Variations in Aortic Pressure Affect the Mechanics of the Intra-Aortic Balloon: An In Vitro Investigation

2010 ◽  
Vol 34 (7) ◽  
pp. 546-553 ◽  
Author(s):  
Giovanni Biglino ◽  
Christina Kolyva ◽  
Michael Whitehorne ◽  
John R. Pepper ◽  
Ashraf W. Khir
2008 ◽  
Vol 35 (S 01) ◽  
Author(s):  
H Leske ◽  
A Baiker ◽  
C Schichor ◽  
J.C Tonn ◽  
R Goldbrunner ◽  
...  

2010 ◽  
Vol 51 (8) ◽  
pp. 4151 ◽  
Author(s):  
Henri Sueke ◽  
Stephen B. Kaye ◽  
Timothy Neal ◽  
Amanda Hall ◽  
Stephen Tuft ◽  
...  

2020 ◽  
Vol 21 (12) ◽  
pp. 2718-2728
Author(s):  
Elsayed M. Abdel Bary ◽  
Ammar N. Harmal ◽  
Mona E. Ibrahim ◽  
Moustafa A. Gouda

2020 ◽  
Vol 1571 ◽  
pp. 012010
Author(s):  
V P Veiko ◽  
Yu Yu Karlagina ◽  
E E Egorova ◽  
E A Zernitskaya ◽  
D S Kuznetsova ◽  
...  

1988 ◽  
Vol 67 (3) ◽  
pp. 577-581 ◽  
Author(s):  
Y. Jima ◽  
T. Koulourides

This in vitro investigation studied the remineralization of experimental caries lesions in bovine enamel by use of three methods: (1) surface microhardness, (2) microradiography, and (3) abrasion biopsy for mineral density and fluoride content. The lesions were produced by a two-day exposure to 0.01 mol/L lactic acidlsodium hydroxide buffer partially saturated with 3.0 mmol/L Ca, 1.8 mmol/L P, in 1% CMC, at pH 4.0 and 37°C. The lesions were exposed to a remineralizing solution containing 3.0 mmol/L Ca, 1.8 mmol/L P, and 3 ppm F in 1% CMC at pH 7.0 and 37°C for two, six, and ten days, with solution changes every two days. The data derived from the three methods are presented in sequence from the baseline and at days two, six, and ten of the remineralizing treatment. Microhardness measurements showed hardness recoveries of 35.9, 78.9, and 87.5%, respectively. Microradiography suggested complete recovery with the ten-day remineralization. Abrasion biopsy of successive 10-μm layers to a depth of 100 μm indicated 15.2, 39.8, and 68.8% mineral density recoveries, with fluoride content of the surface layer increasing from a baseline of 300 ppm to 4600, 9000, and 9800 ppm F for the 2, 6, 10 days of remineralization, respectively. Subsequent acid-etching of thin sections from the ten-day-remineralized specimens showed that the fluoride-enriched remineralized area was more resistant to acid dissolution than was the underlying nonnal enamel.


2002 ◽  
Vol 23 (3) ◽  
pp. 555-566 ◽  
Author(s):  
P J Dunmore-Buyze ◽  
M Moreau ◽  
A Fenster ◽  
D W Holdsworth

2003 ◽  
Vol 10 (3) ◽  
pp. 424-432 ◽  
Author(s):  
Chuh K. Chong ◽  
Thien V. How ◽  
Geoffrey L. Gilling-Smith ◽  
Peter L. Harris

Purpose: To investigate the effect on intrasac pressure of stent-graft deployment within a life-size silicone rubber model of an abdominal aortic aneurysm (AAA) maintained under physiological conditions of pressure and flow. Methods: A commercial bifurcated device with the polyester fabric preclotted with gelatin was deployed in the AAA model. A pump system generated physiological flow. Mean and pulse aortic and intrasac pressures were measured simultaneously using pressure transducers. To simulate a type I endoleak, plastic tubing was placed between the aortic wall and the stent-graft at the proximal anchoring site. Type II endoleak was simulated by means of side branches with set inflow and outflow pressures and perfusion rates. Type IV endoleak was replicated by removal of gelatin from the graft fabric. Results: With no endoleak, the coated graft reduced the mean and pulse sac pressures to negligible values. When a type I endoleak was present, mean sac pressure reached a value similar to mean aortic pressure. When net flow through the sac due to a type II endoleak was present, mean sac pressure was a function of the inlet pressure, while pulse pressure in the sac was dependent on both inlet and outlet pressures. As perfusion rates increased, both mean and pulse sac pressures decreased. When there was no outflow, mean sac pressure was similar to mean aortic pressure. In the presence of both type I and type II endoleaks, mean sac pressure reached mean aortic pressure when the net perfusion rate was low. Conclusions: In vitro studies are useful in gaining an understanding of the impact of different types of endoleaks, in isolation and in combination, on intrasac pressure after aortic stent-graft deployment.


Sign in / Sign up

Export Citation Format

Share Document