Model Tests on the Long-Term Dynamic Performance of Offshore Wind Turbines Founded on Monopiles in Sand

2015 ◽  
Vol 137 (4) ◽  
Author(s):  
Zhen Guo ◽  
Luqing Yu ◽  
Lizhong Wang ◽  
S. Bhattacharya ◽  
G. Nikitas ◽  
...  
Keyword(s):  
Dynamic Response ◽  
Wind Turbines ◽  
Model Tests ◽  
Offshore Wind ◽  
Frequency Change ◽  
Test Results ◽  
Scaled Model ◽  
Structural Dynamic ◽  
Offshore Wind Turbines

The dynamic response of the supporting structure is critical for the in-service stability and safety of offshore wind turbines (OWTs). The aim of this paper is to first illustrate the complexity of environmental loads acting on an OWT and reveal the significance of its structural dynamic response for the OWT safety. Second, it is aimed to investigate the long-term performance of the OWT founded on a monopile in dense sand. Therefore, a series of well-scaled model tests have been carried out, in which an innovative balance gear system was proposed and used to apply different types of dynamic loadings on a model OWT. Test results indicated that the natural frequency of the OWT in sand would increase as the number of applied cyclic loading went up, but the increasing rate of the frequency gradually decreases with the strain accumulation of soil around the monopile. This kind of the frequency change of OWT is thought to be dependent on the way how the OWT is cyclically loaded and the shear strain level of soil in the area adjacent to the pile foundation. In this paper, all test results were plotted in a nondimensional manner in order to be scaled up to predict the consequences for prototype OWT in sandy seabed.

scholarly journals Assessment of Practical Methods to Predict Accumulated Rotations of Monopile-Supported Offshore Wind Turbines in Cohesionless Ground Profiles

Energies ◽  
2020 ◽  
Vol 13 (15) ◽  
pp. 3915
Author(s):  
Saleh Jalbi ◽  
Joseph Hilton ◽  
Luke Jacques
Keyword(s):  
Wind Turbines ◽  
Time History ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Complex Nature ◽  
Scaled Model ◽  
Offshore Wind Turbines ◽  
Applied Loading ◽  
Number Of Cycles

Monopiles supporting offshore wind turbines can experience permanent non-recoverable rotations (or displacements) during their lifetime due to the cyclic nature of hydrodynamic and aerodynamic loading exerted on them. Recent studies in the literature have demonstrated that conventional cyclic p–y curves recommended in different codes of practice (API-RP-2GEO and DNVGL-RP-C212) may not capture the effects of long-term cyclic loads as they are independent of the loading profile and the number of applied cycles. Several published methodologies based on laboratory scaled model tests (on sands) exist to determine the effect of cyclic lateral loads on the long-term behaviour of piles. The tests vary in terms of the pile behaviour (rigid or flexible pile), number of applied loading cycles, and the load profile (one-way or two-way loading). The best-fit curves provided by these tests offer practical and cost-efficient methods to quantify the accumulated rotations when compared to Finite Element Method. It is therefore desirable that such methods are further developed to take into account different soil types and the complex nature of the loading. The objective of this paper is to compare the performance of the available formulations under the actions of a typical 35-h (hour) storm as per the Bundesamt für Seeschifffahrt und Hydrographie (BSH) recommendations. Using classical rain flow counting, the loading time-history is discretized into load packets where each packet has a loading profile and number of cycles, which then enables the computation of an equivalent number of cycles of the largest load packet. The results show that the loading profile plays a detrimental role in the result of the accumulated rotation. Furthermore, flexibility of the pile also has an important effect on the response of the pile where predictions obtained from formulations based on flexible piles resulted in a much lower accumulated rotation than tests based on rigid piles. Finally, the findings of this paper are expected to contribute in the design and interpretation of future experimental frameworks for Offshore Wind Turbine (OWT) monopiles in sands, which will include a more realistic loading profile, number of cycles, and relative soil to pile stiffness.

scholarly journals A Surface Ice Module for Wind Turbine Dynamic Response Simulation Using FAST

2016 ◽  
Vol 138 (5) ◽  
Author(s):  
Bingbin Yu ◽  
Dale G. Karr ◽  
Huimin Song ◽  
Senu Sirnivas
Keyword(s):  
Dynamic Response ◽  
Wind Turbine ◽  
Wind Turbines ◽  
Structural Response ◽  
Simulation Software ◽  
Offshore Wind ◽  
Foundation Soil ◽  
Offshore Wind Turbines ◽  
Ice Failure ◽  
Lock In

Developing offshore wind energy has become more and more serious worldwide in recent years. Many of the promising offshore wind farm locations are in cold regions that may have ice cover during wintertime. The challenge of possible ice loads on offshore wind turbines raises the demand of modeling capacity of dynamic wind turbine response under the joint action of ice, wind, wave, and current. The simulation software FAST is an open source computer-aided engineering (CAE) package maintained by the National Renewable Energy Laboratory. In this paper, a new module of FAST for assessing the dynamic response of offshore wind turbines subjected to ice forcing is presented. In the ice module, several models are presented which involve both prescribed forcing and coupled response. For conditions in which the ice forcing is essentially decoupled from the structural response, ice forces are established from existing models for brittle and ductile ice failure. For conditions in which the ice failure and the structural response are coupled, such as lock-in conditions, a rate-dependent ice model is described, which is developed in conjunction with a new modularization framework for FAST. In this paper, analytical ice mechanics models are presented that incorporate ice floe forcing, deformation, and failure. For lower speeds, forces slowly build until the ice strength is reached and ice fails resulting in a quasi-static condition. For intermediate speeds, the ice failure can be coupled with the structural response and resulting in coinciding periods of the ice failure and the structural response. A third regime occurs at high speeds of encounter in which brittle fracturing of the ice feature occurs in a random pattern, which results in a random vibration excitation of the structure. An example wind turbine response is simulated under ice loading of each of the presented models. This module adds to FAST the capabilities for analyzing the response of wind turbines subjected to forces resulting from ice impact on the turbine support structure. The conditions considered in this module are specifically addressed in the International Organization for Standardization (ISO) standard 19906:2010 for arctic offshore structures design consideration. Special consideration of lock-in vibrations is required due to the detrimental effects of such response with regard to fatigue and foundation/soil response. The use of FAST for transient, time domain simulation with the new ice module is well suited for such analyses.

Comparison of Spar and Semisubmersible Floater Concepts of Offshore Wind Turbines Using Long-Term Analysis

2015 ◽  
Vol 137 (6) ◽  
Author(s):  
Hasan Bagbanci ◽  
D. Karmakar ◽  
C. Guedes Soares
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Transfer Functions ◽  
Probability Distributions ◽  
Offshore Wind ◽  
Short Term ◽  
Offshore Wind Turbines ◽  
Floating Wind Turbine ◽  
Offshore Floating Wind Turbine

The long-term probability distributions of a spar-type and a semisubmersible-type offshore floating wind turbine response are calculated for surge, heave, and pitch motions along with the side-to-side, fore–aft, and yaw tower base bending moments. The transfer functions for surge, heave, and pitch motions for both spar-type and semisubmersible-type floaters are obtained using the fast code and the results are also compared with the results obtained in an experimental study. The long-term predictions of the most probable maximum values of motion amplitudes are used for design purposes, so as to guarantee the safety of the floating wind turbines against overturning in high waves and wind speed. The long-term distribution is carried out using North Atlantic wave data and the short-term floating wind turbine responses are represented using Rayleigh distributions. The transfer functions are used in the procedure to calculate the variances of the short-term responses. The results obtained for both spar-type and semisubmersible-type offshore floating wind turbine are compared, and the study will be helpful in the assessments of the long-term availability and economic performance of the spar-type and semisubmersible-type offshore floating wind turbine.

On the Modeling of Nonlinear Waves for Prediction of Long-Term Offshore Wind Turbine Loads

2008 ◽  
Author(s):  
P. Agarwal ◽  
L. Manuel
Keyword(s):  
Wind Turbine ◽  
Wind Turbines ◽  
Return Period ◽  
Wave Model ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Offshore Wind Turbines ◽  
Irregular Wave ◽  
Inflow Turbulence

In the design of wind turbines—onshore or offshore—the prediction of extreme loads associated with a target return period requires statistical extrapolation from available loads data. The data required for such extrapolation are obtained by stochastic time-domain simulation of the inflow turbulence, the incident waves, and the turbine response. Prediction of accurate loads depends on assumptions made in the simulation models employed. While for the wind, inflow turbulence models are relatively well established, for wave input, the current practice is to model irregular (random) waves using a linear wave theory. Such a wave model does not adequately represent waves in shallow waters where most offshore wind turbines are being sited. As an alternative to this less realistic wave model, the present study investigates the use of irregular nonlinear (second-order) waves for estimating loads on an offshore wind turbine, with a focus on the fore-aft tower bending moment at the mudline. We use a 5MW utility-scale wind turbine model for the simulations. Using, first, simpler linear irregular wave modeling assumptions, we establish long-term loads and identify governing environmental conditions (i.e., the wind speed and wave height) that are associated with the 20-year return period load derived using the inverse first-order reliability method. We present the nonlinear irregular wave model next and incorporate it into an integrated wind-wave-response simulation analysis program for offshore wind turbines. We compute turbine loads for the governing environmental conditions identified with the linear model and also for an extreme environmental state. We show that computed loads are generally larger with the nonlinear wave modeling assumptions; this establishes the importance of using such refined nonlinear wave models in stochastic simulation of the response of offshore wind turbines.

Numerical Prototyping of Floating Offshore Wind Turbines: Virtual Operation in Real Environmental Conditions

2020 ◽  
Author(s):  
Daniel Milano ◽  
Christophe Peyrard ◽  
Matteo Capaldo
Keyword(s):  
Wind Turbines ◽  
Wind Wave ◽  
Fatigue Analysis ◽  
Offshore Wind ◽  
Offshore Wind Turbine ◽  
Wave Direction ◽  
Offshore Wind Turbines ◽  
Floating Offshore Wind Turbines ◽  
Wave Conditions

Abstract The numerical fatigue analysis of floating offshore wind turbines (FOWTs) must account for the environmental loading over a typical design life of 25 years, and the stochastic nature of wind and waves is represented by design load cases (DLCs). In this statistical approach, combinations of wind speeds and directions are associated with different sea states, commonly defined via simplified wave spectra (Pierson-Moskowitz, JONSWAP), and their probability of occurrence is identified based on past observations. However, little is known about the difference between discretizing the wind/wave direction bins into (e.g.) 10deg bins rather than 30deg bins, and the impact it has on FOWT analyses. In addition, there is an interest in identifying the parameters that best represent real sea states (significant wave height, peak period) and wind fields (profile, turbulence) in lumped load cases. In this context, the aim of this work is to better understand the uncertainties associated to wind/wave direction bin size and to the use of metocean parameters as opposed to real wind and sea state conditions. A computational model was developed in order to couple offshore wind turbine models with realistic numerical metocean models, referred to as numerical prototype due to the highly realistic wind/wave conditions in which it operates. This method allows the virtual installation of FOWTs anywhere within a considered spatial domain (e.g. the Mediterranean Sea or the North Sea) and their behaviour to be evaluated in measured wind and modelled wave conditions. The work presented in this paper compares the long-term dynamic behaviour of a tension-leg platform (TLP) FOWT design subject to the numerical prototype and to lumped load cases with different direction bin sizes. Different approaches to representing the wind filed are also investigated, and the modelling choices that have the greatest impact on the fidelity of lumped load cases are identified. The fatigue analysis suggests that 30deg direction bins are sufficient to reliably represent long-term wind/wave conditions, while the use of a constant surface roughness length (as suggested by the IEC standards) seems to significantly overestimate the cumulated damage on the tower of the FOWT.

Dynamic response in frequency and time domains of a floating foundation for offshore wind turbines

2013 ◽  
Vol 60 ◽  
pp. 115-123 ◽  
Author(s):  
Ruoyu Zhang ◽  
Yougang Tang ◽  
Jun Hu ◽  
Shengfu Ruan ◽  
Chaohe Chen
Keyword(s):  
Dynamic Response ◽  
Wind Turbines ◽  
Offshore Wind ◽  
Offshore Wind Turbines ◽  
Floating Foundation ◽  
Time Domains
Sign in / Sign up

Export Citation Format

Share Document