage Source ◽  
Bidirectional Converter ◽  
Pulsating Current

scholarly journals Voltage disturbance mitigation in Iraq's low voltage distribution system

2020 ◽  
Vol 17 (1) ◽  
pp. 47
Author(s):  
Jamal Abdul-Kareem Mohammed ◽  
Arkan Ahmed Hussein ◽  
Sahar R. Al-Sakini
Keyword(s):  
Power Distribution ◽  
Distribution System ◽  
Pulse Width Modulation ◽  
Low Voltage ◽  
Distribution Network ◽  
Voltage Source ◽  
Power Distribution Network ◽  
Dynamic Voltage Restorer ◽  
Voltage Restorer ◽  
Dynamic Voltage

<p>Power distribution network in Iraq still suffers from significant problems regarding electricity distribution level. The most important problem is the disturbances that are occurring on lines voltages, which in turn, will negatively affect sensitive loads they feed on. Protection of these loads could be achieved efficiently and economically using the dynamic voltage restorer DVR when installed between the voltage source and load to inject required compensation voltage to the network during the disturbances period. The DVR mitigates these disturbances via restoring the load voltage to a pre-fault value within a few milliseconds. To control the DVR work, dq0 transformation concept and PID method with sinusoidal pulse-width modulation SPWM based converter had been used to correct the disturbances and thus enhance the power quality of the distribution network. The DVR performance was tested by MATLAB/Simulink with all kinds of expected voltage disturbances and results investigated the effectiveness of the proposed method.</p>

scholarly journals Improvement of Power Quality Considering Voltage Stability in Grid Connected System by FACTS Devices

2013 ◽  
pp. 182-187
Author(s):  
Sarika D. Patil
Keyword(s):  
Power Generation ◽  
Wind Power ◽  
Power Flow ◽  
Voltage Stability ◽  
Low Voltage ◽  
Wind Power Generation ◽  
Voltage Source ◽  
Voltage Source Converter ◽  
Induction Generators ◽  
Facts Devices

Recently the wind power generation has attracted special interest and many wind power stations are being in service in the world. In the wind turbine that mostly uses induction generators, tend to drain large amounts of Vars from the grid, potentially causing low voltage and may be voltage stability problems for the utility owner, especially in the case of large load variation on distribution feeder. Voltage-source converter based various FACTS devices have been used for flexible power flow control, secure loading and damping of power system oscillations. Some of those are used also to improve transient and dynamic stability of the wind power generation (WPGS).

scholarly journals Implementation of Snubber Circuits in a PV-Based Off-Grid Electric Vehicle Charging Station—Comparative Case Studies

Energies ◽  
2021 ◽  
Vol 14 (18) ◽  
pp. 5853
Author(s):  
Divya Krishnan Nair ◽  
Krishnamachar Prasad ◽  
Tek Tjing Lie
Keyword(s):  
Low Voltage ◽  
Solar Array ◽  
Paradigm Shifts ◽  
Storage Unit ◽  
Charging Infrastructure ◽  
Energy Storage Unit ◽  
Leakage Inductance ◽  
Zero Voltage Switching ◽  
Charging Station ◽  
Bidirectional Converter

With the penetration of electric vehicles (EVs), there have been paradigm shifts in the transportation sector. EVs are ideally considered to be clean and eco-friendly, but they can overload the existing grid infrastructure and significantly contribute towards carbon emissions depending on the source of charging. The ideal solution is to develop a charging infrastructure for EVs that is integrated with solar energy technology. This paper presents the design of a zero-voltage switching snubber-based bidirectional converter for an off-grid charging station for EVs. The proposed system includes a solar array with a boost converter, a bidirectional converter with snubber circuits and an energy storage unit. A comprehensive comparison between various types of snubbers, such as the resistive capacitive diode snubber, active clamp snubber and flyback snubber, is presented. This type of system configuration clamps the rail voltage, due to the difference in current between leakage inductance and low voltage side-fed inductor currents, resulting in reduced current spikes at the converter’s switches. Such a converter, therefore, leads to higher efficiency of the charging station for EVs. The design of a snubber-based off-grid charging station for EVs is formulated and validated in the MATLAB/Simulink environment.

scholarly journals Implementation of a Novel Control Technique in Landsman Converter Using Bumble Bee Optimization

2018 ◽  
Vol 7 (3.27) ◽  
pp. 339
Author(s):  
Riyaz A. Rahiman ◽  
M C. John Wiselin
Keyword(s):  
Low Voltage ◽  
High Reliability ◽  
Control Technique ◽  
Voltage Source ◽  
Bumble Bee ◽  
Bldc Motor ◽  
Solar Pv ◽  
Partial Shading ◽  
Point Tracking ◽  
Wide Range

This paper focuses on a solar PV array based BLDC motor employing Landsman converter under partial shading condition (PSC). A converter acts as an interface between the SPV array under PSC and Voltage Source Inverter (VSI) feeding the Brushless DC (BLDC) motor. BLDC motor incorporating the merits of higher efficiency, high reliability, high ruggedness, easy-to-drive, capability to operate successfully at low voltage and excellent performance over a wide range of speed. The speed control of BLDC motor by variable DC-link voltage. This eliminates the additional phase current sensing, DC-link voltage sensing, additional control and associated circuitry. The proposed system includes simplicity control, compactness, and soft starting of the BLDC motor. The operation of Landsman converter in CCM results reduced stress on devices.  To optimize the operating point of the SPV array in order to get maximum possible power output by means of the better maximum power point tracking (MPPT) technique. The technique is Bumble Bee Mating Optimization (BBMO) based MPPT. The novel technique is compared to the conventional techniques. The simulated results are executed in MATLAB/SIMULINK.

Control Scheme for a Bidirectional Converter in a Self-Sustaining Low-Voltage DC Nanogrid

2015 ◽  
Vol 62 (10) ◽  
pp. 6317-6326 ◽  
Author(s):  
Saravana Ilango Ganesan ◽  
Dinesh Pattabiraman ◽  
Ramesh Krishna Govindarajan ◽  
Manoj Rajan ◽  
Chilakapati Nagamani
Keyword(s):  
Low Voltage ◽  
Bidirectional Converter ◽  
Control Scheme
Sign in / Sign up

Export Citation Format

Share Document