Theoretical and Experimental Study of Development of Two-Dimensional Steady and Unsteady Wakes Within Curved Channels

1995 ◽  
Vol 117 (4) ◽  
pp. 593-598 ◽  
Author(s):  
M. T. Schobeiri ◽  
K. Pappu ◽  
J. John

Development of steady and periodic unsteady wake flows downstream of stationary and rotating cylindrical rods within a curved channel under zero longitudinal pressure gradient is theoretically and experimentally investigated. Wake quantities such as the mean velocity and turbulent fluctuations in longitudinal and lateral directions, as well as the turbulent shear stress, are measured. For the nondimensionalized velocity defect, affine profiles are observed throughout the flow regime. Based on these observations and using the transformed equations of motion and continuity, a theoretical frame work is established that generally describes the two-dimensional curvilinear wake flow. To confirm the theory, development of steady and periodic unsteady wakes in the above curved channel are experimentally investigated. The detailed comparison between the measurement and the theory indicates that the complex steady and unsteady wake flows are very well predicted.

Author(s):  
M. T. Schobeiri ◽  
J. John ◽  
K. Pappu

The development of a wake flow downstream of a cylindrical rod within a curved channel under zero streamwise pressure gradient is theoretically and experimentally investigated. The measured asymmetric wake quantities such as the mean velocity and turbulent fluctuations in longitudinal and lateral directions as well as the turbulent shear stress are transformed from the probe coordinate system into the curvilinear wake eigen-coordinate system. For the transformed non-dimensionalized velocity defect and the turbulent quantities, affine profiles are observed throughout the flow regime. Based on these observations and using the transformed equations of motion and continuity, a theoretical frame work is established that generally describes the two-dimensional curvilinear wake flow. The theory also describes the straight wake as a special case, for which the curvature radius approaches infinity. The comparison of the theory with the experimental data pertaining to the curvilinear and straight wakes demonstrate the general validity of the theory.


1994 ◽  
Vol 1 (1) ◽  
pp. 19-35
Author(s):  
M. T. Schobeiri ◽  
K. Pappu ◽  
J. John

The development of a wake flow downstream of a cylindrical rod within a curved channel under zero streamwise pressure gradient is theoretically and experimentally investigated. The measured asymmetric wake quantities such as the mean velocity and turbulent fluctuations in longitudinal and lateral directions as well as the turbulent shear stress are transformed from the probe coordinate system into the curvilinear wake eigen-coordinate system. For the transformed nondimensionalized velocity defect and the turbulent quantities, affine profiles are observed throughout the flow regime. Based on these observations and using the transformed equations of motion and continuity, a theoretical framework is established that generally describes the two-dimensional curvilinear wake flow. The theory also describes the straight wake as a special case, for which the curvature radius approaches infinity. To demonstrate the general validity of theory, experimental results pertaining to curved wake as well as straight wake flows are compared with the developed theory.


1996 ◽  
Vol 118 (3) ◽  
pp. 506-518 ◽  
Author(s):  
M. T. Schobeiri ◽  
J. John ◽  
K. Pappu

The development of a wake flow downstream of a cylindrical rod within a curved channel under zero streamwise pressure gradient is theoretically and experimentally investigated. The measured asymmetric wake quantities such as the mean velocity and turbulent fluctuations in longitudinal and lateral directions as well as the turbulent shear stress are transformed from the probe coordinate system into the curvilinear wake eigen-coordinate system. For the transformed non-dimensionalized velocity defect and the turbulent quantities, affine profiles are observed throughout the flow regime. Based on these observations and using the transformed equations of motion and continuity, a theoretical frame work is established that generally describes the two-dimensional curvilinear wake flow. The theory also describes the straight wake as a special case, for which the curvature radius approaches infinity. The comparison of the theory with the experimental data pertaining to the curvilinear and straight wakes demonstrate the general validity of the theory.


2004 ◽  
Vol 108 (1086) ◽  
pp. 419-425 ◽  
Author(s):  
P. R. Viswanath ◽  
K. T. Madhavan

Abstract Experiments have been performed investigating the effectiveness of steady tangential blowing, with the blowing slot located downstream of separation (but inside the separation bubble) to control a trailing-edge separated flow at low speeds. Trailing-edge separation was induced on a two-dimensional aerofoil-like body and the shear layer closure occurred in the near-wake. Measurements made consisted of model surface pressures and mean velocity, turbulent shear stress and kinetic energy profiles in the separated zone using a two-component LDV system. It is explicitly demonstrated that the novel concept of tangential blowing inside the bubble can be an effective means of control for trailing-edge separated flows as well. Blowing mass and momentum requirements for the suppression of wall and wake flow reversals have been estimated.


1996 ◽  
Vol 118 (2) ◽  
pp. 292-299 ◽  
Author(s):  
J. John ◽  
M. T. Schobeiri

The development of turbomachinery wake flows is greatly influenced by streamline curvature and streamwise pressure gradient. This paper is part of a comprehensive experimental and theoretical study on the development of the steady and periodic unsteady turbulent wakes in curved channels at different streamwise pressure gradients. This paper reports on the experimental investigation of the two-dimensional wake behind a stationary circular cylinder in a curved channel at positive streamwise pressure gradient. Measurements of mean velocity and Reynolds stress components are carried out using a X-hot-film probe. The measured quantities obtained in probe coordinates are transformed to a curvilinear coordinate system along the wake center line and are presented in similarity coordinates. The results show strong asymmetry in velocity and Reynolds stress components. The Reynolds stress components have higher values at the inner half of the wake than at the outer half of the wake. However, the mean velocity defect profiles in similarity coordinates are almost symmetric and follow the same Gaussian function for the straight wake data. A comparison with the wake development in a curved channel at zero streamwise pressure gradient suggests the decay rate of velocity defect is slower and the growth of wake width is faster for a positive streamwise pressure gradient.


1974 ◽  
Vol 64 (3) ◽  
pp. 529-564 ◽  
Author(s):  
J. Counihan ◽  
J. C. R. Hunt ◽  
P. S. Jackson

By making simple assumptions, an analytical theory is deduced for the mean velocity behind a two-dimensional obstacle (of heighth) placed on a rigid plane over which flows a turbulent boundary layer (of thickness δ). It is assumed thath[Gt ] δ, and that the wake can be divided into three regions. The velocity deficit −uis greatest in the two regions in which the change in shear stress is important, a wall region (W) close to the wall and a mixing region (M) spreading from the top of the obstacle. Above these is the external region (E) in which the velocity field is an inviscid perturbation on the incident boundary-layer velocity, which is taken to have a power-law profileU(y) =U∞(y−y1)n/δn, wheren[Gt ] 1. In (M), assuming that an eddy viscosity (=KhU(h)) can be defined for the perturbed flow in terms of the incident boundary-layer flow and that the velocity is self-preserving, it is found thatu(x,y) has the form$\frac{u}{U(h)} = \frac{ C }{Kh^2U^2(h)} \frac{f(n)}{x/h},\;\;\;\; {\rm where}\;\;\;\; \eta = (y/h)/[Kx/h]^{1/(n+2)}$, and the constant which defines the strength of the wake is$C = \int^\infty_0 y^U(y)(u-u_E)dy$, whereu=uE(x, y) asy→ 0 in region (E).In region (W),u(y) is proportional to Iny.By considering a large control surface enclosing the obstacle it is shown that the constant of the wake flow is not simply related to the drag of the obstacle, but is equal to the sum of the couple on the obstacle and an integral of the pressure field on the surface near the body.New wind-tunnel measurements of mean and turbulent velocities and Reynolds stresses in the wake behind a two-dimensional rectangular block on a roughened surface are presented. The turbulent boundary layer is artificially developed by well-established methods (Counihan 1969) in such a way that δ = 8h. These measurements are compared with the theory, with other wind-tunnel measurements and also with full-scale measurements of the wind behind windbreaks.It is found that the theory describes the distribution of mean velocity reasonably well, in particular the (x/h)−1decay law is well confirmed. The theory gives the correct self-preserving form for the distribution of Reynolds stress and the maximum increase of the mean-square turbulent velocity is found to decay downstream approximately as$ (\frac{x}{h})^{- \frac{3}{2}} $in accordance with the theory. The theory also suggests that the velocity deficit is affected by the roughness of the terrain (as measured by the roughness lengthy0) in proportion to In (h/y0), and there seems to be some experimental support for this hypothesis.


1980 ◽  
Vol 101 (1) ◽  
pp. 159-178 ◽  
Author(s):  
S. Yavuzkurt ◽  
R. J. Moffat ◽  
W. M. Kays

Hydrodynamic data are reported in the companion paper (Yavuzkurt, Moffat & Kays 1980) for a full-coverage film-cooling situation, both for the blown and the recovery regions. Values of the mean velocity, the turbulent shear stress, and the turbulence kinetic energy were measured at various locations, both within the blown region and in the recovery region. The present paper is concerned with an analysis of the recovery region only. Examination of the data suggested that the recovery-region hydrodynamics could be modelled by considering that a new boundary layer began to grow immediately after the cessation of blowing. Distributions of the Prandtl mixing length were calculated from the data using the measured values of mean velocity and turbulent shear stresses. The mixing-length distributions were consistent with the notion of a dual boundary-layer structure in the recovery region. The measured distributions of mixing length were described by using a piecewise continuous but heuristic fit, consistent with the concept of two quasi-independent layers suggested by the general appearance of the data. This distribution of mixing length, together with a set of otherwise normal constants for a two-dimensional boundary layer, successfully predicted all of the observed features of the flow. The program used in these predictions contains a one-equation model of turbulence, using turbulence kinetic energy with an algebraic mixing length. The program is a two-dimensional, finite-difference program capable of predicting the mean velocity and turbulence kinetic energy profiles based upon initial values, boundary conditions, and a closure condition.


1994 ◽  
Author(s):  
J. John ◽  
M. T. Schobeiri

The development of turbomachinery wake flows are greatly influenced by streamline curvature and streamwise pressure gradient. This paper is a part of a comprehensive experimental and theoretical study on the development of the steady and the periodic unsteady turbulent wakes in curved channels at different streamwise pressure gradients. The experimental investigation of the two-dimensional wake behind a stationary circular cylinder in a curved channel at positive streamwise pressure gradient is reported in this paper. Measurements of mean velocity and Reynolds stress components are carried out using a X-hot-film probe. The measured quantities obtained in probe coordinates are transformed to a curvilinear coordinate system along the wake center line and are presented in similarity coordinates. The results indicates strong asymmetry in velocity and Reynolds stress components. The Reynolds stress components have higher values at the inner half of the wake than at the outer half of the wake. However, the mean velocity defect profiles in similarity coordinates is almost symmetric and follows the same Gaussian function for the straight wake data. A comparison with the wake development in a curved channel at zero streamwise pressure gradient suggests that the decay rate of velocity defect is slower and the growth of wake width is faster in the case of positive streamwise pressure gradient.


2017 ◽  
Vol 2 (1) ◽  
pp. 55-76 ◽  
Author(s):  
Jan Bartl ◽  
Lars Sætran

Abstract. This is a summary of the results of the fourth blind test workshop that was held in Trondheim in October 2015. Herein, computational predictions on the performance of two in-line model wind turbines as well as the mean and turbulent wake flow are compared to experimental data measured at the wind tunnel of the Norwegian University of Science and Technology (NTNU). A detailed description of the model geometry, the wind tunnel boundary conditions and the test case specifications was published before the workshop. Expert groups within computational fluid dynamics (CFD) were invited to submit predictions on wind turbine performance and wake flow without knowing the experimental results at the outset. The focus of this blind test comparison is to examine the model turbines' performance and wake development with nine rotor diameters downstream at three different turbulent inflow conditions. Aside from a spatially uniform inflow field of very low-turbulence intensity (TI = 0.23 %) and high-turbulence intensity (TI = 10.0 %), the turbines are exposed to a grid-generated highly turbulent shear flow (TI = 10.1 %).Five different research groups contributed their predictions using a variety of simulation models, ranging from fully resolved Reynolds-averaged Navier–Stokes (RANS) models to large eddy simulations (LESs). For the three inlet conditions, the power and the thrust force of the upstream turbine is predicted fairly well by most models, while the predictions of the downstream turbine's performance show a significantly higher scatter. Comparing the mean velocity profiles in the wake, most models approximate the mean velocity deficit level sufficiently well. However, larger variations between the models for higher downstream positions are observed. Prediction of the turbulence kinetic energy in the wake is observed to be very challenging. Both the LES model and the IDDES (improved delayed detached eddy simulation) model, however, consistently manage to provide fairly accurate predictions of the wake turbulence.


Sign in / Sign up

Export Citation Format

Share Document