Application of sensitive, high-resolution imaging at a commercial lab-based X-ray micro-CT system using propagation-based phase retrieval

2017 ◽  
Vol 266 (2) ◽  
pp. 211-220 ◽  
Author(s):  
P. BIDOLA ◽  
K. MORGAN ◽  
M. WILLNER ◽  
A. FEHRINGER ◽  
S. ALLNER ◽  
...  
2012 ◽  
Vol 329 ◽  
pp. 26-31 ◽  
Author(s):  
H.M. Hertz ◽  
M. Bertilson ◽  
O. v. Hofsten ◽  
S.-C. Gleber ◽  
J. Sedlmair ◽  
...  

2012 ◽  
Vol 18 (S2) ◽  
pp. 390-391
Author(s):  
R. Gauvin ◽  
P. Michaud ◽  
N. Brodusch ◽  
M.L. Trudeau

Extended abstract of a paper presented at Microscopy and Microanalysis 2012 in Phoenix, Arizona, USA, July 29 – August 2, 2012.


2010 ◽  
Vol 2010 ◽  
pp. 1-10 ◽  
Author(s):  
Michael J. Haugh ◽  
Richard Stewart

This paper describes the design, crystal selection, and crystal testing for a vertical Johann spectrometer operating in the 13 keV range to measure ion Doppler broadening in inertial confinement plasmas. The spectrometer is designed to use thin, curved, mica crystals to achieve a resolving power of E/ΔE>2000. A number of natural mica crystals were screened for flatness and X-ray diffraction width to find samples of sufficient perfection for use in the instrument. Procedures to select and mount high quality mica samples are discussed. A diode-type X-ray source coupled to a dual goniometer arrangement was used to measure the crystal reflectivity curve. A procedure was developed for evaluating the goniometer performance using a set of diffraction grade Si crystals. This goniometer system was invaluable for identifying the best original crystals for further use and developing the techniques to select satisfactory curved crystals for the spectrometer.


2000 ◽  
Vol 41 (1) ◽  
pp. 64-66
Author(s):  
S. Ohtsuka ◽  
Y. Sugishita ◽  
T. Takeda ◽  
Y. Itai ◽  
J. Tada ◽  
...  

2020 ◽  
Author(s):  
Jeffrey Fein ◽  
David Ampleford ◽  
J. Vogel ◽  
B. Kozioziemski ◽  
C. Walton ◽  
...  

2019 ◽  
Vol 30 (4) ◽  
pp. 2280-2292 ◽  
Author(s):  
Y. Dawood ◽  
G. J. Strijkers ◽  
J. Limpens ◽  
R. J. Oostra ◽  
B. S. de Bakker

Abstract Background MRI and CT have been extensively used to study fetal anatomy for research and diagnostic purposes, enabling minimally invasive autopsy and giving insight in human fetal development. Novel (contrast-enhanced) microfocus CT (micro-CT) and ultra-high-field (≥ 7.0 T) MRI (UHF-MRI) techniques now enable micron-level resolution that combats the disadvantages of low-field MRI and conventional CT. Thereby, they might be suitable to study fetal anatomy in high detail and, in time, contribute to the postmortem diagnosis of fetal conditions. Objectives (1) To systematically examine the usability of micro-CT and UHF-MRI to study postmortem human fetal anatomy, and (2) to analyze factors that govern success at each step of the specimen preparation and imaging. Method MEDLINE and EMBASE were systematically searched to identify publications on fetal imaging by micro-CT or UHF-MRI. Scanning protocols were summarized and best practices concerning specimen preparation and imaging were enumerated. Results Thirty-two publications reporting on micro-CT and UHF-MRI were included. The majority of the publications focused on imaging organs separately and seven publications focused on whole body imaging, demonstrating the possibility of visualization of small anatomical structures with a resolution well below 100 μm. When imaging soft tissues by micro-CT, the fetus should be stained by immersion in Lugol’s staining solution. Conclusion Micro-CT and UHF-MRI are both excellent imaging techniques to provide detailed images of gross anatomy of human fetuses. The present study offers an overview of the current best practices when using micro-CT and/or UHF-MRI to study fetal anatomy for clinical and research purposes. Key Points • Micro-CT and UHF-MRI can both be used to study postmortem human fetal anatomy for clinical and research purposes. • Micro-CT enables high-resolution imaging of fetal specimens in relatively short scanning time. However, tissue staining using a contrast solution is necessary to enable soft-tissue visualization. • UHF-MRI enables high-resolution imaging of fetal specimens, without the necessity of prior staining, but with the drawback of long scanning time.


Author(s):  
Y. Wang ◽  
C. Jacobsen

Contact x-ray microscopy or microradiography offers a simple-to-use approach to high resolution imaging of wet, thick biological specimens. One great advantage of the technique is that it can be usedwith short pulse, incoherent x-ray sources such as laser produced plasmas, and polymer replicas or direct AFM viewing are promising new approaches to image readout. However, it has long been pointed outthat issues such as diffraction blurring over finite sample-to-resist spacing, shot noise in the exposure, and sidecutting during development must be considered in evaluating contact x-ray microradiographs.We present here the results of numerical modelling of contact x-ray microscopy using photoresists. We assume a phantom consisting of protein rods and balls of different diameters, all embedded in a water layer. We assume that the x-ray exposure is provided by a black body source with temperature kBT = 100 eV (such as in a laser-produced plasma), and that the black bodyspectrum is then modified by x-ray transmission in 0.1/μm of Al2O3, 0.1μm of Si3N4, and 5μm of water.


1976 ◽  
Vol 47 (3) ◽  
pp. 282-290 ◽  
Author(s):  
E. Kellogg ◽  
P. Henry ◽  
S. Murray ◽  
L. Van Speybroeck ◽  
P. Bjorkholm

Sign in / Sign up

Export Citation Format

Share Document