Estimations of Magnetic Field Distributions in Three Dimensions Using a Two Dimensional Computer Program TRIMM

1971 ◽  
Vol 18 (3) ◽  
pp. 907-908
Author(s):  
S. M. Matin ◽  
R. D. Hay
1995 ◽  
Vol 305 ◽  
pp. 281-305 ◽  
Author(s):  
P. C. Matthews ◽  
M. R. E. Proctor ◽  
N. O. Weiss

Convection in a compressible fiuid with an imposed vertical magnetic field is studied numerically in a three-dimensional Cartesian geometry with periodic lateral boundary conditions. Attention is restricted to the mildly nonlinear regime, with parameters chosen first so that convection at onset is steady, and then so that it is oscillatory.Steady convection occurs in the form of two-dimensional rolls when the magnetic field is weak. These rolls can become unstable to a mean horizontal shear flow, which in two dimensions leads to a pulsating wave in which the direction of the mean flow reverses. In three dimensions a new pattern is found in which the alignment of the rolls and the shear flow alternates.If the magnetic field is sufficiently strong, squares or hexagons are stable at the onset of convection. Both the squares and the hexagons have an asymmetrical topology, with upflow in plumes and downflow in sheets. For the squares this involves a resonance between rolls aligned with the box and rolls aligned digonally to the box. The preference for three-dimensional flow when the field is strong is a consequence of the compressibility of the layer- for Boussinesq magnetoconvection rolls are always preferred over squares at onset.In the regime where convection is oscillatory, the preferred planform for moderate fields is found to be alternating rolls - standing waves in both horizontal directions which are out of phase. For stronger fields, both alternating rolls and two-dimensional travelling rolls are stable. As the amplitude of convection is increased, either by dcereasing the magnetic field strength or by increasing the temperature contrast, the regular planform structure seen at onset is soon destroyed by secondary instabilities.


1984 ◽  
Vol 30 (1) ◽  
pp. 250-258 ◽  
Author(s):  
M. Thomsen ◽  
M. F. Thorpe ◽  
T. C. Choy ◽  
D. Sherrington

2013 ◽  
Vol 735 ◽  
pp. 457-472
Author(s):  
F. Cattaneo ◽  
S. M. Tobias

AbstractIt has been shown that it is possible to measure the turbulent diffusivity of a magnetic field by a method involving oscillatory sources. So far the method has only been tried in the special case of two-dimensional fields and flows. Here we extend the method to three dimensions and consider the case where the flow is thermally driven convection in a large-aspect-ratio domain. We demonstrate that if the diffusing field is horizontal the method is successful even if the underlying flow can sustain dynamo action. We show that the resulting turbulent diffusivity is comparable with, although not exactly the same as, that of a passive scalar. We were not able to measure unambiguously the diffusivity if the diffusing field is vertical, but argue that such a measurement is possible if enough resources are utilized on the problem.


Author(s):  
Makoto Shiojiri ◽  
Toshiyuki Isshiki ◽  
Tetsuya Fudaba ◽  
Yoshihiro Hirota

In hexagonal Se crystal each atom is covalently bound to two others to form an endless spiral chain, and in Sb crystal each atom to three others to form an extended puckered sheet. Such chains and sheets may be regarded as one- and two- dimensional molecules, respectively. In this paper we investigate the structures in amorphous state of these elements and the crystallization.HRTEM and ED images of vacuum-deposited amorphous Se and Sb films were taken with a JEM-200CX electron microscope (Cs=1.2 mm). The structure models of amorphous films were constructed on a computer by Monte Carlo method. Generated atoms were subsequently deposited on a space of 2 nm×2 nm as they fulfiled the binding condition, to form a film 5 nm thick (Fig. 1a-1c). An improvement on a previous computer program has been made as to realize the actual film formation. Radial distribution fuction (RDF) curves, ED intensities and HRTEM images for the constructed structure models were calculated, and compared with the observed ones.


Sign in / Sign up

Export Citation Format

Share Document