Experimental Study of Turbulent Transport in Non-Isothermal Oscillating Grids Turbulence Using Particle Image Velocimetry

2003 ◽  
Author(s):  
Alexander Eidelman ◽  
Tov Elperin ◽  
Nathan Kleeorin ◽  
Alexander Krein ◽  
Igor Rogachevskii ◽  
...  
Keyword(s):  
Particle Image Velocimetry ◽  
Spatial Distribution ◽  
Temperature Gradient ◽  
Thermal Diffusion ◽  
Particle Image ◽  
Turbulent Transport ◽  
Mean Temperature ◽  
Image Velocimetry ◽  
Oscillating Grids ◽  
The Mean

An oscillating grids turbulence generator was constructed for studies of a new effect associated with turbulent transport of inertial particles — turbulent thermal diffusion. This phenomenon was predicted theoretically in Phys. Rev. Lett. 76, 224 (1996) and has been detected experimentally in oscillating grids turbulence with an imposed mean temperature gradient in air flow. This effect implies an additional mean flux of particles in the direction opposite to the mean temperature gradient and results in formation of large-scale inhomogeneities in the spatial distribution of particles. We used Particle Image Velocimetry to determine the turbulent velocity field and an Image Processing Technique to determine the spatial distribution of particles. Velocity distributions were measured in the flow generated with one and two grids in the Oscillating Grids Turbulence Generators at RWTH (Aachen) and BGU (Beer-Sheva). Analysis of the intensity of laser light Mie scattering by particles showed that they are accumulated in the vicinity of the minimum of the mean temperature of the surrounding fluid. The latter finding confirms the existence of the effect of turbulent thermal diffusion predicted theoretically.

scholarly journals Turbulent thermal diffusion of aerosols in geophysics and in laboratory experiments

2004 ◽  
Vol 11 (3) ◽  
pp. 343-350 ◽  
Author(s):  
A. Eidelman ◽  
T. Elperin ◽  
N. Kleeorin ◽  
A. Krein ◽  
I. Rogachevskii ◽  
...  
Keyword(s):  
Spatial Distribution ◽  
Thermal Diffusion ◽  
Large Scale ◽  
Laboratory Experiments ◽  
Turbulent Transport ◽  
Mie Scattering ◽  
Processing Technique ◽  
Image Processing Technique ◽  
Mean Temperature ◽  
Image Velocimetry

Abstract. We discuss a new phenomenon of turbulent thermal diffusion associated with turbulent transport of aerosols in the atmosphere and in laboratory experiments. The essence of this phenomenon is the appearance of a nondiffusive mean flux of particles in the direction of the mean heat flux, which results in the formation of large-scale inhomogeneities in the spatial distribution of aerosols that accumulate in regions of minimum mean temperature of the surrounding fluid. This effect of turbulent thermal diffusion was detected experimentally. In experiments turbulence was generated by two oscillating grids in two directions of the imposed vertical mean temperature gradient. We used Particle Image Velocimetry to determine the turbulent velocity field, and an Image Processing Technique based on an analysis of the intensity of Mie scattering to determine the spatial distribution of aerosols. Analysis of the intensity of laser light Mie scattering by aerosols showed that aerosols accumulate in the vicinity of the minimum mean temperature due to the effect of turbulent thermal diffusion.

Experimental study of the mean structure and quasi-conical scaling of a swept-compression-ramp interaction at Mach 2

2018 ◽  
Vol 841 ◽  
pp. 1-27 ◽  
Author(s):  
Leon Vanstone ◽  
Mustafa Nail Musta ◽  
Serdar Seckin ◽  
Noel Clemens
Keyword(s):  
Boundary Layer ◽  
Shock Wave ◽  
Particle Image Velocimetry ◽  
Flow Field ◽  
Scaling Laws ◽  
Particle Image ◽  
Separated Flow ◽  
Image Velocimetry ◽  
The Mean ◽  
Wave Boundary

This study investigates the mean flow structure of two shock-wave boundary-layer interactions generated by moderately swept compression ramps in a Mach 2 flow. The ramps have a compression angle of either $19^{\circ }$ or $22.5^{\circ }$ and a sweep angle of $30^{\circ }$. The primary diagnostic methods used for this study are surface-streakline flow visualization and particle image velocimetry. The shock-wave boundary-layer interactions are shown to be quasi-conical, with the intermittent region, separation line and reattachment line all scaling in a self-similar manner outside of the inception region. This is one of the first studies to investigate the flow field of a swept ramp using particle image velocimetry, allowing more sensitive measurements of the velocity flow field than previously possible. It is observed that the streamwise velocity component outside of the separated flow reaches the quasi-conical state at the same time as the bulk surface flow features. However, the streamwise and cross-stream components within the separated flow take longer to recover to the quasi-conical state, which indicates that the inception region for these low-magnitude velocity components is actually larger than was previously assumed. Specific scaling laws reported previously in the literature are also investigated and the results of this study are shown to scale similarly to these related interactions. Certain limiting cases of the scaling laws are explored that have potential implications for the interpretation of cylindrical and quasi-conical scaling.

Particle Image Velocimetry Measurements of the Mean Flow Characteristics in a Bubble Plume

2007 ◽  
Vol 133 (6) ◽  
pp. 665-676 ◽  
Author(s):  
Dong-Guan Seol ◽  
Tirtharaj Bhaumik ◽  
Christian Bergmann ◽  
Scott A. Socolofsky
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Flow Characteristics ◽  
Bubble Plume ◽  
Mean Flow ◽  
Image Velocimetry ◽  
The Mean

scholarly journals Shear Band Characterization of Clayey Soils with Particle Image Velocimetry

2020 ◽  
Vol 10 (3) ◽  
pp. 1139
Author(s):  
Kwak ◽  
Park ◽  
Kim ◽  
Chung ◽  
Baek
Keyword(s):  
Particle Image Velocimetry ◽  
Spatial Distribution ◽  
Shear Band ◽  
Particle Image ◽  
Shear Bands ◽  
Side Wall ◽  
Failure Behavior ◽  
Clayey Soils ◽  
Initial State ◽  
Image Velocimetry

Identifying the spatial distribution of deformation and shear band characteristics is important for accurately modeling soil behavior and ensuring the safety of nearby geotechnical structures. However, most research on the shear behavior of soils has focused on granular soil and clay-rich rocks, with little focus on clayey soil, and the entire shearing process from the initial state to failure has not been observed. This study evaluated the spatial distribution and evolution of deformation in clayey soils from the initial state to the post-failure state and the shear band characteristics. Plane strain tests were performed on normally consolidated and over-consolidated clay specimens, and digital images were captured through a transparent side wall for particle image velocimetry (PIV) analysis. PIV was performed to evaluate the displacement and deformation of soil particles. The results show that the shear-strain behaviors of two clays during the shearing process could be divided into four stages: initial, peak, softening, and steady state. Shear bands were observed to form in the softening stage, and the shear band slopes were compared to values in the literature. These results can be used to characterize shear bands in clay as well as predict failure behavior and guide reinforcement at actual sites with soft ground.

Particle Image Velocimetry and Proper Orthogonal Decomposition Applied to Aerodynamic Sound Source Region Visualization in Organ Flue Pipe

2015 ◽  
Vol 40 (4) ◽  
pp. 475-484 ◽  
Author(s):  
Witold Mickiewicz
Keyword(s):  
Particle Image Velocimetry ◽  
Velocity Field ◽  
Proper Orthogonal Decomposition ◽  
Particle Image ◽  
Orthogonal Decomposition ◽  
Sound Generation ◽  
Image Velocimetry ◽  
The Mean ◽  
Temporal Modes ◽  
Proper Orthogonal

AbstractThe paper presents experimental results of the visualization of the nonlinear aeroacoustic sound generation phenomena occurring in organ flue pipe. The phase-locked particle image velocimetry technique is applied to visualize the mixed velocity field in the transparent organ flue pipe model made from Plexiglas. Presented measurements were done using synchronization to the tone generated by the pipe itself sup- plied by controlled air flow with seeding particles. The time series of raw velocity field distribution images show nonlinear sound generation mechanisms: the large amplitude of deflection of the mean flue jet and vortex shedding in the region of pipe mouth. Proper Orthogonal Decomposition (POD) was then applied to the experimental data to separately visualize the mean mass flow, pulsating jet mass flow with vortices and also sound waves near the generation region as well as inside and outside of the pipe. The resulting POD spatial and temporal modes were used to approximate the acoustic velocity field behaviour at the pipe fundamental frequency. The temporal modes shapes are in a good agreement with the microphone pressure signal shape registered from a distance. Obtained decomposed spatial modes give interesting insight into sound generating region of the organ pipe and the transition area towards the pure acoustic field inside the resonance pipe. They can give qualitative and quantitative data to verify existing sound generation models used in Computational Fluid Dynamics (CFD) and Computational Aero-Acoustics (CAA).

Thermal Diffusion in Mixtures of Alcohols and Aromatic Hydrocarbons

1971 ◽  
Vol 26 (1) ◽  
pp. 48-51 ◽  
Author(s):  
P. S. Belton ◽  
H. J. V. Tyrrell
Keyword(s):  
Temperature Gradient ◽  
Thermal Diffusion ◽  
Aromatic Hydrocarbons ◽  
Thermal Gradient ◽  
Average Degree ◽  
Quantitative Interpretation ◽  
Mean Temperature ◽  
The Mean ◽  
Degree Of Association

Abstract The thermal diffusion factors observed for these systems vary considerably with concentration, and frequently show a change in sign at some concentration. New data on ethanol-toluene mixtures show that the sign and magnitude of the separation of the components in a thermal gradient are also strongly dependent on the mean temperature of the system. These observations, together with earlier ones on similar systems, can be given a semi-quantitative interpretation in terms of a shift in the average degree of association of the alcohol along the temperature gradient.

Near-surface particle image velocimetry measurements in a transitionally rough-wall atmospheric boundary layer

2007 ◽  
Vol 580 ◽  
pp. 319-338 ◽  
Author(s):  
SCOTT C. MORRIS ◽  
SCOTT R. STOLPA ◽  
PAUL E. SLABOCH ◽  
JOSEPH C. KLEWICKI
Keyword(s):  
Reynolds Number ◽  
Particle Image Velocimetry ◽  
Environmental Science ◽  
Particle Image ◽  
Shear Velocity ◽  
Mean Flow ◽  
Mean Velocity ◽  
Near Surface ◽  
Image Velocimetry ◽  
The Mean

The Reynolds number dependence of the structure and statistics of wall-layer turbulence remains an open topic of research. This issue is considered in the present work using two-component planar particle image velocimetry (PIV) measurements acquired at the Surface Layer Turbulence and Environmental Science Test (SLTEST) facility in western Utah. The Reynolds number (δuτ/ν) was of the order 106. The surface was flat with an equivalent sand grain roughness k+ = 18. The domain of the measurements was 500 < yuτ/ν < 3000 in viscous units, 0.00081 < y/δ < 0.005 in outer units, with a streamwise extent of 6000ν/uτ. The mean velocity was fitted by a logarithmic equation with a von Kármán constant of 0.41. The profile of u′v′ indicated that the entire measurement domain was within a region of essentially constant stress, from which the wall shear velocity was estimated. The stochastic measurements discussed include mean and RMS profiles as well as two-point velocity correlations. Examination of the instantaneous vector maps indicated that approximately 60% of the realizations could be characterized as having a nearly uniform velocity. The remaining 40% of the images indicated two regions of nearly uniform momentum separated by a thin region of high shear. This shear layer was typically found to be inclined to the mean flow, with an average positive angle of 14.9°.

Particle Image Velocimetry Measurements in the Wake of a Cactus-Shaped Cylinder

2011 ◽  
Vol 133 (9) ◽  
Author(s):  
Jack E. Abboud ◽  
Wafaa S. Karaki ◽  
Ghanem F. Oweis
Keyword(s):  
Particle Image Velocimetry ◽  
Particle Image ◽  
Static Pressure ◽  
Pressure Measurements ◽  
Biologically Inspired ◽  
Biologically Relevant ◽  
Image Velocimetry ◽  
Cylinder Model ◽  
The Mean ◽  
Velocity Level

The flow field past a biologically inspired cylindrical model with a cactus-shaped cross section is investigated in a wind tunnel using particle image velocimetry and surface pressure measurements at a biologically relevant Reynolds number of ∼ 2 × 105. For the cactus model, the mean streamwise flow heals faster in its immediate wake, the wake turbulent velocity level is lower, and the surface static pressure has better recovery compared to the circular cylinder model.

Particle Image Velocimetry Measurements of Wake Flows of Various Bridge Sections

2006 ◽  
Author(s):  
Emanuela Palombi ◽  
Gregory A. Kopp ◽  
Roi Gurka
Keyword(s):  
Particle Image Velocimetry ◽  
Vortex Shedding ◽  
Particle Image ◽  
Uniform Flow ◽  
Pressure Measurements ◽  
Trailing Edge ◽  
Wake Flows ◽  
Edge Geometry ◽  
Image Velocimetry ◽  
The Mean

Using Particle Image Velocimetry (PIV) we investigate the influence of leading and trailing edge geometry on the wake flows of various elongated cylinders in smooth uniform flow. The results present a comparison between the mean wake flows, as well as the vortex shedding activity found to occur in each case. Pressure measurements were recorded on the surface of the cylinders to examine the corresponding fluctuating and mean forces exhibited by each model tested. Significant variations in the wake topology and aerodynamic behaviour of the four cylinder geometries tested were observed.

Sign in / Sign up

Export Citation Format

Share Document