Numerical Study of the Damped Oscillation of Liquid Column in U-Tube With Particle Method

2013 ◽  
Vol 135 (6) ◽  
Author(s):  
Yangyang Liang ◽  
Guang Xi ◽  
Zhongguo Sun
Keyword(s):  
Size Effect ◽  
Numerical Study ◽  
Particle Method ◽  
Liquid Column ◽  
Liquid Density ◽  
Minor Influence ◽  
Oscillation Process ◽  
Damped Oscillation ◽  
Moving Particle ◽  
A Minor

The damped oscillation process of the liquid column in a U-tube is simulated and studied using the moving particle semi-implicit (MPS) method. The oscillation process is well reproduced and the effect of liquid properties as the density and viscosity is investigated, as well as the size effect of the U-tube. As key parameters, the amplitude and the period of the oscillation are calculated and analyzed when the flow conditions are changed. The results show that the amplitude and the average period of the oscillation process decrease when the liquid viscosity increases, and that the liquid density has a minor influence on the damping process. A critical finding for the size effect is that the oscillation process almost changes linearly with the size of the U-tube larger than the critical point, but nonlinearly when the size is scaled down. Larger viscosity results in shorter equilibrium time and viscosity plays a more important role in damping, especially for a smaller size of the U-tube. These versatile numerical protocols can present useful qualitative suggestions on the applications of a U-tube in many industrial fields.

Numerical Study of Pressure Wave Transmission in Liquid Under Different Interface Conditions Using Particle Method

2009 ◽  
Author(s):  
Zhongguo Sun ◽  
Guang Xi
Keyword(s):  
Free Surface ◽  
Pressure Wave ◽  
Numerical Study ◽  
Wave Length ◽  
Particle Method ◽  
Wave Transmission ◽  
Wave Transport ◽  
Moving Particle ◽  
Energy Absorbing ◽  
The Waves

The process of pressure wave transmission in liquid is simulated with the moving particle semi-implicit (MPS) method. The simulation is carried out in a tube full filled with an energy absorbing liquid. Here we studied the shapes and positions of pressure waves and investigated the behavior of the waves under different viscosities and densities of liquids. Some typical parameters of pressure wave, such as peak pressure value, wave length and transport speed are studied. Varying viscosity does not change the wave length and speed of the pressure wave evidently. The effect of interfaces which formed by viscosity difference or density difference is investigated. Reflection is found not always happened on such interfaces. Pressure wave transport to liquid-solid interface and free surface are also simulated. Pressure wave is vanished when closing to free surface. These results give useful qualitative suggestions on controlling the pressure wave in fluid engineering.

Structure-activity relations and β-lactamase resistance

1980 ◽  
Vol 289 (1036) ◽  
pp. 197-205 ◽  
Keyword(s):  
Broad Spectrum ◽  
Product Inhibition ◽  
Sulphur Atom ◽  
Chemical Modifications ◽  
Gram Negative ◽  
Structure Activity ◽  
Broad Spectrum Resistance ◽  
Structure Activity Relations ◽  
Minor Influence ◽  
A Minor

β-Lactam antibiotics resistant to β-lactamase degradation can be produced by many chemical modifications, but often at the expense of antibacterial activity. Substitution onto several positions in the molecule produces different and often selective resistance; for instance, heavily sterically hindered acyl groups give staphylococcal P-lactamase resistance to penicillins, and resistance to some enzymes from Gram-negative pathogens to both penicillins and cephalosporins. 6-α- or 7-α-substituents respectively confer a broad spectrum of resistance (e.g. cefoxitin), but changes at positions 2 or 3 have only a minor influence on enzyme susceptibility. Changes in the ring condensed with the β-lactam, such as changing ceph-3-em to ceph-2-em may greatly enhance stability. Small improvements can occur when the nuclear sulphur atom is oxidized, but a much better effect is obtained when it is replaced by another atom such as oxygen, as in clavulanic acid. This compound appears to have broad spectrum resistance which is actually due to susceptibility and subsequent product inhibition.

Experimental and numerical study of size effect on long-term drying behavior of concrete: influence of drying depth

2016 ◽  
Vol 49 (10) ◽  
pp. 4029-4048 ◽  
Author(s):  
H. Samouh ◽  
A. Soive ◽  
E. Rozière ◽  
A. Loukili
Keyword(s):  
Size Effect ◽  
Numerical Study ◽  
Drying Behavior

Lubrication Properties of Aqueous Solutions with Polyethoxylated Ether (PEOE) Added

2011 ◽  
Vol 239-242 ◽  
pp. 1359-1363
Author(s):  
Chao Hui Zhang ◽  
Si Si Liu ◽  
Yue Tao Sun ◽  
Jun Ming Liu
Keyword(s):  
Aqueous Solution ◽  
Aqueous Solutions ◽  
Metal Working ◽  
Functional Additives ◽  
Film Forming ◽  
Minor Influence ◽  
Forming Characteristics ◽  
Aqueous Surfactants ◽  
A Minor ◽  
Lubrication Properties

Aqueous solutions have found broad usages as lubricants, in conjunction with other possible utilizations, such as in metal working and other industries. Due to the inferior lubricity, functional additives are needed to improve their tribological performances among which aqueous surfactants are exclusively included. The film forming property of aqueous solution with polyethoxylated ether added (PEOE) is measured, taking consideration of the influences of the temperature and the concentration. The addition of PEOEs into aqueous solutions will largely increase the film forming capacity. But the concentration has only a minor influence on the lubrication property of the aqueous solutions with PEOEs. The cloud point will strongly alter the film forming characteristics.

scholarly journals Influence of Different Commercial Yeasts on Volatile Fraction of Sparkling Wines

Foods ◽  
2021 ◽  
Vol 10 (2) ◽  
pp. 247
Author(s):  
Valeriu V. Cotea ◽  
Mihai Cristian Focea ◽  
Camelia Elena Luchian ◽  
Lucia Cintia Colibaba ◽  
Elena Cristina Scutarașu ◽  
...  
Keyword(s):  
International Organization ◽  
Volatile Fraction ◽  
Chemical Parameters ◽  
Physical Chemical ◽  
Organoleptic Characteristics ◽  
Mass Spectrometry Technique ◽  
Minor Influence ◽  
Spectrometry Technique ◽  
A Minor ◽  
Aging Stage

The occurrence of aroma constituents in sparkling wines, with direct impact on their organoleptic characteristics, is affected by several factors, for example the base-wine particularities, grapes cultivar conditions, inoculated yeasts, the aging stage, and wine-making practices. This study evaluated the influence of different four commercial yeasts (IOC FIZZ™, IOC DIVINE™, LEVULIA CRISTAL™, and IOC 18-2007™) on the volatile composition of experimental sparkling wines. For this, five sparkling wines variants from the Muscat Ottonel grape variety were obtained. The base-wine was obtained through reverse osmosis and had a predetermined alcoholic concentration (10.5% vol.). In order to fulfill the proposed purpose, the experimental sparkling wines were characterized by the physical–chemical parameters (according to International Organization of Vine and Wine methods of analysis), volatile fraction (using gas-chromatography coupled with mass spectrometry technique), and sensory descriptors. Data showed a key impact on the concentration of the volatile constituents (p < 0.05), depending on the type of inoculated yeast for the second fermentation. Regarding the sensory analysis, important differences can be observed due to the type of inoculated yeast. Only a minor influence on the physical–chemical parameters was registered.

Optimization of Moving Particle Semi-Implicit (MPS) Method and Studying of Flow Instability

2018 ◽  
Author(s):  
Kailun Guo ◽  
Ronghua Chen ◽  
Suizheng Qiu ◽  
Wenxi Tian ◽  
Guanghui Su ◽  
...  
Keyword(s):  
Multiphase Flows ◽  
Flow Instability ◽  
Free Particle ◽  
Particle Method ◽  
Severe Accident ◽  
Particle Methods ◽  
Two Phase ◽  
Mps Method ◽  
Viscosity Term ◽  
Moving Particle

Multiphase flow widely exists in the nature and engineering. The two-phase flow is the highlight of the studies about the flow in the vessel and steam explosion in nuclear severe accidents. The Moving Particle Semi-implicit (MPS) method is a fully-Lagrangian particle method without grid mesh which focuses on tracking the single particle and concerns with its movement. It has advantages in tracking complex multiphase flows compared with gird methods, and thus shows great potential in predicting multiphase flows. The objective of this thesis is to develop a general multiphase particle method based on the original MPS method and thus this work is of great significance for improving the numerical method for simulating the instability in reactor severe accident and two-phase flows in vessel. This research is intended to provide a study of the instability based on the MPS method. Latest achievements of mesh-free particle methods in instability are researched and a new multiphase MPS method, which is based on the original one, for simulating instability has been developed and validated. Based on referring to other researchers’ papers, the Pressure Poisson Equation (PPE), the viscosity term, the free surface particle determination part and the surface tension model are optimized or added. The numerical simulation on stratification behavior of two immiscible flows is carried out and results are analyzed after data processing. It is proved that the improved MPS method is more accurate than the original method in analysis of multiphase flows. In this paper, the main purposes are simulating and discussing Rayleigh-Taylor (R-T) instability and Kelvin-Helmholtz (K-H) instability. R-T and K-H instability play an important role in the mixing process of many layered flows. R-T instability occurs when a lower density fluid is supported by another density higher fluid or higher density fluid is accelerated by lower density fluid, and the resulting small perturbation increases and eventually forms turbulence. K-H instability is a small disturbance for two different densities, such as waves, at the interface of the two-phase fluid after giving a fixed acceleration in the fluid. Turbulence generated by R-T instability and K-H instability has an important effect in applications such as astrophysics, geophysics, and nuclear science.

scholarly journals Numerical study of size effect in concrete penetration with LDPM

2018 ◽  
Vol 14 (5) ◽  
pp. 560-569 ◽  
Author(s):  
Jun Feng ◽  
Wei-wei Sun ◽  
Bao-ming Li
Keyword(s):  
Size Effect ◽  
Numerical Study

scholarly journals Study on divergence approximation formula for pressure calculation in particle method

2018 ◽  
Vol 10 (4) ◽  
pp. 159-169
Author(s):  
Zhu Yue ◽  
Jiang Shengyao ◽  
Yang Xingtuan ◽  
Duan Riqiang
Keyword(s):  
Pressure Oscillation ◽  
Particle Method ◽  
Free Surface Flows ◽  
Implicit Method ◽  
Approximation Formula ◽  
Pressure Poisson Equation ◽  
Pressure Calculation ◽  
Approximation Formulas ◽  
Moving Particle ◽  
Dam Breaking

The moving particle semi-implicit method is a meshless particle method for incompressible fluid and has proven useful in a wide variety of engineering applications of free-surface flows. Despite its wide applicability, the moving particle semi-implicit method has the defects of spurious unphysical pressure oscillation. Three various divergence approximation formulas, including basic divergence approximation formula, difference divergence approximation formula, and symmetric divergence approximation formula are proposed in this paper. The proposed three divergence approximation formulas are then applied for discretization of source term in pressure Poisson equation. Two numerical tests, including hydrostatic pressure problem and dam-breaking problem, are carried out to assess the performance of different formulas in enhancing and stabilizing the pressure calculation. The results demonstrate that the pressure calculated by basic divergence approximation formula and difference divergence approximation formula fluctuates severely. However, application of symmetric divergence approximation formula can result in a more accurate and stabilized pressure.

scholarly journals Phytoplankton thermal responses adapt in the absence of hard thermodynamic constraints

2018 ◽  
Author(s):  
Dimitrios - Georgios Kontopoulos ◽  
Erik van Sebille ◽  
Michael Lange ◽  
Gabriel Yvon-Durocher ◽  
Timothy G. Barraclough ◽  
...  
Keyword(s):  
Thermal Performance ◽  
Thermal Sensitivity ◽  
Meta Analysis ◽  
Habitat Type ◽  
Performance Curve ◽  
Thermal Environments ◽  
Thermal Performance Curve ◽  
Performance Curves ◽  
Minor Influence ◽  
A Minor

AbstractTo better predict how populations and communities respond to climatic temperature variation, it is necessary to understand how the shape of the response of fitness-related traits to temperature evolves (the thermal performance curve). Currently, there is disagreement about the extent to which the evolution of thermal performance curves is constrained. One school of thought has argued for the prevalence of thermodynamic constraints through enzyme kinetics, whereas another argues that adaptation can—at least partly—overcome such constraints. To shed further light on this debate, we perform a phylogenetic meta-analysis of the thermal performance curves of growth rate of phytoplankton—a globally important functional group—, controlling for environmental effects (habitat type and thermal regime). We find that thermodynamic constraints have a minor influence on the shape of the curve. In particular, we detect a very weak increase of maximum performance with the temperature at which the curve peaks, suggesting a weak “hotter-is-better” constraint. Also, instead of a constant thermal sensitivity of growth across species, as might be expected from strong constraints, we find that all aspects of the thermal performance curve evolve along the phylogeny. Our results suggest that phytoplankton thermal performance curves adapt to thermal environments largely in the absence of hard thermodynamic constraints.

Sign in / Sign up

Export Citation Format

Share Document