Design Optimization of Batteryless Photovoltaic-Powered Reverse Osmosis Water Desalination in Remote Areas

2014 ◽  
Author(s):  
Jihun Kim ◽  
Karim Hamza ◽  
Mohamed El-Morsi ◽  
Ashraf O. Nassef ◽  
Sayed Metwalli ◽  
...  
Keyword(s):  
Reverse Osmosis ◽  
Fresh Water ◽  
Water Desalination ◽  
Operating Pressure ◽  
Battery Storage ◽  
Outer Loop ◽  
Loop Optimization ◽  
Remote Areas ◽  
Desalination Plant ◽  
Real Coded Genetic Algorithm

Reverse osmosis (RO) is one of the main technologies for water desalination, which can be used in locations with water resources that have high salinity content (such as saline ground water or seawater) to produce fresh water. Energy requirement for RO is less than other desalination processes, but is in the form of electric power, which can be scarce as fresh water in in remote areas not connected to the grid. Fortunately, many areas with fresh water shortage due to lack of rainfall have abundant sunshine. The combination of solar power and RO desalination is attractive, but remote areas usually requires small modular units, which favors photovoltaic (PV) solar energy harvesting. It is important to consider the net cost-effectiveness of the system when designing the PV-RO desalination plant. Adding battery storage to a PV-RO system has the advantage of steadier operation, but is an additional cost whose real benefit is only realized with a larger PV array that can harvest more energy during daytime. This paper compares the net unit cost of fresh water for realistic scenarios of PV-RO systems with and without battery storage. A multi-level optimization approach previously developed by the authors for time-variant power PV-RO systems is adopted; a “sub-loop” optimization determines the operating pressure and flow rate given a fixed system configuration and instantaneous power input, while an “outer loop” optimizes the configuration of the desalination plant. The sub-loop optimization is done via an enumeration approach, while the outer loop is optimized via a mixed real-coded genetic algorithm (GA). A demonstration study shows a batteryless system being approx. 30% more expensive per unit fresh water production than a fully optimized battery-backed system. However, most of the cost of a batteryless system is in initial investment, which with 7% less annual operating cost, can present a plausible design choice for remote areas.

Multi-Level Design Optimization of Reverse Osmosis Water Desalination Powered via Photovoltaic Panels With Battery Storage

2014 ◽  
Author(s):  
Jihun Kim ◽  
Karim Hamza ◽  
Mohamed El-Morsi ◽  
Ashraf O. Nassef ◽  
Sayed Metwalli ◽  
...  
Keyword(s):  
Reverse Osmosis ◽  
Fresh Water ◽  
Operating Conditions ◽  
Human Consumption ◽  
System Configuration ◽  
Battery Storage ◽  
Loop Optimization ◽  
Desalination Plant ◽  
Power Dispatch ◽  
Multi Level

Reverse osmosis (RO) is one of the main commercial technologies for desalination of water with salinity content too high for human consumption in order to produce fresh water. RO may hold promise for remote areas with scarce fresh water resources, however, RO energy requirements being in the form of electric power have few options in such areas. Fortunately, scarce rainfall is often associated with abundant sunshine, which makes solar photovoltaic (PV) power an attractive option. Equipping a photovoltaic powered reverse osmosis (PV-RO) desalination plant with battery storage has an advantage of steadier and longer hours of operation, thereby making better use of the investments in RO system components, but the additional cost from including batteries may end up increasing the overall cost of fresh water. It is therefore of paramount importance to consider the overall cost-effectiveness of the PV-RO system when designing the desalination plant. Recent work by the authors has generalized the steady operation model of RO systems to hourly adjusted power-dispatch via a proportional-derivative (PD) controller that depends on the state of charge (SOC) of the battery, yet the operating conditions; namely pressure and flow for a given power dispatch were only empirically selected. This paper considers a multi-level optimization model for PV-RO systems with battery storage by considering a “sub-loop” optimization of the feed pressure and flow given power dispatch for a fixed RO system configuration, as well as a “top-level” optimization where the system configuration itself is adjusted by the design variables. Effect of the sub-loop optimization is assessed by comparing the obtained cost of fresh water with the previous empirically adjusted system for locations and weather conditions near the city of Hurgada on the Red Sea.

Design Optimization of a Solar-Powered Reverse Osmosis Desalination System for Small Communities

2013 ◽  
Author(s):  
Jihun Kim ◽  
Karim Hamza ◽  
Mohamed El Morsi ◽  
Ashraf O. Nassef ◽  
Sayed Metwalli ◽  
...  
Keyword(s):  
Reverse Osmosis ◽  
Fresh Water ◽  
Energy Resource ◽  
Production Capacity ◽  
Water Desalination ◽  
Battery Storage ◽  
Water Stream ◽  
Permeable Membrane ◽  
Small Communities ◽  
Solar Powered

Fresh water availability is essential for the economic development in small communities in remote areas. In desert climate, where naturally occurring fresh water is scarce, seawater or brackish water from wells is often more abundant. Since water desalination approaches are energy intensive, a strong motivation exists for the design of cost-effective desalination systems that utilize the abundant renewable energy resource; solar energy. This paper presents an optimization model of a solar-powered reverse osmosis (RO) desalination system. RO systems rely on pumping salty water at high pressure through semi-permeable membrane modules. Under sufficient pressure, water molecules will flow through the membranes, leaving salt ions behind, and are collected in a fresh water stream. Since RO system are primarily powered via electricity, the system model incorporates photovoltaic (PV) panels, and battery storage for smoothing out fluctuations in the PV power output, as well as allowing system operation for a number of hours after sunset. Design variables include sizing of the PV solar collectors, battery storage capacity, as well as the sizing of the RO system membrane module and power elements. The objective is to minimize the cost of unit volume produced fresh water, subject to constraints on production capacity. A genetic algorithm is used to generate and compare optimal designs for two different locations near the Red Sea and Sinai.

scholarly journals Study of the Ecological Footprint and Carbon Footprint in a Reverse Osmosis Sea Water Desalination Plant

Membranes ◽  
2021 ◽  
Vol 11 (6) ◽  
pp. 377
Author(s):  
Federico Leon ◽  
Alejandro Ramos-Martin ◽  
Sebastian Ovidio Perez-Baez
Keyword(s):  
Reverse Osmosis ◽  
Canary Islands ◽  
Ecological Footprint ◽  
Sea Water ◽  
Water Desalination ◽  
Energy Costs ◽  
Generation System ◽  
Negative Part ◽  
Desalination Plant ◽  
Materials Used

The water situation in the Canary Islands has been a historical problem that has been sought to be solved in various ways. After years of work, efforts have focused on desalination of seawater to provide safe water mainly to citizens, agriculture, and tourism. Due to the high demand in the Islands, the Canary Islands was a pioneering place in the world in desalination issues, allowing the improvement of the techniques and materials used. There are a wide variety of technologies for desalination water, but nowadays the most used is reverse osmosis. Desalination has a negative part, the energy costs of producing desalinated water are high. To this we add the peculiarities of the electricity generation system in the Canary Islands, which generates more emissions per unit of energy produced compared to the peninsular generation system. In this study we have selected a desalination plant located on the island of Tenerife, specifically in the municipality of Granadilla de Abona, and once its technical characteristics have been known, the ecological footprint has been calculated. To do this we have had to perform some calculations such as the capacity to fix carbon dioxide per hectare in the Canary Islands, as well as the total calculation of the emissions produced in the generation of energy to feed the desalination plant.

Performance evaluation of reverse osmosis brackish water desalination plant with different recycled ratios of retentate

2020 ◽  
Vol 135 ◽  
pp. 106729 ◽  
Author(s):  
Alanood A. Alsarayreh ◽  
M.A. Al-Obaidi ◽  
A.M. Al-Hroub ◽  
R. Patel ◽  
I.M. Mujtaba
Keyword(s):  
Performance Evaluation ◽  
Reverse Osmosis ◽  
Brackish Water ◽  
Water Desalination ◽  
Desalination Plant

scholarly journals Full-Scale Seawater Reverse Osmosis Desalination Plant Simulator

2020 ◽  
Author(s):  
Hammad Siddiqui ◽  
Mariam Elnour ◽  
Nader Meskin ◽  
Syed Zaidi
Keyword(s):  
Reverse Osmosis ◽  
Full Scale ◽  
Operating Conditions ◽  
Water Desalination ◽  
System Behavior ◽  
Desalination Plant ◽  
Local Plant ◽  
Seawater Reverse Osmosis ◽  
High Flexibility ◽  
Operational Data

Reverse Osmosis (RO) is an efficient and clean membrane-based technology for water desalination. This work presents a full-scale seawater reverse osmosis (SWRO) desalination plant simulator using MATLAB/Simulink that has been validated using the operational data from a local plant. It allows simulating the system behavior under different operating conditions with high flexibility and minimal cost.

scholarly journals Construction and operation of the MIDES plant

2021 ◽  
pp. 105-136
Author(s):  
Naiara Hernández-Ibáñez ◽  
Juan Arévalo ◽  
Vicente F. Mena ◽  
Victor Monsalvo-Garcia ◽  
Frank Rogalla
Keyword(s):  
Reverse Osmosis ◽  
Brackish Water ◽  
Water Sources ◽  
Water Desalination ◽  
Seawater Desalination ◽  
Desalination Plant ◽  
Microbial Desalination Cell ◽  
Pre Treatment ◽  
Construction Operation ◽  
Different Water Sources

Abstract This chapter presents the construction, operation, and validation of all the MIDES systems, including water pre-treatment, wastewater pre-treatment, the microbial desalination cell (MDC), low-pressure reverse osmosis (RO), and post-treatment (remineralization and disinfection). MIDES technology has been validated with different water sources: brackish water from Demo Site 1, (Racons Brackish Water Desalination Plant (BWDP), located in Denia, Spain) and seawater from Demo Site 2 (Fonsalía Seawater Desalination Plant (SWDP), located in Guía de Isora, Spain). In this chapter, the preparation of both demo sites for the reception and installation of the pilot plants is also presented.

Evaluation and minimisation of energy consumption in a medium-scale reverse osmosis brackish water desalination plant

2020 ◽  
Vol 248 ◽  
pp. 119220 ◽  
Author(s):  
Alanood A. Alsarayreh ◽  
M.A. Al-Obaidi ◽  
A.M. Al-Hroub ◽  
R. Patel ◽  
I.M. Mujtaba
Keyword(s):  
Energy Consumption ◽  
Reverse Osmosis ◽  
Brackish Water ◽  
Water Desalination ◽  
Medium Scale ◽  
Desalination Plant
Sign in / Sign up

Export Citation Format

Share Document