Self-Assembly and Manipulation of Particles on Drop Surfaces

2014 ◽  
Author(s):  
Edison C. Amah ◽  
Kinnari Shah ◽  
Ian S. Fischer ◽  
Pushpendra Singh
Keyword(s):  
Dielectric Properties ◽  
Electric Field ◽  
Self Assembly ◽  
Hydrodynamic Force ◽  
Hydrodynamic Forces ◽  
Ac Electric Field ◽  
Induced Motion

It was recently shown by us that particles distributed on the surface of a drop can be concentrated at the poles or equator of the drop by subjecting it to a uniform ac electric field. The dielectrophoretic and hydrodynamic forces which cause the motion of particles depend on the parameters such as the particles’ and drop’s radii, the dielectric properties of the fluids and particles, and the frequency of the electric field. The hydrodynamic force, which arises because of the induced motion in the liquids, is the main focus of this paper. We show that it can be used to control the distribution of particle monolayers on the surface of a drop.

scholarly journals The effect of an AC electric field on the dielectric properties of Pb(Mg1/3Nb2/3)O3 ceramic

2021 ◽  
Vol 5 (2) ◽  
Author(s):  
E.C. Lima ◽  
J.D.S. Guerra ◽  
E.B. Araujo
Keyword(s):  
Dielectric Properties ◽  
Dielectric Permittivity ◽  
Electric Field ◽  
Statistical Model ◽  
Dielectric Response ◽  
Freezing Temperature ◽  
Dielectric Dispersion ◽  
Electrical Field ◽  
Ac Electric Field ◽  
Applied Electrical Field

The dynamic dielectric response of Pb(Mg1/3Nb2/3 )O3 ceramic was experimentally studied as a function of the EAC amplitude field. An increase in real dielectric permittivity was obtained by increasing the applied electrical field within the investigated temperature range for frequencies below 10 kHz. The temperature of maximum dielectric permittivity and freezing temperature decreased with an increase in E AC. Nonlinear permittivity was studied and found to behave similarly to freezing temperature. A statistical model was used to fit the dielectric dispersion of real dielectric permittivity with temperature and frequency. The results are discussed in terms of different factors’ contributions to dielectric permittivity under different EAC field conditions.

scholarly journals An In-Situ Reaction Route to Molecular Level Dispersed Bisimide and ZnO Nanorod Hybrids with Efficient Photo-Induced Charge Transfer

2021 ◽  
Vol 16 (1) ◽  
Author(s):  
Chunzheng Lv ◽  
Lirong He ◽  
Jiahong Tang ◽  
Feng Yang ◽  
Chuhong Zhang
Keyword(s):  
Charge Transfer ◽  
Electric Field ◽  
Self Assembly ◽  
Molecular Level ◽  
Surface Photovoltage ◽  
Zno Nanorod ◽  
In Situ Reaction ◽  
Perylene Bisimide ◽  
Induced Charge

AbstractAs an important photoconductive hybrid material, perylene/ZnO has attracted tremendous attention for photovoltaic-related applications, but generally faces a great challenge to design molecular level dispersed perylenes/ZnO nanohybrids due to easy phase separation between perylenes and ZnO nanocrystals. In this work, we reported an in-situ reaction method to prepare molecular level dispersed H-aggregates of perylene bisimide/ZnO nanorod hybrids. Surface photovoltage and electric field-induced surface photovoltage spectrum show that the photovoltage intensities of nanorod hybrids increased dramatically for 100 times compared with that of pristine perylene bisimide. The enhancement of photovoltage intensities resulting from two aspects: (1) the photo-generated electrons transfer from perylene bisimide to ZnO nanorod due to the electric field formed on the interface of perylene bisimide/ZnO; (2) the H-aggregates of perylene bisimide in ZnO nanorod composites, which is beneficial for photo-generated charge separation and transportation. The introduction of ordered self-assembly thiol-functionalized perylene-3,4,9,10-tetracarboxylic diimide (T-PTCDI)/ ZnO nanorod composites induces a significant improvement in incident photo-to-electron conversion efficiency. This work provides a novel mentality to boost photo-induced charge transfer efficiency, which brings new inspiration for the preparation of the highly efficient solar cell.

Simulation of TiO 2 particle trajectory in AC electric field

2015 ◽  
Vol 108 ◽  
pp. 183-191 ◽  
Author(s):  
Reza Riahifar ◽  
Babak Raissi ◽  
Cyrus Zamani ◽  
Ehsan Marzbanrad
Keyword(s):  
Electric Field ◽  
Particle Trajectory ◽  
Ac Electric Field

Electrically induced reversible viscosity change in hectorite aqueous dispersion under an AC electric field

2014 ◽  
Vol 99 ◽  
pp. 160-163 ◽  
Author(s):  
Hiroshi Kimura ◽  
Mao Ueno ◽  
Shinya Takahashi ◽  
Akira Tsuchida ◽  
Keiichi Kurosaka
Keyword(s):  
Electric Field ◽  
Aqueous Dispersion ◽  
Viscosity Change ◽  
Ac Electric Field

Self-Assembly of Monolayers of Submicron Sized Particles on Thin Liquid Films

2013 ◽  
Author(s):  
Shriram Pillapakkam ◽  
N. A. Musunuri ◽  
P. Singh
Keyword(s):  
Electric Field ◽  
Self Assembly ◽  
Uv Light ◽  
Capillary Forces ◽  
Liquid Films ◽  
Thin Liquid Films ◽  
Liquid Interfaces ◽  
Uv Curable ◽  
Particle Monolayer ◽  
Uv Curable Resin

In this paper, we present a technique for freezing monolayers of micron and sub-micron sized particles onto the surface of a flexible thin film after the self-assembly of a particle monolayer on fluid-liquid interfaces has been improved by the process we have developed where an electric field is applied in the direction normal to the interface. Particles smaller than about 10 microns do not self-assemble under the action of lateral capillary forces alone since capillary forces amongst them are small compared to Brownian forces. We have overcome this problem by applying an electric field in the direction normal to the interface which gives rise to dipoledipole and capillary forces which cause the particles to arrange in a triangular pattern. The technique involves assembling the monolayer on the interface between a UV-curable resin and another liquid by applying an electric field, and then curing the resin by applying UV light. The monolayer becomes embedded on the surface of the solidified resin film.

Mechanism of Cell Lysis in Microfluidic Channel With Integrated Nanocomposite Electrodes

2013 ◽  
Author(s):  
Madhusmita Mishra ◽  
Anil Krishna Koduri ◽  
Aman Chandra ◽  
D. Roy Mahapatra ◽  
G. M. Hegde
Keyword(s):  
Electric Field ◽  
Microfluidic Channel ◽  
Cell Lysis ◽  
Bacterial Cells ◽  
Nano Composite ◽  
Time Resolved ◽  
Ac Electric Field ◽  
Cell Dispersion ◽  
Electrical Lysis ◽  
Nanocomposite Electrodes

This paper reports on the characterization of an integrated micro-fluidic platform for controlled electrical lysis of biological cells and subsequent extraction of intracellular biomolecules. The proposed methodology is capable of high throughput electrical cell lysis facilitated by nano-composite coated electrodes. The nano-composites are synthesized using Carbon Nanotube and ZnO nanorod dispersion in polymer. Bacterial cells are used to demonstrate the lysis performance of these nanocomposite electrodes. Investigation of electrical lysis in the microchannel is carried out under different parameters, one with continuous DC application and the other under DC biased AC electric field. Lysis in DC field is dependent on optimal field strength and governed by the cell type. By introducing the AC electrical field, the electrokinetics is controlled to prevent cell clogging in the micro-channel and ensure uniform cell dispersion and lysis. Lysis mechanism is analyzed with time-resolved fluorescence imaging which reveal the time scale of electrical lysis and explain the dynamic behavior of GFP-expressing E. coli cells under the electric field induced by nanocomposite electrodes. The DNA and protein samples extracted after lysis are compared with those obtained from a conventional chemical lysis method by using a UV–Visible spectroscopy and fluorimetry. The paper also focuses on the mechanistic understanding of the nano-composite coating material and the film thickness on the leakage charge densities which lead to differential lysis efficiency.

Sign in / Sign up

Export Citation Format

Share Document